Clear-Water Scour below Underwater Pipelines under Steady Flow
Publication: Journal of Hydraulic Engineering
Volume 134, Issue 5
Abstract
Experiments on clear-water scour below underwater pipelines (initially laid on the sediment bed) in uniform and nonuniform sediments under steady flow were conducted. Equilibrium scour profiles were modeled by a cubic polynomial. The experimental results are examined to describe the influence of various parameters on equilibrium scour depth. The equilibrium scour depth increases with increase in approach flow depth for shallow flow depths, becoming independent of higher flow depths when , where =pipe diameter. However, the curves of scour depth versus sediment size and Froude number have a maximum value of at and . The influence of sediment gradation on scour depth is prominent for nonuniform sediments, which reduce scour depth to a large extent due to the formation of armor layer within the scour hole. The influence of different shaped cross sections of pipes on the scour depth was investigated, where the shape factors for circular, (diagonal facing) and (side facing) square pipes obtained as 1, 1.29, and 1.91, respectively. Using the data of scour depths at different times, the time variation of scour depth is scaled by an exponential law, where the nondimensional time scale increases sharply with increase in Froude number characterized by the pipe diameter. In addition, clear-water scour below circular pipelines laid on a thinly armored sand bed (the sand bed is overlain by a thin armor layer of gravels) was experimentally studied. Depending on the pipe diameter, armor gravel, and bed-sand sizes, three cases of scour holes were recognized. The comparison of the experimental data reveals that the scour depth below a pipeline with an armor layer under limiting stability of the surface particles (approach flow velocity nearly equaling critical velocity for surface particles) is greater than that without armor layer for the same sand bed, if the secondary armoring formed within the scour hole is scattered. In contrast, the scour depth with an armor layer is less than that without armor layer for the same sand bed, when the scour hole is shielded by the secondary armor layer.
Get full access to this article
View all available purchase options and get full access to this article.
References
Ballio, F., and Orsi, E. (2000). “Time evolution of scour around bridge abutments.” Water Eng. Res., 2(4), 243–259.
Bijker, E. W., and Leeuwestein, W. (1984). “Interaction between pipelines and the seabed under influence of waves and currents.” Proc., Symp. on Int. Union of Theoretical Applied Mechanics/Int. Union of Geology and Geophys., 235–242.
Brørs, B. (1999). “Numerical modeling of flow and scour at pipelines.” J. Hydraul. Eng., 125(5), 511–523.
Chao, J. L., and Hennessy, P. V. (1972). “Local scour under ocean outfall pipe-lines.” J. Water Pollut. Control Fed., 44(7), 1443–1447.
Chiew, Y. M. (1990). “Mechanics of local scour around submarine pipelines.” J. Hydraul. Eng., 116(4), 515–529.
Chiew, Y. M. (1991). “Prediction of maximum scour depth at submarine pipelines.” J. Hydraul. Eng., 117(4), 452–466.
Dey, S. (1995). “Three-dimensional vortex flow field around a circular cylinder in a quasi-equilibrium scour hole.” Sadhana: Proc., Indian Acad. Sci., 20, 771–785.
Dey, S., and Barbhuiya, A. K. (2004a). “Clear water scour at abutments.” Proc. Inst. Civ. Eng., Water Management J., 157, 77–97.
Dey, S., and Barbhuiya, A. K. (2004b). “Clear-water scour at abutments in thinly armored beds.” J. Hydraul. Eng., 130(7), 622–634.
Dey, S., Bose, S. K., and Sastry, G. L. N. (1995). “Clear water scour at circular piers: A model.” J. Hydraul. Eng., 121(12), 869–876.
Dey, S., and Raikar, R. V. (2007). “Clear-water scour at piers in sand beds with an armor layer of gravels.” J. Hydraul. Eng., 133(6), 703–711.
Dey, S., and Sarkar, A. (2007). “Effect of upward seepage on scour and flow downstream of an apron due to submerged jets.” J. Hydraul. Eng., 133(1), 59–69.
Ettema, R. (1980). “Scour at bridge piers.” Rep. No. 216, School of Engineering, Univ. of Auckland, Auckland, New Zealand.
Froehlich, D. C. (1995). “Armor-limited clear-water contraction scour at bridges.” J. Hydraul. Eng., 121(6), 490–493.
Hansen, E. A., Fredsøe, J., and Ye, M. (1986). “Two-dimensional scour below pipelines.” Proc., 5th Int. Symp. on Offshore Mechanics and Arctic Engineering, 670–678.
Ibrahim, A., and Nalluri, C. (1986). “Scour prediction around marine pipelines.” Proc., 5th Int. Symp. on offshore Mechanics and Arctic Engineering, 679–684.
Kjeldsen, S. P., Gjørsvik, O., Bringaker, K. G., and Jacobsen, J. (1973). “Local scour near offshore pipelines.” Proc., 2nd Int. Conf. on Port and Ocean Engineering under Arctic Conditions, Univ. of Iceland, 308–331.
Lauchlan, C. S., and Melville, B. W. (2001). “Riprap protection at bridge piers.” J. Hydraul. Eng., 127(5), 412–418.
Li, F., and Cheng, L. (1999). “Numerical model for local scour under offshore pipelines.” J. Hydraul. Eng., 125(4), 400–406.
Mao, Y. (1986). “The interaction between a pipeline and an erodible bed.” Ser. Paper 39, Institute of Hydrodynamics and Hydraulic Engineering, Technical Univ. of Denmark, Lyngby, Denmark.
Maza, J. A. (1987). “Introduction to river engineering.” Advanced Course on Water Resources Management, Universitá Italiana per Stranieri, Perugia, Italy.
Melville, B. W. (1975). “Scour at bridge sites.” Rep. No. 117, School of Engineering, Univ. of Auckland, Auckland, New Zealand.
Moncada-M., A. T., and Aguirre-Pe, J. (1999). “Scour below pipeline in river crossings.” J. Hydraul. Eng., 125(9), 953–958.
Nalluri, C., and Ibrahim, A. (1985). “Scour around pipelines under marine environment.” Proc., 4th Symp. on Offshore Mechanics and Arctic Engineering, 569–575.
Raikar, R. V., and Dey, S. (2005). “Clear-water scour at bridge piers in fine and medium gravel beds.” Can. J. Civ. Eng., 32(4), 775–781.
Raudkivi, A. J., and Ettema, R. (1983). “Clear-water scour at cylindrical piers.” J. Hydraul. Eng., 109(3), 338–350.
Sumer, B. M., Christiansen, N., and Fredsøe, J. (1993). “Influence of cross section on wave scour around piles.” J. Waterway, Port, Coastal, Ocean Eng., 119(5), 477–495.
Sumer, B. M., and Fredsøe, J. (1992). The mechanics of scour in the marine environment, World Scientific, Singapore.
Sumer, B. M., Jensen, H. R., Mao, Y., and Fredsøe, J. (1988). “Effect of lee-wave on scour below pipelines in current.” J. Waterway, Port, Coastal, Ocean Eng., 114(1), 81–92.
Whitehouse, R. (1998). Scour at marine structures, Thomas Telford, London, U.K.
Information & Authors
Information
Published In
Copyright
© 2008 ASCE.
History
Received: Aug 23, 2006
Accepted: Aug 31, 2007
Published online: May 1, 2008
Published in print: May 2008
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.