Modeling of Evaporation Reduction in Drip Irrigation System
Publication: Journal of Irrigation and Drainage Engineering
Volume 125, Issue 6
Abstract
Surface drip irrigation is an efficient system for delivering water to crops; however, conditions at the soil surface affect evaporation rate and efficiency. A method is proposed, sand tube irrigation (STI), to increase the efficiency of drip irrigation systems. This method is specific to permanent tree crops where soil is not tilled or turned. The STI method consists of removing a soil core beneath the emitter and filling the void with coarse sand. The SWMS _2D model, implemented in a 3D axisymmetric form, was used to simulate infiltration, water redistribution, evaporation from the soil surface, and rise of water inside the sand tube. Model simulations were compared with laboratory measurements determined from a weighing lysimeter. The simulated values of water height inside the sand tube and temporal position of the wetting front in both lateral and upward directions closely matched the experimental measurements. The advancement of the wetting front in the downward direction and evaporation estimates was predicted with less accuracy. Experiments showed that relative to surface drip irrigation, the STI method reduced evaporation by approximately 26% over a 4-day period.
Get full access to this article
View all available purchase options and get full access to this article.
References
1.
Angelakis, A. N., Rolston, D. E., Kadir, T. N., and Scott, V. H. (1993). “Soil-water distribution under trickle source.”J. Irrig. and Drain. Engrg., ASCE, 119(3), 484–500.
2.
Ben-Asher, J., and Phene, C. J. (1996). “Surface and subsurface drip irrigation: An analysis by a numerical model.” Rep., Jacob Blaustein Institute for Desert Research, Ben Gurion University of Negev, Sde Boker Campus, Negev, Israel.
3.
Brandt, A., Bresler, E., Diner, N., Ben-Asher, J. Heller, J., and Goldberg, D. (1971). “Infiltration from a trickle source: I. Mathematical models.” Soil Sci. Soc. Am. Proc., 35(5), 675–682.
4.
Bresler, E. ( 1975). “Trickle-drip irrigation: Principles and application to soil-water management.” Dept. of Agronomy, Cornell University, Ithaca, New York.
5.
Bresler, E. (1978). “Analysis of trickle irrigation with application to design problems.” Irrig. Sci., Berlin, 1, 3–17.
6.
Bresler, E., Heller, J., Diner, N., Ben-Asher, J., Brandt, A., and Goldberg, D. (1971). “Infiltration from a trickle source: I: Experimental data and theoretical predictions.” Soil Sci. Soc. Am. Proc., 35(5), 683–689.
7.
Clothier, B., Scotter, D., and Harper, E. (1985). “Three-dimensional infiltration and trickle irrigation.” Trans. ASAE, 28(2), 497–501.
8.
Hillel, D. ( 1980). Application of soil physics. Academic, New York, 120–134.
9.
Jackson, R. D., Reginato, B., Kimball, A., and Nakayama, F. S. (1974). “Diurnal soil-water evaporation: Comparison of measured and calculated soil-water fluxes.” Soil Sci. Soc. Am. Proc., 38(6), 861–866.
10.
Jeppson, R. W. (1974). “Axisymetric infiltration in soil: I. Numerical techniques for solution.” J Hydrol., Amsterdam, 23, 111–130.
11.
Matthias, A. D., Salehi, R., and Warrick, A. W. (1986). “Bare soil evaporation near a surface point-source emitter.” Agric. Water Mgmt., Amsterdam, 11, 257–277.
12.
Meshkat, M. ( 1997). “Modeling and laboratory evaluation of evaporation and moisture redistribution for drip/trickle and `sand tube irrigation' using undisturbed and reconstructed soils,” PhD dissertation, University of Kentucky, Lexington, Ky.
13.
Meshkat, M., Warner, R. C., and Walton, L. R. (1999). “Lysimeter design, construction and instrumentation for assessing evaporation from a large undisturbed soil monolith.” J. Appl. Engrg. in Agr., 15(4), 303–308.
14.
Meshkat, M., Warner, R. C., and Workman, S. R. (1998). “Comparison of water and temperature distribution profiles under sand tube irrigation.” Trans. ASAE, 41(6), 1657–1663.
15.
Milly, P. C. D. (1984). “A simulation analysis of thermal effects on evaporation from soil.” Water Resour. Res., 20(8), 1087–1098.
16.
Omary, M., and Ligon, J. T. (1992). “Three-dimensional movement of water and pesticide from trickle irrigation: Finite element model.” Trans. ASAE, 35(3), 811–821.
17.
Simunek, J., Vogel, T., and van Genuchten, M. Th. (1994). “The SWMS _2D code for simulating water flow and solute transport in two-dimensional variably saturated media, version 1.2.” Res. Rep. No. 132. U.S. Salinity Lab., USDA-Agricultural Research Service, Riverside, Calif.
18.
Taghavi, S. A., Marino, M. A., and Rolston, D. E. (1984). “Infiltration from trickle irrigation source.”J. Irrig. and Drain. Engrg., ASCE, 110(4), 331–341.
19.
van Genuchten, M. T. (1980). “A closed form equation for predicting the hydraulic conductivity of unsaturated soils.” Soil Sci. Soc. Am. Proc., 44, 892–898.
Information & Authors
Information
Published In
Journal of Irrigation and Drainage Engineering
Volume 125 • Issue 6 • December 1999
Pages: 315 - 323
History
Received: Oct 8, 1998
Published online: Dec 1, 1999
Published in print: Dec 1999
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.