Modeling the Evolution of Incised Streams. II: Streambank Erosion
This article has a reply.
VIEW THE REPLYThis article has a reply.
VIEW THE REPLYPublication: Journal of Hydraulic Engineering
Volume 134, Issue 7
Abstract
Incision and ensuing widening of alluvial stream channels is widespread in the midsouth and midwestern United States and represents an important form of channel adjustment. Streambanks have been found to contribute as much as 80% of the total suspended load. The location, timing, and magnitude of streambank erosion are difficult to predict. Results from field studies to characterize the resistance of fine-grained materials to hydraulic and geotechnical erosion, the impact of pore-water pressures on failure dimensions and shearing resistance, and the role of riparian vegetation on matric suction, streambank permeability, and shearing resistance are used to enhance the channel evolution model CONCEPTS (conservational channel evolution and pollutant transport system). This paper discusses the conceptualization of the above-mentioned physical processes, and demonstrates the ability of the derived model to simulate streambank-failure processes. The model is tested against observed streambank erosion of a bendway on Goodwin Creek, Miss. between March 1996 and March 2001, where it accurately predicts the rate of retreat of the outside bank of the bendway. The observed change in average channel width within the central section of the bendway is over the simulation period, whereas a retreat of (7.4% larger) is simulated. The observed top-bank retreat within the central section of the bendway is over the simulation period, whereas a retreat of (15% smaller) is simulated.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
The writers want to thank Rob Thomas for his work in collecting, compiling, and analyzing the data used in the computer simulations. They further acknowledge Brian Bell, Andy Collison, Steve Darby, Mark Griffith, Joe Murphey, Keith Parker, and Anna Wood for assistance in collecting the data.
References
Alonso, C. V., and Combs, S. T. (1986). “Channel width adjustment in straight alluvial streams.” Proc., 4th Federal Interagency Sedimentation Conf., 5-31–5-40.
Amiri-Tokaldany, E., Darby, S. E., and Tosswell, P. (2003). “Bank stability analysis for predicting reach scale land loss and sediment yield.” J. Am. Water Resour. Assoc., 39(4), 897–909.
ASCE Task Committee on Hydraulics, Bank Mechanics, and Modeling of River Width Adjustment (ASCE). (1998). “River width adjustment. I: Processes and mechanisms.” J. Hydraul. Eng., 124(9), 881–902.
Bishop, A. W. (1955). “The use of the slip circle in the stability analysis of slopes.” Geotechnique, 5(1), 7–17.
Blackmarr, W. A. (1995). “Documentation of hydrologic, geomorphic, and sediment transport measurements on the Goodwin Creek Experimental Watershed, northern Mississippi, for the period 1982–1993.” Research Rep. No. 3, USDA, Agricultural Research Service, National Sedimentation Laboratory, Oxford, Miss.
Casagli, N., Rinaldi, M., Gargini, S., and Curini, A. (1999). “Pore water pressures and streambank stability: Results from a monitoring site on the Sieve River, Italy.” Earth Surf. Processes Landforms, 24(12), 1095–1114.
Darby, S. E., and Thorne, C. R. (1996). “Development and testing of riverbank-stability analysis.” J. Hydraul. Eng., 122(8), 443–454.
Fan, K., Fredlund, D. G., and Wilson, G. W. (1986). “An interslice force function for limit equilibrium slope stability analysis.” Can. Geotech. J., 23(3), 287–296.
Federal Interagency Stream Restoration Working Group (FISRWG). (1998). Stream corridor restoration: Principles, processes, and practices, GPO, Washington, D.C.
Fellenius, W. (1936). “Calculation of the stability of earth dams.” Trans., 2nd Congress on Large Dams, Vol. 4, 445–462.
Fox, G. A., Wilson, G. V., Periketi, R. K., and Cullum, R. F. (2006). “Sediment transport model for seepage erosion of streambank sediment.” J. Hydrol. Eng., 11(6), 603–611.
Fredlund, D. G., and Krahn, J. (1977). “Comparison of slope stability methods of analysis.” Can. Geotech. J., 14(3), 429–439.
Fredlund, D. G., and Rahardjo, H. (1993). Soil mechanics for unsaturated soils, Wiley, New York.
Gray, D. H., and Leiser, A. T. (1982). Biotechnical slope protection and erosion control, Krieger, Malabar, Fla.
Grissinger, E. H., and Murphey, J. B. (1983). “Present channel stability and late Quaternary valley deposits in northern Mississippi.” Modern and ancient fluvial systems, J. D. Collinson and J. Lewin, eds., Blackwell Scientific Publications, Oxford, U.K., 241–250.
Hagerty, D. J. (1991). “Piping/sapping erosion. I: Basic considerations.” J. Hydraul. Eng., 117(8), 991–1008.
Huang, Y. H. (1983). Stability analysis of earth slopes, Van Nostrand Reinhold Company, New York.
Janbu, N. (1954). “Application of composite slip surface for stability analysis.” Proc., European Conf. on the Stability of Earth Slopes, Vol. 3, 43–49.
Janbu, N. (1973). “Slope stability computations.” Embankment dam engineering—Casagrande volume, R. C. Hirschfeld and S. J. Poulos, eds., Wiley, New York, 47–86.
