Simulation of Missouri River Bed Degradation
Publication: Journal of Hydraulic Engineering
Volume 112, Issue 6
Abstract
The future course of bed degradation in the middle Missouri River has been predicted using numerical simulation techniques. The simulation required development of the new Total Load Transport Model (TLTM), which incorporates the interdependence of friction factor and sediment transport through data‐based empirical relations. TLTM was implemented in a mathematical simulation model called IALLUVIAL, which computes quasi‐steady water and sediment flow in natural rivers having nonuniform bed sediments. IALLUVIAL also incorporates bed‐sediment sorting and armoring, which are processes of fundamental importance to the future course of Missouri River degradation. IALLUVIAL was first validated through simulation of the 1960–1980 severe degradation in the Missouri River between Sioux City, Iowa and Omaha, Nebraska. Subsequently IALLUVIAL was used to predict 1980–2000 degradation for several river‐management scenarios. The simulations suggest that the worst of the degradation is now over, and that it is the channelization, rather than upstream regulation, which is primarily responsible for the degradation. A companion paper describes the details of IALLUVIAL's armoring and sorting simulation procedures.
Get full access to this article
View all available purchase options and get full access to this article.
References
1.
Alam, A. M. Z., and Kennedy, J. F., “Friction Factors for Flow in Sand Bed Channels,” Journal of the Hydraulics Division, ASCE, Vol. 95, HY6, Nov., 1969, pp. 1973–1992.
2.
Brownlie, W. R., “Prediction of Flow Depth and Sediment Discharge in Open Channels,” Report No. KH‐R‐43A, W. M. Keck Laboratory of Hydraulics and Water Resources, California Institute of Technology, Pasadena, Calif., Nov., 1981.
3.
Chang, H., and Hill, J. C., “Computer Modeling of Erodible Flood Channels and Deltas,” Journal of the Hydraulics Division, ASCE, Vol. 102, No. HY10, Oct., 1976, pp. 1461–1478.
4.
Cunge, J. A., “Programme CHAR 2—Calcul d'Evolutions Lentes des Fonds en Regimes Non Stationnaires pour les Rivieres Presentant une Resistance du Type Manning‐Strickler,” Technical Note 36‐1328, SOGREAH Consulting Engineers, Grenoble, France, Nov., 1980.
5.
Cunge, J. A., Holly, F. M., Jr., and Verwey, A., Practical Aspects of Computational River Hydraulics, Pitman Publishing Ltd., London, England, 1980.
6.
Einstein, H. A., and Barbarossa, N., “River Channel Roughness,” Transactions, ASCE, Vol. 117, Paper No. 2528, 1952, pp. 1121–1146.
7.
Engelund, F., “Hydraulic Resistance of Alluvial Streams,” Journal of the Hydraulics Division, ASCE, Vol. 92, HY2, Mar., 1966, pp. 315–328.
8.
Garde, R. J., and Raju, K. G. R., “Resistance Relationships for Alluvial Channel Flow,” Journal of the Hydraulics Division, ASCE, Vol. 92, No. HY4, Proc. Paper 4869, July, 1966, pp. 77–102.
9.
Holly, F. M., and Karim, M. F., “Computer Simulation Prognosis for the Degradation of the Missouri River Between Gavins Point Dam and Iowa's Southern Border,” Iowa Institute of Hydraulic Research, The Univ. of Iowa, Report No. 267, Aug., 1983.
10.
Holly, F. M., Jr., Nakato, T. N., and Kennedy, J. F., “Computer‐Based Prediction of Alluvial River‐Bed Changes,” 2nd Bridge Engineering Conference, Highway Research Board, Minneapolis, Minn., Sept. 24–26, 1984.
11.
Holly, F. M., Jr., Yang, J. C., and Karim, M. F., “Computer‐Based Prognosis of Missouri River Bed Degradation—Refinement of Computational Procedures,” Iowa Institute of Hydraulic Research, The Univ. of Iowa, Report No. 281, Aug., 1984.
12.
Karim, M. F., and Kennedy, J. F., “Computer‐Based Predictors for Sediment Discharge and Friction Factor of Alluvial Streams,” Iowa Institute of Hydraulic Research, The Univ. of Iowa, Report No. 242, Dec., 1981.
