Sediment Control by Submerged Vanes
Publication: Journal of Hydraulic Engineering
Volume 112, Issue 12
Abstract
A procedure is developed for a rational design of a system of submerged vanes for depth control in alluvial‐river channels. The vanes are vertical, small‐aspect ratio foils installed on the channel bed at an angle of attack of 10–15° with the flow. Their height is 0.2–0.5 times the water depth at design flow (stage). The design procedure is based on a calculation of the transverse bed slope generated by the vane‐induced transverse component of the nearbed velocity vector. The streamwise extent of the vanes' impact is governed by the momentum equation. The effectiveness of the technique is tested in a series of laboratory experiments.
Get full access to this article
View all available purchase options and get full access to this article.
References
1.
Batalin, R. I. (1961). “Application of transverse circulation methods to problems of erosion and siltation,” The Dock and Harbour Authority, Vol. 42, pp. 407–408.
2.
Bramley, M. E., and Thompson, G. (1984). “Design of the remodelled headworks and canal system for the Greater Mussayib Project,” Channels and Channel Control Structures, K. V. H. Smith, Ed., Springer Verlag, Berlin, Heidelberg.
3.
Chabert, J., Remillieux, M., and Spitz, I. (1961). “Application de la circulation transversale a la correction des rivieres et a la protection des prises d'eau,” Proceedings of the 9th Convention IAHR, Dubrovnik, Yugoslavia, pp. 1216–1223.
4.
Chabert, J., Remillieux, M., and Spitz, I. (1962). “Correction des rivieres par panneaux de fond,” Bulletin du Centre des Recherches et d' Essais de Chatou, No. 1, pp. 49–63.
5.
Chabert, J., and Remillieux, M. (1965). Discussion of “Channel stabilization of alluvial rivers,” Progress Report by the ASCE Task Committee on Channel Stabilization Works, Committee on Regulation and Stabilization of Rivers, Journal of the Waterways and Harbors Division, ASCE, Vol. 91, No. WW1, pp. 70–79.
6.
Falkovitch, A. I. (1950). “Etude hydraulique des panneaux deviateurs dans un courant,” Trudy VNIIGM, Vol. 3, Moscow, USSR.
7.
Fiuzat, A. A., Sweeney, C. E., and Kerssens, J. M. (1984). “Sedimentation of Dave Johnston power plant intake, Glenrock, Wyoming, U.S.A.,” Channels and Channel Control Structures, K. V. H. Smith, Ed., Springer‐Verlag, Berlin, Heidelberg.
8.
Jansen, P. Ph., Bendegom, L. van, Berg, J. van den, Vries, M. de, and Zanen, A., Eds. (1979). Principles of river engineering, Pitman Publishing Ltd., London, England.
9.
Kamphuis, J. W. (1974). “Determination of sand roughness for fixed beds,” Journal of Hydraulic Research, Vol. 12, No. 2, pp. 193–203.
10.
Kikkawa, H., Ikeda, S., and Kitagawa, A. (1976). “Flow and bed topography in curved open channels,” Journal of the Hydraulics Division, ASCE, Vol. 102, No. HY9, pp. 1317–1342.
11.
Nakato, T., and Kennedy, J. F. (1977). “Field study of sediment transport characteristics of the Mississippi River near Fox Island (RM355‐6) and Buzzard Island (RM349‐50),” IIHR Report No. 201, Iowa Institute of Hydraulic Research, The University of Iowa, Iowa City, Iowa.
12.
Nakato, T. (1984). “Model investigation of intake‐shoaling and pump‐vibration problems, Iowa generation Council Bluffs unit 3 circulating‐water intake,” IIHR Report No. 283, Iowa Institute of Hydraulic Research, The University of Iowa, Iowa City, Iowa.
13.
Nicollet, G. (1964). “Circulation transversale creee par des obstacles dans un canal,” thesis presented to the Faculte des Sciences de l'Universite de Paris, at Paris, France, in partial fulfillment of the requirements for the degree of Docteur‐Ingenieur.
