Bridge Rail Rating Curves and Submergence Characteristics
Publication: Journal of Hydraulic Engineering
Volume 135, Issue 2
Abstract
This paper describes a three-parameter model used for determining the hydraulic performance of bridge rails during extreme flood events as well as two submergence models. Typically the geometry of the bridge rails is not considered when conducting floodplain analysis. The use of certain bridge rails with large height or minimal open space may adversely impact the surrounding floodplain. Therefore, a mathematical model used to characterize the hydraulic performance of bridge rails has been developed in order to understand how different bridge rail systems may impact a floodplain. Physical modeling experiments are conducted in order to determine rating curves for various rail geometries that describe the upstream specific energy as a function of the flow rate passing over the rail. In addition, the effects of the submergence of bridge rails by an increase in downstream water surface elevation are also evaluated, as well as the submergence effects of two bridge rails in series. Two different mathematical models are used to approximate and characterize the effects of rail submergence.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
Research support from the Texas Department of Transportation is greatly appreciated. Additional data collection was conducted by Mike Konieczki and Tyler McEwen at the UT Center for Research in Water Resources.
References
Benson, K. S. (2004). “Hydraulic effects of safety end treatments on culvert performance.” MS thesis, The Univ. of Texas at Austin, Austin, Tex.
Bos, M. G. (1989). Discharge measurement structures, Publication 20, 3rd revised Ed., International Institute for Land Reclamation and Improvement, Wageningen, The Netherlands.
Charbeneau, R. J., Henderson, A. D., and Sherman, L. C. (2006). “Hydraulic performance curves for highway culverts.” J. Hydraul. Eng., 132(5), 474–481.
Federal Highway Administration (FHwA). (2007). FHWA Caltrans bridge rail guide 2005, U.S. Department of Transportation, Bridge Technology, ⟨http://www.fhwa.dot.gov/bridge/bridgerail/index.cfm⟩ (March 15, 2007).
Henderson, F. M. (1966). Open channel flow, Macmillan, New York.
King, H. W., and Brater, E. F. (1963). Handbook of hydraulics, 5th Ed., McGraw-Hill, New York.
Klenzendorf, J. B. (2007). “Hydraulic performance of bridge rails based on rating curves and submergence effects.” MS thesis, The Univ. of Texas at Austin, Austin, Tex.
Ross, H. E., Sicking, D. L., Zimmer, R. A., and Michie, J. D. (1993). “National Cooperative Highway Research Program Report 350: Recommended procedures for the safety performance evaluation of highway features.” Rep. to Transportation Research Board, National Research Council, National Academy Press, Washington, D.C.
Rouse, H. (1950). “Engineering hydraulics.” Proc., 4th Hydraulics Conf., Iowa Institute of Hydraulic Research, Wiley, New York.
Texas Department of Transportation (TxDOT). (2004). Hydraulic design manual, Austin, Tex.
Texas Department of Transportation (TxDOT). (2005). Bridge railing manual, Austin, Tex.
Texas Department of Transportation (TxDOT). (2007). Bridge standards, Bridge Division, ⟨http://www.dot.state.tx.us/insdtdot/orgchart/cmd/cserve/standard/bridge-e.htm⟩ (March 15, 2007).
Tullis, B. P., Young, J. C., and Chandler, M. A. (2007). “Head-discharge relationships for submerged labyrinth weirs.” J. Hydraul. Eng., 133(3), 248–254.
Villemonte, J. R. (1947). “Submerged-weir discharge studies.” Eng. News-Rec., 866–869.
Information & Authors
Information
Published In
Copyright
© 2009 ASCE.
History
Received: Jul 23, 2007
Accepted: Jul 22, 2008
Published online: Feb 1, 2009
Published in print: Feb 2009
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.