Side-Weir Flow in Curved Channels
Publication: Journal of Irrigation and Drainage Engineering
Volume 124, Issue 3
Abstract
Side-weirs located on straight channels have attracted considerable interest and research effort. The same, however, is not true for side-weirs on curved channels. The existing studies deal mainly with sediment transport problems and lateral intake structures. The present study focuses on the investigation of the hydraulic behavior of a rectangular sharp crested weir at various locations along a 180° bend. The flow resulting from the effects of the bend and the side-weir was investigated experimentally. Velocity measurements were carried out both for the bend with and without active overflow conditions while surface profiles were determined only for the former case. Velocity measurements were made over the depth at several cross sections along the bend. Observations indicated that a stagnation zone existed at the side-weir section along the inner side of the bend, and that standing waves were present downstream of the side-weir even under subcritical flow conditions. Both phenomena were found to be highly dependent on the upstream Froude number. The side-weir discharge coefficient was determined at one section along the approach to the bend and at five stations along the bend for a number of different side-weir dimensions. The side-weir discharge coefficient along the bend was found to depend on the upstream Froude number, the dimensionless weir height, p/h1, and the dimensionless weir length, L/b. The variation of the discharge coefficient along the bend as a function of the Froude number and the dimensionless weir length was found to exhibit a parabolic relationship.
Get full access to this article
View all available purchase options and get full access to this article.
References
1.
Chang, H. H.(1983). “Variation of flow resistance through curved channels.”J. Hydr. Engrg., ASCE, 110(12), 1772–1782.
2.
Chang, H. H. (1983). “Energy expenditure in curved open channels.”J. Hydr. Engrg., ASCE, 109(7).
3.
Cheong, H. F.(1991). “Discharge coefficient of lateral diversion from trapezoidal channel.”J. Irrig. and Drain. Engrg., ASCE, 117(4), 461–475.
4.
Choudrary, U.K., and Narasimhan, S.(1977). “Flow in 180° open channel rigid boundary bends.”J. Hydr. Engrg., ASCE, 103(6), 651–657.
5.
Chow, V. T. (1959). Open channel hydraulics. McGraw-Hill Inc., New York, N.Y., 439–460.
6.
De Marchi, G.(1934). “Saggio di teoria de funzionamente degli stramazzi laterali.”L'Energia Elettrica, Milano, 11, 849–860.
7.
El-Khashab, A. M. M. (1975). “Hydraulics of flow over side-weirs,” PhD thesis, Univ. of Southampton, England.
8.
Fares, Y. R., and Herbertson, J. G.(1993). “Compertement de I'ecoulement dans un canal courbe avec un deversior lateral alimentant un canal evacuateurde crue.”J. Hydr. Res., 31(3), 383–401.
9.
Georgiadou, A. D., and Smith, A. K.(1986). “Flow in curved converging channel.”J. Hydr. Engrg., ASCE, 112(6), 476–496.
10.
Muramoto, Y.(1967). “Secondary flows in curved open channels.”Proc. IAHR, 3, 315.
11.
Nandesamoorthy, T., and Thomson, A.(1972). “Discussion of spatially varied flow over side-weirs.”J. Hydr. Engrg., ASCE, 98(12), 2234–2235.
12.
Ramamurthy, A. S., and Satish, M. G.(1986). “Discharge characteristic of flow past a floor slot.”J. Irrig. and Drain. Engrg., ASCE, 112(1), 20–17.
13.
Ranga Raju, K. G., Prasad, B., and Grupta, S. K.(1979). “Side-weir in rectangular channel.”J. Hydr. Engrg., ASCE, 105(5), 547–554.
14.
Rozovskii, I. L. (1957). “Flow of water in bends of open channels.” Academy of Sciences of Ukranian S. S. R., Kiev, Russia.
15.
Shukry, A.(1950). “Flow around bends in open flume.”J. Hydr. Engrg., ASCE, 115, 751–759.
16.
Sing, R., Manivannan, D., and Satyanarayana, T.(1994). “Discharge coefficient of rectangular side weirs.”J. Irrig. and Drain. Engrg., ASCE, 120(4), 814–819.
17.
Soliman, M. M., and Týnney, E. R.(1968). “Flow around 180° bends in open rectangular channels.”J. Hydr. Engrg., ASCE, 94(4), 893–908.
18.
Spiegel, M. R. (1972). Theory and problems of statistics. McGraw-Hill Inc., New York, N.Y.
19.
Subramanya, K., and Awasthy, S. C.(1972). “Spatially varied flow over side-weirs.”J. Hydr. Engrg., ASCE, 98(1), 1–10.
20.
Suga, K.(1967). “The stable profiles of the curved open channel beds.”J. Hydr. Res., 1, 487–495.
21.
Yen, K. C., and Kennedy, J. F.(1993). “Moment model of nonuniform channel bend flow.”J. Hydr. Engrg., ASCE, 119(7), 776–795.
22.
Yu-Tech, L.(1972). “Discussion of spatially varied flow over side-weirs.”J. Hydr. Engrg., ASCE, 98(11), 2046–2048.
Information & Authors
Information
Published In
Copyright
Copyright © 1998 American Society of Civil Engineers.
History
Published online: May 1, 1998
Published in print: May 1998
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.