Comparison of Bed Load Sampler and Tracer Data on Initiation of Motion
Publication: Journal of Hydraulic Engineering
Volume 125, Issue 6
Abstract
Concerns that the Helley-Smith bed load sampler and painted tracer techniques measure different critical discharges for the initiation of motion for each particle size in coarse bed material rivers are investigated for two sites on the Roaring River in Colorado. For the sampler technique, the size of the largest particle trapped is paired with the discharge at the time of sampling. For the tracer technique, the maximum size of tracer moved is paired with the maximum discharge between emplacement and observation. Performance considerations suggest that the sampler technique may yield a larger critical discharge for a given particle size than will the tracer technique. The limited field data support this when the tracer measurements refer to the absolute maximum size moved. When the tracer measurements refer to the largest size moved for which all smaller sizes were moved, the data overlap the sampler data. Caution should therefore be displayed when using data from either technique to develop or test formulas for initiation of particle motion, as such formulas may show a small level of technique dependence.
Get full access to this article
View all available purchase options and get full access to this article.
References
1.
Andrews, E. D. ( 1983). “Entrainment of gravel from naturally sorted riverbed material.” Geological Soc. Am. Bull., 94, 1225–1231.
2.
Andrews, E. D. ( 1994). “Marginal bed load transport in a gravel bed stream, Sagehen Creek, California.” Water Resour. Res., 30(7), 2241–2250.
3.
Ashiq, M. ( 1997). “Bed load transport models for coarse bed material rivers,” PhD thesis, University of Newcastle upon Tyne, Newcastle upon Tyne, U.K.
4.
Bathurst, J. C. ( 1987). “Critical conditions for bed material movement in steep, boulder-bed streams.” Erosion and Sedimentation in the Pacific Rim: Proc., Int. Assoc. Hydro. Sci. Symp., International Association of Hydrological Sciences (IAHS) Publ. No. 165, Wallingford, U.K., 309–318.
5.
Bathurst, J. C., and Ashiq, M. ( 1998). “Dambreak flood impact on mountain stream bedload transport after 13 years.” Earth Surface Processes and Landforms, 23, 643–649.
6.
Bathurst, J. C., Leeks, G. J. L., and Newson, M. D. ( 1986a). “Relationship between sediment supply and sediment transport for the Roaring River, Colorado, U.S.A.” Drainage Basin Sediment Delivery: Proc., Int. Assoc. Hydro. Sci. Symp., International Association of Hydrological Sciences (IAHS) Publ. No. 159, Wallingford, U.K., 105–117.
7.
Bathurst, J. C., Leeks, G. J. L., and Newson, M. D. ( 1986b). “Field measurements for hydraulic and geomorphological studies of sediment transport: the special problems of mountain streams.” Measuring techniques in hydraulic research, A. C. E. Wessels, ed., Balkema, Rotterdam, The Netherlands, 137–151.
8.
Emmett, W. W. ( 1980). “A field calibration of the sediment-trapping characteristics of the Helley-Smith bedload sampler.” Prof. Paper 1139, U.S. Geological Survey, Washington, D.C.
9.
Helley, E. J., and Smith, W. ( 1971). “Development and calibration of a pressure-difference bedload sampler.” Open-File Rep., U.S. Geological Survey, Menlo Park, Calif.
10.
Hubbell, D. W., Stevens, H. H., Skinner, J. V., and Beverage, J. P. (1985). “New approach to calibrating bed load samplers.”J. Hydr. Engrg., ASCE, 111(4), 677–694.
11.
Inpasihardjo, K. ( 1991). “Bed load transport of nonuniform size sediment in mountain rivers,” PhD thesis, University of Newcastle upon Tyne, Newcastle upon Tyne, U.K.
12.
Johnson, C. W., Engelman, R. L., Smith, J. P., and Hanson, C. L. (1977). “Helley-Smith bed load samplers.”J. Hydr. Div., ASCE, 103(10), 1217–1221.
13.
O'Leary, S. J., and Beschta, R. L. ( 1981). “Bedload transport in an Oregon Coast Range stream” Water Resour. Bull., 17(5), 886–894.
14.
Reid, I., and Frostick, L. E. ( 1986). “Dynamics of bedload transport in Turkey Brook, a coarse-grained alluvial channel.” Earth Surface Processes and Landforms, 11, 143–155.
15.
Ryan, S. ( 1998). “Sampling bedload transport in coarse-grained mountain channels using portable samplers.” Sediment Technol. for 21st Century: Proc., Federal Interagency Workshop, St. Petersburg, Fla.
16.
Williams, G. P., and Rosgen, D. L. ( 1989). “Measured total sediment loads (suspended loads and bedloads) for 93 United States streams.” Open File Rep. 89-67, U.S. Geological Survey, Denver.
17.
Wolman, M. G. ( 1954). “A method of sampling coarse river-bed material.” Trans. Am. Geophysical Union, 35(6), 951–956.
Information & Authors
Information
Published In
Journal of Hydraulic Engineering
Volume 125 • Issue 6 • June 1999
Pages: 661 - 664
History
Published online: Jun 1, 1999
Published in print: Jun 1999
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.