Estimating Bottom Stress in Tidal Boundary Layer from Acoustic Doppler Velocimeter Data
Publication: Journal of Hydraulic Engineering
Volume 126, Issue 6
Abstract
Bed stresses in the bottom boundary layer of the York River estuary, Va., were estimated from 3D near-bottom velocities measured by Acoustic Doppler Velocimeters (ADVs) and also by a profiling array of electromagnetic current meters. By assuming the measurements were made in a constant stress layer, four methods of stress estimation were evaluated using ADVs: (1) direct covariance (COV) measurement; (2) turbulent kinetic energy; (3) inertial dissipation utilizing the Kolmogorov spectrum; and (4) log profile. The four methods yielded similar estimates of frictional velocity U* based on ADV output from both 14 and 44 cm above bed. All eight estimates of average U* were consistent with the overall mean of 1.10 cm/s to within the 95% confidence interval for individual burst estimates. The COV method worked slightly better nearer the bed, possibly because of the sensitivity of COV to the upper limit of the constant stress layer. The inertial dissipation method performed marginally well at 14 cm above bed, likely due to sediment induced stratification and insufficient separation of turbulent production and dissipation scales. The log profile method was the most variable and appeared most sensitive to stratification and to the thickness of the constant stress layer. The turbulent kinetic energy method was the most consistent at both heights and appears most promising for further development. Results encourage future use of the ADV in estuarine environments but also favor the simultaneous use of several methods to estimate bottom stress.
Get full access to this article
View all available purchase options and get full access to this article.
References
1.
Champagne, F. H., Friehe, C. A., and LaRue, J. C. (1977). “Flux measurements, flux estimation techniques, and fine-scale turbulence measurements in the unstable surface layer over land.” J. Atmosph. Sci., 34, 515–530.
2.
Cheng, R. T., Lind, C. H., and Gartner, J. W. (1999). “Estimates of bottom roughness length and bottom shear stress in south San Francisco Bay, California.” J. Geophys. Res., 104, 7715–7728.
3.
Dellapena, T. M., Kuehl, S. A., and Schaffner, L. C. (1998). “Sea-bed mixing and particle residence times in biologically dominated estuarine systems: A comparison of lower Chesapeake Bay and the York River subestuary.” Estuar. Coast. Shelf Sci., 46, 777–795.
4.
French, J. R., and Clifford, N. J. (1992). “Characteristics and event-structure of near-bed turbulence in a saltmarsh channel.” Estuar. Coast. Shelf Sci., 34, 49–69.
5.
Galperin, B., Kantha, L. H., Hassid, S., and Rosati, A. (1988). “A quasi-equilibrium turbulent energy model for geophysical flows.” J. Atmosph. Sci., 45, 55–62.
6.
Green, M. O. (1992). “Spectral estimates of bed shear stress at subcritical Reynolds numbers in a tidal boundary layer.” J. Phys. Oceanogr., 22, 903–917.
7.
Gross, T. F., and Nowell, A. R. M. (1985). “Spectral scaling in a tidal boundary layer.” J. Phys. Oceanogr., 15, 496–508.
8.
Gross, T. F., Isley, A. E., and Sherwood, C. R. (1992). “Estimation of stress and bed roughness during storms on the Northern California Shelf.” Cont. Shelf Res., 12, 389–413.
9.
Heathershaw, A. D., and Simpson, J. H. (1978). “The sampling variability of the Reynolds stress and its relation to boundary shear stress and drag coefficient measurements.” Estuar. Coast. Shelf Sci., 6, 263–274.
10.
Huntley, D. A. (1988). “A modified inertial dissipation method for estimating seabed stresses at low Reynolds numbers, with application to wave/current boundary layer measurements.” J. Phys. Oceanogr., 18, 339–346.
11.
Kraus, N. C., Lohrmann, A., and Cabrera, R. (1994). “New acoustic meter for measuring 3D laboratory flows.”J. Hydr. Engrg., ASCE, 120(3), 406–412.
12.
Kuo, A. Y., Shen, J. and Hamrick, J. M. (1996). Effect of acceleration on bottom shear stress in tidal estuaries.”J. Wtrwy., Port, Coast., and Oc. Engrg., ASCE, 122(2), 75–83.
13.
Lohrmann, A., Cabrera, R., and Kraus, N. C. ( 1994). “Acoustic-Doppler velocimeter (ADV) for laboratory use.” Fundamentals and advancements in hydraulic measurements and experimental proceedings, ASCE, Reston, Va., 351–365.
14.
Lohrmann, A., Cabrera, R., Gelfenbaum, G., and Haines, J. (1995). “Direct measurements of Reynolds stress with an acoustic Doppler velocimeter.” Proc., IEEE 5th Working Conf. on Current Measurement, IEEE, Piscataway, N.J., 205–210
15.
Sanford, L. P., Panageotou, W., and Halka, J. P. (1991). “Tidal resuspension of sediments in northern Chesapeake Bay.” Mar. Geol., 97, 87–101.
16.
Sheng, Y. P., and Villaret, C. (1989). “Modeling the effect of suspended sediment stratification on bottom exchange processes.” J. Geophys. Res., 94, 14429–14444.
17.
Simpson, J. H., Brown, J., Matthews, J., and Allen, G. (1990). “Tidal straining, density currents, and stirring in the control of estuarine stratification.” Estuaries, 13, 125–132.
18.
Snedecor, G. W., and Cochran, W. G. (1967). Statistical methods, Iowa State University Press, Ames, Iowa.
19.
Snyder, W. H., and Castro, I. P. (1999). “Acoustic Doppler velocimeter evaluation in stratified towing tank.”J. Hydr. Engrg., ASCE, 125(6), 595–603.
20.
Soulsby, R. L. (1980). “Selecting record length and digitization rate for near-bed turbulence measurement.” J. Phys. Oceanogr., 10, 208–219.
21.
Soulsby, R. L., and Dyer, K. R. (1981). “The form of the near-bed velocity profile in a tidally accelerating flow.” J. Geophys. Res., 86, 8067–8074.
22.
Stapleton, K. R., and Huntley, D. A. (1995). “Seabed stress determination using the inertial dissipation method and the turbulent kinetic energy method.” Earth Surface Processes and Landforms, 20, 807–815.
23.
Sukhodolov, A. Thiele, M., and Bungartz, H. (1998). “Turbulence structure in a river reach with sand bed.” Water Resour. Res., 34, 1317–1334.
24.
Tennekes, H., and Lumley, J. L. (1972). A first course in turbulence, MIT Press, Cambridge, Mass.
25.
Voulgaris, B., and Trowbridge, J. H. (1998). “Evaluation of the Acoustic Doppler Velocimeter (ADV) for turbulence measurements.” J. Atmosph. Oceanic Technol., 15, 272–289.
26.
Wright, L. D., Kim, S.-C., and Friedrichs, C. T. (1999). “Across-shelf variations in bed roughness, bed stress and sediment suspension on the Northern California shelf.” Mar. Geol. 154, 99–115.
Information & Authors
Information
Published In
Journal of Hydraulic Engineering
Volume 126 • Issue 6 • June 2000
Pages: 399 - 406
History
Received: Jul 6, 1999
Published online: Jun 1, 2000
Published in print: Jun 2000
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.