Reduction of Bend Scour by an Outer Bank Footing: Footing Design and Bed Topography
Publication: Journal of Hydraulic Engineering
Volume 133, Issue 2
Abstract
Protection of banks against erosion is an important but very expensive task in river management. The outer banks in river bends are most vulnerable to erosion and require an enhanced protection. This paper investigates, in an experimental flume, the efficiency of scour reduction and bank protection near the outer banks in open-channel bends by means of a horizontal foundation, called footing, protruding into the flow. First it is experimentally verified that bed mobility has a minor influence on the bed topography, which is mainly shaped by bend effects. Subsequently, the influence of the footing width and vertical elevation on the bed topography is investigated under clear water scour conditions. A maximum scour reduction of more than 40% was obtained with a footing placed at one-third of the maximum scour depth without bank protection and a footing width of about two-thirds of this maximum scour value. But a footing that is too narrow and/or not deep enough is vulnerable to underscour and subsequent bank failure. The experiments convincingly demonstrate the efficiency of this bank protection technique. The optimal footing parameters in the presented experiments should merely be seen as indicative, however, as they are expected to be case dependent.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
This research has been sponsored by the Spanish Government Program FPI-PN97 and FEDER 1FD97-2110-C02-01. The laboratory tests were performed in the Hydraulic Laboratory of the Civil Engineering School of Castilla-La Mancha.
References
Blanckaert, K., and de Vriend, H. J. (2003). “Nonlinear modeling of mean flow redistribution in curved open channels.” Water Resour. Res., 39(12), 1375–1381.
Blanckaert, K., and de Vriend, H. J. (2004). “Secondary flow in sharp open-channel bends.” J. Fluid Mech., 498(1), 353–380.
Blanckaert, K., and Graf, W. H. (2004). “Momentum transport in sharp open-channel bends.” J. Hydraul. Eng., 130(3), 186–198.
Breusers, H. N. C., and Raudkivi, A. J. (1991). Scouring, International Association for Hydraulic Research, ed., Balkema, Rotterdam, The Netherlands.
Cardoso, A. H. (1998). Fluvial hydraulics, Fundaçao Calouste Gulbenkian, Lisbon, Portugal (in Portugese).
Engelund, F. (1974). “Flow and bed topography in channel bends.” J. Hydr. Div., 100(11), 1631–1648.
Hersberger, D. (2002). “Wall roughness effects on flow and scouring in curved channels with gravel bed.” Ph.D. thesis Nr 2632, École Polytechnique Fédérate Lausanne, Switzerland.
Johannesson, H., and Parker, G. (1989). “Secondary flow in mildly sinuous channel.” J. Hydraul. Eng., 115(3), 289–308.
Kawai, S., and Julien, P. Y. (1996). “Point bar deposits in narrow sharp bends.” J. Hydraul. Res., 34(2), 205–218.
Martín-Vide, J. P. (2002). River engineering, UPC Editions, Barcelona, Spain (in Spanish).
Maynord, S. T. (1996). “Toe-scour estimation in stabilized bendways.” J. Hydraul. Eng., 122(8), 460–464.
Maza Álvarez, J. A. (2003). River erosion and protection works. River engineering manual, Engineering Institute, UNAM, Mexico DF, Mexico (in Spanish).
Melville, B. M., and Coleman, S. E. (2000). Bridge scour, Water Resources Publications, Littleton, Colo.
Odgaard, A. J., and Mosconi, C. E. (1987). “Streambank protection by submerged vanes.” J. Hydraul. Eng., 113(4), 520–536.
Przedwojski, B., Blazejewski, R., and Pilarczyk, K. W. (1995). River training techniques, Balkema, Rotterdam, The Netherlands.
Roca, M. (2003). “Scour in a sharp bend. Effect of the outer bank wall footings.” Ph.D. dissertation, Technical Univ. of Catalonia, UPC, Barcelona, Spain (in Spanish).
Rozovskii, I. L. (1957). “Flow and water in bens of open channels.” Academy of Sciences of the Ukrainian SSr, Isr. Progr. Sc. Transl., Jerusalem, Israel.
Sterling Jones, J., Bertoldi, D., and Stein, S. (1995) “Alternative scour countermeasures.” Proc., Water Resources Engineering, ASCE, San Antonio, 1819–1823.
Struiksma, N., Olesen, K. W., Flokstra, C., and de Vriend, H. J. (1985). “Bed deformation in curved alluvial channels.” J. Hydraul. Res., 23(1), 57–79.
Van Rijn, L. C. (1993). Principles of sediment transport in rivers, estuaries and coastal seas, Aqua Publications I11, Amsterdam, The Netherlands.
Whiting, P. J., and Dietrich, W. E. (1993a). “Experimental studies of bed topography and flow patterns in large amplitude meanders. I: Observations.” Water Resour. Res., 29(11), 3605–3614.
Whiting, P. J., and Dietrich, W. E. (1993b). “Experimental studies of bed topography and flow patterns in large amplitude meanders. II: Mechanisms.” Water Resour. Res., 29(11), 3615–3622.
Yalin, M. S. (1977). Mechanics of sediment transport, Pergamon, Oxford, U.K.
Yalin, M. S., and Ferreira da Silva, A. M. (2001). Fluvial processes, IAHR Monograph, Balkema, Delft, The Netherlands.
Information & Authors
Information
Published In
Copyright
© 2007 ASCE.
History
Received: Jan 6, 2005
Accepted: Jul 18, 2006
Published online: Feb 1, 2007
Published in print: Feb 2007
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.