Kaufman, E. H., Jr., Leeming, D. J., and Taylor, G. D. (1995). “An ODE-based approach to nonlinearly constrained minimax problems.” Numer. Algorithms, 9(1), 25–37.
Lambe, T. W., and Whitman, R. V. (1969). Soil mechanics, Wiley, New York.
Langendoen, E. J. (2000). “CONCEPTS—Conservational channel evolution and pollutant transport system.” Research Rep. No. 16, USDA, Agricultural Research Service, National Sedimentation Laboratory, Oxford, Miss.
Langendoen, E. J., and Alonso, C. V. (2008). “Modeling evolution of incised streams: I. Model formulation and validation of flow and streambed evolution components.” J. Hydraul. Eng., 134(6), 749–762
Langendoen, E. J., Lowrance, R. R., Williams, R. G., Pollen, N., and Simon, A. (2005). “Modeling the impact of riparian buffer systems on bank stability of an incised stream.” Proc., World Water and Environmental Resources Congress (CD-ROM).
Langendoen, E. J., Simon, A., Curini, A., and Alonso, C. V. (1999). “Field validation of an improved process-based model for streambank stability analysis.” Water resources into the new millennium: Past accomplishments and new challenges (CD-ROM), R. Walton and R. E. Nece, eds., Water Resources Publications, Highlands Ranch, Colo.
Langendoen, E. J., Simon, A., Pollen, N., Williams, R. G., and Lowrance, R. R. (2006). “A comprehensive stream-riparian corridor model to study the impact of riparian buffers on channel and edge-of-field processes: Simulation of streambank hydrology.” Proc., 3rd Federal Interagency Hydrologic Modeling Conf. (CD-ROM).
Lutenegger, J. A., and Hallberg, B. R. (1981). “Borehole shear test in geotechnical investigations.” ASTM Special Publication No. 740, 566–578.
Morgenstern, N., and Price, V. E. (1965). “The analysis of the stability of general slip surfaces.” Geotechnique, 15(1), 79–93.
Osman, A. M., and Thorne, C. R. (1988). “Riverbank stability analysis. I: Theory.” J. Hydraul. Eng., 114(2), 134–150.
Rinaldi, M., and Casagli, N. (1999). “Stability of streambanks formed in partially saturated soils and effects of negative pore water pressure: The Sieve River (Italy).” Geomorphology, 26(4), 253–277.
Simon, A., and Collison, A. J. C. (2002). “Quantifying the mechanical and hydrologic effects of riparian vegetation on streambank stability.” Earth Surf. Processes Landforms, 27(5), 527–546.
Simon, A., and Curini, A. (1998). “Pore pressure and bank stability: The influence of matric suction.” Proc., Water Resources Engineering ’98, S. R. Abt, J. Young-Pezeshk, and C. C. Watson, eds., ASCE, Reston, Va., 358–363.
Simon, A., Curini, A., Darby, S. E., and Langendoen, E. J. (2000). “Bank and near-bank processes in an incised channel.” Geomorphology, 35(3–4), 193–217.
Simon, A., and Darby, S. E. (1997). “Bank erosion processes in two incised meander bends: Goodwin Creek, Mississippi.” Management of landscapes disturbed by channel incision, S. S. Y. Wang, E. J. Langendoen, and F. D. Shields, Jr., eds., University of Mississippi Press, University, Miss, 256–261.
Simon, A., and Rinaldi, M. (2006). “Disturbance, stream incision, and channel evolution: The roles of excess transport capacity and boundary materials in controlling channel response.” Geomorphology, 79(3–4), 361–383.
Simon, A., Wolfe, W. J., and Molinas, A. (1991). “Mass wasting algorithms in an alluvial channel model.” Proc., 5th Federal Interagency Sedimentation Conf., 8-22–8-29.
Spencer, E. (1968). “Effect of tension on stability of embankments.” J. Soil Mech. and Found. Div., 94(5), 1159–1173.
Taylor, D. W. (1948). Fundamentals of soil mechanics, Wiley, New York.
Thorne, C. R. (1982). “Processes and mechanisms of river bank erosion.” Gravel-bed rivers, R. D. Hey, J. C. Bathurst, and C. R. Thorne, eds., Wiley, New York, 227–271.
Thorne, C. R., and Tovey, N. K. (1981). “Stability of composite river banks.” Earth Surf. Processes Landforms, 6(5), 469–484.
U.S. Environmental Protection Agency (USEPA). (2000). “National water quality inventory: 1998 report to Congress.” Rep. No. EPA-841-R-00-001, Office of Water, Washington, D.C.
Whitman, R. V., and Bailey, W. A. (1967). “Use of computers for slope stability analysis.” J. Soil Mech. and Found. Div., 93(4), 475–498.
Wood, A. L. (2001). “A geomorphological analysis of bank toe processes: The fate of failed blocks stored in the basal zone of incised channels.” Ph.D. thesis, Univ. of Nottingham, Nottingham, U.K.
Information & Authors
Information
Published In
Copyright
© 2008 ASCE.
History
Received: Oct 31, 2005
Accepted: Sep 13, 2007
Published online: Jul 1, 2008
Published in print: Jul 2008
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.