14.
Odgaard, A. J. (1982). “Bed characteristics in alluvial channel bends,” Journal of the Hydraulic Division, ASCE, Vol. 108, No. HY11, pp. 1268–1281.
15.
Odgaard, A. J., and Kennedy, J. F. (1982). “Analysis of Sacramento River bend flows, and development of a new method for bank protection,” IIHR Report No. 241, Iowa Institute of Hydraulic Research, The University of Iowa, Iowa City, Iowa.
16.
Odgaard, A. J., and Kennedy, J. F. (1983). “River‐bend bank protection by submerged vanes,” Journal of Hydraulic Engineering, ASCE, Vol. 109, No. 8, pp. 1161–1173.
17.
Odgaard, A. J., and Lee, H. Y. E. (1984). “Submerged vanes for flow control and bank protection in streams,” IIHR Report No. 279, Iowa‐Institute of Hydraulic Research, The University of Iowa, Iowa City, Iowa.
18.
Odgaard, A. J. (1986). “Meander‐flow model. I: Development,” Journal of Hydraulic Engineering, ASCE, Vol. 112, No. 12, pp. 1117–1136.
19.
Onishi, Y., and Sayre, W. W. (1974). “Movable‐bed hydraulic model study for Cooper Nuclear Station intake system,” IIHR Report No. 156, Iowa Institute of Hydraulic Research, The University of Iowa, Iowa City, Iowa.
20.
Rozovskii, L. L. (1961). “Flow of water in bends of open channels,” Israel Program for Scientific Translations, Jerusalem, Israel, (available from U.S. Department of Commerce, National Technical Service, Springfield, VA 22161).
21.
Scheuerlein, H. (1983). “Der wasserbauliche modellversuch als hilfsmittel bei der bewaltigung von verlandungsproblemen in flussen,” Bericht Nr. 47, Versuchsanstalt fur Wasserbau der Technischen Universitat Munchen, Munchen/Obernach, West Germany, pp. 1–32.
22.
Scheuerlein, H. (1984a). Die wasserentnahme aus geschiebefuhrenden flussen, Wilhelm Ernst & Sohn, Verlag fur Architektur und technische Wissenschaften, Berlin.
23.
Scheuerlein, H. J. (1984b). “A new design of sediment control facilities for diversion headworks in mountain streams,” Channels and Channel Control Structures, K. V. H. Smith, Ed., Springer‐Verlag, Berlin, Heidelberg.
24.
Shields, A. (1936). “Anwendung der ähnlichkeitsmechanik und der turbulenzforschung auf die geshiebebewegung,” Mitteilungen der Preussischen Versuchsanstalt fur Wasserbau und Schiffbau, Berlin, Germany, Translated to English by W. P. Ott and J. C. van Uchelen, California Institute of Technology, Pasadena, Calif.
25.
U.S. Army Corps of Engineers (1981). Review report for water and related land resources management study, metropolitan Sioux City and Missouri River, Iowa, Nebraska and South Dakota, Vol. 4: Supporting Technical Report—Missouri River Degradation, Omaha District, Corps of Engineers.
26.
U.S. Army Corps of Engineers (1964–66). Symposium on channel stabilization problems, Vols. 1–4, Technical Report No. 1 of the Committee on Channel Stabilization, U.S. Army Engineers Waterways Experiment Station, Vicksburg, Miss.
27.
Vanoni, V. A., Ed. (1976). Sedimentation Engineering, Manual and Report on Engineering Practice, No. 4, ASCE.
28.
Vassiliev, O. F. (1958). “Fondements de la mecanique des ecoulements helicoidaux et a circulation,” Gosenergollzdat, Moscow, USSR.
Information & Authors
Information
Published In
Copyright
Copyright © 1986 ASCE.
History
Published online: Dec 1, 1986
Published in print: Dec 1986
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.