13.
Karim, M. F., and Kennedy, J. F., “IALLUVIAL: A Computer‐Based Flow and Sediment Routing Model for Alluvial Streams and its Application to the Missouri River,” Iowa Institute of Hydraulic Research, The Univ. of Iowa, Report No. 250, Aug., 1982.
14.
Karim, M. F., and Holly, F. M., Jr., “Bed‐Armoring and Sorting Simulation in Alluvial Rivers,” to be published in Journal of Hydraulic Engineering, ASCE, 1986.
15.
Kennedy, J. F., “Laboratory Study of an Alluvial Stream at Constant Discharge,” Proceedings, Federal Inter‐Agency Sedimentation Conference, Paper No. 37, 1963, pp. 320–330.
16.
Kyozo, S., “On the Simulation of River‐Bed Variations by Characteristics,” Proceedings, 13th Congress of the IAHR, Kyoto, Japan, 1969.
17.
Lovera, F., and Kennedy, J. F., “Friction‐Factors for Flat‐Bed Flows in Sand Channels,” Journal of the Hydraulics Division, ASCE, Vol. 95, HY4, July, 1969, pp. 1227–1234.
18.
Nordin, C. F., “Aspects of Flow Resistance and Sediment Transport, Rio Grande Near Bernalillo, New Mexico,” Geological Survey Water Supply Paper, 1498‐H, 1964.
19.
Preissmann, A. P., “Propagation des Instumescences dans les Canaux et Rivieres,” 1st Congress of the French Association for Computation, Grenoble, Sept., 1961.
20.
Raudkivi, A. J., “Analyses of Resistance in Fluvial Channels,” Journal of Hydraulics Division, ASCE, Vol. 93, HY5, Sept., 1967, pp. 73–84.
21.
Sayre, W. W., and Kennedy, J. F., “Degradation and Aggradation of the Missouri River,” Iowa Institute of Hydraulic Research, Univ. of Iowa, Report No. 215, June, 1978.
22.
Simons, D. B., Li, R. M., and Brown, G. O., “Sedimentation Study of the Yazoo River Basin—User Manual for Program KUWASER,” Report CER79‐80DBS‐R, Colorado State Univ., Fort Collins, Colo., Aug., 1979.
23.
Simons and Li Associates, Inc., “Scour and Sedimentation Analysis of the Proposed Channelization of the Salt River for Protecting the Sky Harbor International Airport in Phoenix, Arizona,” Howard, Needles, Tammen, and Bergendoff, Kansas City, Mo., 1980.
24.
Simons, D. B., and Chen, Y. H., “A Mathematical Model of the Lower Chippewa River Network System,” Report CER78‐79‐DBS‐YHC58, Colorado State Univ., Fort Collins, Colo., June, 1979.
25.
Thomas, W. A., and Prashun, A. L., “Mathematical Modeling of Scour and Deposition,” Journal of the Hydraulics Division, ASCE, Vol. 103, No. HY8, Aug., 1977, pp. 851–864.
26.
Vanoni, V., Ed., Sedimentation Engineering, ASCE M&R No. 54, 1975.
27.
Vanoni, V. A., and Brooks, N. H., “Laboratory Studies of the Roughness and Suspended Load of Alluvial Streams,” California Institute of Technology, Pasadena, Calif., 1957.
28.
Vanoni, V. A., and Hwang, L. S., “Relation Between Bed Forms and Friction in Streams,” Journal of the Hydraulics Division, ASCE, Vol. 93, No. HY3, Proc. Paper 5242, May, 1967, pp. 121–144.
29.
Vreugdenhil, C. B., and de Vries, M., “Computations of Non‐steady Bed‐Load Transport by a Pseudo‐Viscosity Method,” Delft Hydraulics Laboratory Publication No. 45, Delft, The Netherlands, 1967.
30.
White, W. R., Paris, E., and Bettess, R., “A New General Method for Predicting the Frictional Characteristics of Alluvial Streams,” Report No. IT 187, Hydraulics Research Station, Wallingford, England, 1979.
Information & Authors
Information
Published In
Copyright
Copyright © 1986 ASCE.
History
Published online: Jun 1, 1986
Published in print: Jun 1986
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.