Field Verification of 2–D and 3–D Suspended‐Sediment Models
Publication: Journal of Hydraulic Engineering
Volume 116, Issue 10
Abstract
A tidal channel in the Eastern Scheldt estuary in the Netherlands is closed by pumping a sand‐water mixture into the closure gap. During the closure, fields measurements of flow velocities and sand concentrations are carried out. Based on the results of the field measurements, computations with two‐ and three‐dimensional sediment transport models are carried out. The two‐dimensional computations show that the depth‐integrated transport rates can be reasonably predicted (within a factor of 2) in case of diverging flow. But less satisfactory results are obtained for converging flow. The three‐dimensional computations show quite good agreement between measured and predicted flow velocities, sediment concentrations, and transport rates, both for flood and ebb flow. A sensitivity analysis with respect to the time‐dependent concentration term, the shape of the velocity profiles, the turbulent mixing coefficients, and the bed material gradation is carried out. The results show no significant influence of these parameters. The main reason for the difference between measured and predicted results is caused by the formula modeling the sediment pickup rate (at the bottom).
Get full access to this article
View all available purchase options and get full access to this article.
References
1.
Engelund, F., and Hansen, E. (1967). A monograph on sediment transport. Teknisk Verlag, Copenhagen, Denmark.
2.
Kerssens, P. J. M., Prins, A., and Van Rijn, L. C. (1979). “Model for suspended sediment transport.” J. Hydraul. Div., ASCE, (5), 461–476.
3.
Leendertse, J. J. (1972). “A water‐quality simulation model for well mixed estuaries and coastal seas: Vol IV, Jamaica Bay tidal flows.” R‐1009‐NYC, The Rand Institute, New York, N.Y., July.
4.
Ogink, H. J. M. (1984). “Hydraulic roughness of the Bovenrijn and Waal River.” Report R2017, Delft Hydraulics, Emmeloord, The Netherlands, (in Dutch).
5.
Schaafsma, A. S., and van der Kinderen, W. J. G. J. (1985). “Ultrasonic instruments for the continuous measurement of suspended sand transport.” Proc. Int. Assoc. for Hydraulic Research Symp., Measuring Techniques in Hydraul. Res., Delft, The Netherlands.
6.
Termes, A. P. P. (1987). “Sand transport computations in closures Eastern Scheldt tidal channel.” Report Q508‐III, Delft Hydraulics, Emmeloord, The Netherlands, (in Dutch).
7.
Van Rijn, L. C. (1984a). “Sediment transport, part 1: Bed load transport.” J. Hydr. Engrg., ASCE, 110(10), 1431–1456.
8.
Van Rijn, L. C. (1984b). “Sediment transport, part 2: Suspended load transport.” J. Hydr. Engrg., ASCE, 110(11), 1613–1641.
9.
Van Rijn, L. C. (1984c). “Sediment transport, part 3: Bed forms and alluvial roughness.” J. Hydraul. Engrg., ASCE, 110(12), 1733–1754.
10.
Van Rijn, L. C. (1986). “Mathematical modelling of suspended sediment in nonuniform flows.” J. Hydraul. Engrg., ASCE, 112(6), 433–455.
11.
Van Rijn, L. C. (1987). “Mathematical modelling of morphological processes in the case of suspended sediment transport,” thesis presented to Delft University of Technology, at Delft, The Netherlands, in partial fulfillment of the requirements for the degree of Doctor of Philosophy.
12.
Van Rijn, L. C. (1990). Principles of fluid flow and surface waves in rivers, estuaries, seas and oceans. Aqua Publications, Amsterdam, The Netherlands.
13.
Van Rijn, L. C. (1989). Handbook of sediment transport by currents and waves. Delft Hydraulics, Delft, The Netherlands.
Information & Authors
Information
Published In
Copyright
Copyright © 1990 ASCE.
History
Published online: Oct 1, 1990
Published in print: Oct 1990
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.