Numerical Analysis of River Channel Processes with Bank Erosion
Publication: Journal of Hydraulic Engineering
Volume 126, Issue 4
Abstract
This paper presents a numerical analysis of river channel processes with bank erosion. The model can be used for investigating both bed-deformation and bankline shifting in 2D plan form. The basic equations are used in a moving boundary fitted-coordinate system, and a new formulation of nonequilibrium sediment transport is introduced to reproduce the channel processes. The model was applied to examine the morphological behavior of experimental channels. Temporal changes in the plan form in a meandering channel can be classified into two patterns: meander developing and meander straightening. Comparison of the observed and calculated results indicates that the model is applicable to both channel changes under various hydraulic conditions. On the basis of the numerical findings, the paper clarifies the influence of hydraulic variables on the location of bank erosion and bed scouring. The model also was used to investigate the effect of alternate bars on bank erosion and to investigate the development of channel meandering from an initially straight channel.
Get full access to this article
View all available purchase options and get full access to this article.
References
1.
Blondeaux, P., and Seminara, G. (1985). “A unified bar-bend theory of river meanders.” J. Fluid Mech., Cambridge, U.K., 157, 449–470.
2.
Darby, S. E., and Thorne, C. R. (1996). “Numerical simulation of widening and bed deformation of straight sand-bed rivers. I: Model development.”J. Hydr. Engrg., ASCE, 122(4), 184–193.
3.
Darby, S. E., Thorne, C. R., and Simon, A. (1996). “Numerical simulation of widening and bed deformation of straight sand-bed rivers. II: Model evaluation.”J. Hydr. Engrg., ASCE, 122(4), 194–202.
4.
Duan, G., Jia, Y., and Wang, S. (1997). “Meandering process simulation with a two dimensional numerical model.” Proc., Conf. on Mgmt. of Landscapes Disturbed by Channel Incision, University of Mississippi, Miss., 389–394.
5.
Einstein, H. A. (1942). “Formulas for the transportation of bed load.” Trans. ASCE, Paper No. 2140, 561–597.
6.
Engelund, F. (1974). “Flow and bed topography in channel bends.”J. Hydr. Div., ASCE, 100(11), 1631–1648.
7.
Fletcher, C. A. J. (1991). Computational techniques for fluid dynamics, Vol. II, Springer, Berlin.
8.
Hasegawa, K. (1981). “Bank-erosion discharge based on a non-equilibrium theory.” Proc. JSCE, Tokyo, 316, 37–50 (in Japanese).
9.
Hasegawa, K., and Yamaoka, I. (1980). “The effect of plane and bed forms of channels upon the mender development.” Proc. JSCE, Tokyo, 296, 143–152.
10.
Ikeda, S., Parker, G., and Sawai, K. (1981). “Bend theory of river meanders. Part 1. Linear development.” J. Fluid Mech., Cambridge, U.K., 112, 363–377.
11.
Kikkawa, H., Kitagawa, A., and Ikeda, S. (1976). “Flow and bed topography in curved open channels.”J. Hydr. Div., ASCE, 102(9), 1327–1342.
12.
Kovacs, A., and Parker, G. (1994). “A new vectorial bedload formulation and its application to the time evolution of straight river channels.” J. Fluid Mech., Cambridge, U.K., 267, 153–183.
13.
Lane, E. W. (1955). “Design of stable channels.” Trans. ASCE, 120, 1234–1260.
14.
Mosselman, E., Huisink, M., Koomen, E., and Seijmonsbergen, A. C. ( 1995). “Morphological changes in a large braided sand-bed river.” River Geomorphology, E. J. Hickin, ed., Wiley, Chichester, U.K., 235–247.
15.
Muramoto, Y., and Fujita, Y. ( 1992). “Recent channel processes of the major rivers in Bangladesh.” Annuals of the Disaster Prevention Res. Inst., Kyoto Univ., Kyoto, Japan, 35 B-2, 89–114 (in Japanese).
16.
Nagata, N., Hosoda, T., Muramoto, Y., and Rahman, M. M. (1996). “Numerical analysis of unsteady open channel flows with channel processes.” Proc., 6th Hydr. Engrg. Software, Computational Mechanics Publications, Southampton, U.K., 234–242.
17.
Nakagawa, H., and Tsujimoto, T. (1980). “Sand bed instability due to bed load motion.”J. Hydr. Div., ASCE, 106(12), 2029–2051.
18.
Nakagawa, H., Tsujimoto, T., and Murakami, S. (1986). “Non-equilibrium bed load transport along side slope of an alluvial stream.” Proc., 3rd Int. Symp, on River Sedimentation, University of Mississippi, Miss., 885–893.
19.
Nezu, I., and Nakagawa, H. ( 1993). “Turbulence in open channel flows.” IAHR Monograph, Balkema, Rotterdam, The Netherlands, 53–56.
20.
Odgaard, A. J. (1986). “Meander flow model I: Development.”J. Hydr. Engrg., ASCE, 112(12), 1117–1136.
21.
Parker, G. (1984). “Discussion of `Lateral bed load transport on side slopes,' by S. Ikeda.”J. Hydr. Engrg., ASCE, 110(2), 197–203.
22.
Parker, G., and Johannesson, H. ( 1989). “Observations on several recent theories of resonance and over deepening in meandering channels.” River Meandering, Water Resources Monograph 12, American Geophysical Union, Washington, D.C., 379–415.
23.
Parker, G., Sawai, K., and Ikeda, S. (1982). “Bend theory of river meanders. Part 2. Nonlinear deformation of finite-amplitude bends.” J. Fluid Mech., Cambridge, U.K., 115, 303–314.
24.
Rahman, M. M., Nagata, N., and Murata, H. (1997). “Plan form variation of meandering channels with bank erosion.” Proc., 52th Annu. Conf. JSCE, Japan Society of Civil Engineers, Tokyo, 2, 506–507.
25.
Roache, P. J. (1976). Computational fluid dynamics. Hermosa, Albuquerque, N.M.
26.
Shimizu, Y., Hirano, M., and Watanabe, Y. (1996). “Numerical calculation of bank erosion and free meandering.”Annu. J. Hydr. Engrg., Tokyo, 40, 921–926 (in Japanese).
27.
Shimizu, Y., and Itakura, T. (1989). “Calculation of bed variation in alluvial channels.”J. Hydr. Engrg., ASCE, 115(3), 367–384.
28.
Tingsanchali, T., and Chinnarasri, C. (1997). “Design of Mekong river bank protection.” Proc., Conf. on Mgmt. of Landscapes Disturbed by Channel Incision, University of Mississippi, Miss., 345–348.
Information & Authors
Information
Published In
History
Received: Mar 16, 1998
Published online: Apr 1, 2000
Published in print: Apr 2000
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.