Effects of Particle Size and Bulk Density on Erosion of Quartz Particles
Publication: Journal of Hydraulic Engineering
Volume 124, Issue 12
Abstract
Experiments have been done in order to determine the effects of particle size and bulk density on the erosion of quartz particles. Average particle sizes ranged from 5 to 1,350 μm, while bulk densities ranged from approximately 1.65 to 1.95 g/cm3. For the larger particles, the sediments behaved in a noncohesive manner, i.e., they consolidated rapidly and the surface eroded particle by particle. For the smaller particles, the sediments behaved in a cohesive manner, i.e., they consolidated relatively slowly and the surface eroded in chunks. Erosion rates were a very strong decreasing function of density for the finer particles and were essentially independent of density for the larger particles. For a particular bulk density and shear stress and as the particle size increased, the erosion rate increased rapidly for the smaller particles, reached a maximum, and then decreased rapidly for the larger particles. Critical stresses for erosion were strongly dependent on particle size and, for the smaller particles, were also strongly dependent on bulk density.
Get full access to this article
View all available purchase options and get full access to this article.
References
1.
Been, K.(1981). “Non-destructive soil bulk density measurements using X-ray attenuation.”Geotech. Testing J., 4, 169–176.
2.
Chepil, W. S.(1958). “The use of evenly spaced hemispheres to evaluate aerodynamic forces on a soil surface.”Trans. Am. Geophys. Union, 39, 397–404.
3.
Chepil, W. S.(1959). “Equilibrium of soil grains at the threshold of movement by wind.”Soil Sci. Soc. Proc., 23, 422–428.
4.
Dyer, K. (1986). Coastal and estuarine sediment dynamics. John Wiley & Sons, Inc., New York.
5.
Gotthard, D. (1997). “Three-dimensional, non-destructive measurements of sediment bulk density using gamma attenuation.”Rep., Dept. of Mech. and Envir. Engrg., University of California, Santa Barbara, Calif.
6.
Jepsen, R., Roberts, J., and Lick, W.(1997a). “Effects of bulk density on sediment erosion rates.”Water, Air, and Soil Pollution, 99, 21–31.
7.
Jepsen, R., Roberts, J., and Lick, W. (1997b). “Long Beach Harbor sediment study.”Rep. to the U.S. Army Corps of Engrs., Los Angeles Dist.
8.
McNeil, J., Taylor, C., and Lick, W.(1996). “Measurements of erosion of undisturbed bottom sediments with depth.”J. Hydr. Engrg., ASCE, 122(6), 316–324.
9.
Mantz, P. A.(1977). “Incipient transport of fine grains and flakes by fluids—extended Shields diagram.”J. Hydr. Div., ASCE, 103(6), 601–615.
10.
Mehta, A. J., and Lee, S. C.(1994). “Problems in linking the threshold condition for the transport of cohesionless and cohesive sediment grain.”Inst. of Coast. Res., 10, 170–177.
11.
Miller, M. C., McCave, I. N., and Komar, P. D.(1977). “Threshold of sediment motion under unidirectional currents.”Sedimentology, 24, 507–528.
12.
Taylor, C., and Lick, W. (1996). “Erosion properties of Great Lakes sediments.”Rep., Dept. of Mech. and Envir. Engrg., University of California, Santa Barbara, Calif.
13.
White, S. J.(1970). “Plane bed thresholds of fine-grained sediments.”Nature, 228, 152–153.
Information & Authors
Information
Published In
Copyright
Copyright © 1998 American Society of Civil Engineers.
History
Published online: Dec 1, 1998
Published in print: Dec 1998
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.