Overtopping Reliability Models for River Levee
Publication: Journal of Hydraulic Engineering
Volume 124, Issue 12
Abstract
Wind setup and wave run-up heights are important considerations in determining the total height of a river levee system. In this study, two generalized reliability models for a levee system are developed considering the inherent uncertainties associated with wind as well as hydrologic and hydraulic processes. The generalized models can be simplified to reliability models when only hydrologic and hydraulic uncertainties are incorporated. By using the concept of a wind-flood damage ratio, reliability values of a levee system can be obtained and discussed on the same economic basis. A higher ratio of wind-flood damage requires a higher total levee height to obtain the same reliability value as for a lower wind-flood damage ratio. The total reliability decreases with an increase in service period of the hydraulic structure and/or the wind-flood damage ratio if the total levee height remains the same. The models enable the performance of a levee system to be predicted in terms of reliability. When the total levee height is specified, different options exist for the flood levee height to protect flood overtopping and for the freeboard allowance to withstand wind-generated wave overtopping. The best option can be chosen on the basis of a maximum reliability value. An example application of the models shows how the flood levee height and freeboard allowance may be determined to yield maximum reliability.
Get full access to this article
View all available purchase options and get full access to this article.
References
1.
Ang, A. H-S., and Tang, W. H. (1984). Probability concepts in engineering planning and design. Vol. II: Decision, risk, and reliability. John Wiley and Sons, New York.
2.
Baecher, G., Pate, M., and de Neufville, R.(1980). “Dam failue in benefit/cost analysis.”J. Geotech. Engrg., ASCE, 106(1), 101–105.
3.
Cheng, S. T. (1993). “Statistics on dam failures.”Reliability and uncertainty analyses in hydraulic design, B. C. Yen and Y. K. Tung, eds., ASCE, Reston, Va., 97–105.
4.
Cheng, S. T., Yen, B. C., and Tang, W. H. (1982). “Overtopping risk for existing dam.”Civ. Engrg. Studies UILU-ENG-82-2017, Dept. of Civ. Engrg., University of Illinois at Urbana-Champaign, Urbana, Ill.
5.
Cheng, S. T., Yen, B. C., and Tang, W. H. (1986). “Wind induced overtopping risk of dams.”Stochastic and risk analysis in hydrauic engineering. Water Resources Publ., Highlands Ranch, Colo., 66–78.
6.
Cunnane, C. (1992). Hydrological frequency and time series analysis, Vol. 1, Int. Postgrad. Hydro. Course, University College, Galway, Ireland.
7.
Davis, D. W. (1991). “A risk and uncertainty based concept for sizing levee projects.”Proc., Hydrol. and Hydr. Workshop on Riverine Levee Freeboard, Monticello, Minn., 231–249. U.S. Army Corps of Engineers, Davis, Calif.
8.
Gui, S., Zhang, R., and Wu, J.(1998). “Simpified dynamic reliability models for hydraulic design.”J. Hydr. Engrg., ASCE, 124(3), 329–333.
9.
Haan, C. T. (1977). Statistical methods in hydrology. The Iowa State University Press, Ames, Iowa.
10.
Hall, W. A., and Howell, D. T.(1963). “Estimating flood probability within specific time intervals.”J. Hydrol., 1(1), 265–271.
11.
Jansen, R. B. (1988). Advanced dam engineering for design, construction, and rehabilitation. Van Nostrand Reinhold, Melbourne, Australia.
12.
MacArthur, R. C., and MacArthur, T. B. (1991). “International survey of levee freeboard design procedures.”Proc., Hydrol. and Hydr. Workshop on Riverine Levee Freeboard, Monticello, Minn., 211–227.
13.
Middlebrooks, T. A. (1953). “Earth dam practice in the United States.”Trans., ASCE, Reston, Va., 697–722.
14.
Moser, A. D. (1991). “Risk and uncertainty and the economics of levee level of protection and freeboard.”Proc., Hydrol. and Hydr. Workshop on Riverine Levee Freeboard, Monticello, Minn., 251–260, U.S. Army Corps of Engineers, Davis, Calif.
15.
Saville Jr., T., McClendon, E. W., and Cochran, A. L.(1962). “Freeboard allowances for waves in inland reservoirs.”J. Wtrwy. and Harb. Div., ASCE, 88(2), 93–124.
16.
Simiu, E., Bietry, J., and Filliben, J. J.(1978). “Sampling errors in estimation of extreme winds.”J. Struct. Div., ASCE, 104(3), 491–501.
17.
Simiu, E., Changery, M. J., and Filliben, J. J. (1979). “Extreme wind speeds at 129 stations in the United States.”NBS Build. Sci. Series 118, U.S. Dept. of Commerce, National Bureau of Standards, Washington, D.C.
18.
Simiu, E., and Filliben, J. J.(1980). “Weibull distributions and extreme wind speeds.”J. Struct. Div., ASCE, 106(12), 2365–2374.
19.
Tang, W. H.(1980). “Bayesian frequency analysis.”J. Hydr. Engrg., ASCE, 106(7), 1203–1218.
20.
Tang, W. H.(1981). “Probabilistic evaluation of loads.”J. Geotech. Engrg., ASCE, 107(3), 287–304.
21.
Thom, H. C. S.(1968). “New distributions of extreme winds in the United States.”J. Struct. Div., ASCE, 94(7), 1787–1801.
22.
Tung, T. K.(1985). “Models for evaluating flow conveyance reliability of hydraulic structures.”Water Resour. Res., 21(10), 1463–1468.
23.
Tung, Y. K., and Mays, L. W.(1980a). “Risk analysis for hydraulic design.”J. Hydr. Engrg., ASCE, 106(5), 893–913.
24.
Tung, Y. K., and Mays, L. W. (1980b). “Optimal risk-based design for water resources engineering projects.”Tech. Rep. CRWR-171, Ctr. for Res. in Water Resour., University of Texas, Austin, Tex.
25.
Tung, Y. K., and Mays, L. W.(1981). “Risk models for flood levee design.”Water Resour. Res., 17(4), 833–841.
26.
Wen, Y. K.(1977). “Statistical combination of extreme loads.”J. Struct. Div., ASCE, 103(5), 1079–1093.
27.
Wood, E. F.(1977). “An analysis of flood levee reliability.”Water Resour. Res., 13(3), 665–671.
28.
Yen, B. C.(1970). “Risks in hydrologic design of engineering projects.”J. Hydr. Engrg., ASCE, 96(4), 959–966.
Information & Authors
Information
Published In
Journal of Hydraulic Engineering
Volume 124 • Issue 12 • December 1998
Pages: 1227 - 1234
Copyright
Copyright © 1998 American Society of Civil Engineers.
History
Published online: Dec 1, 1998
Published in print: Dec 1998
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.