One-Dimensional Compression of Sands at High Pressures
This article has a reply.
VIEW THE REPLYPublication: Journal of Geotechnical Engineering
Volume 122, Issue 2
Abstract
A one-dimensional testing apparatus was developed to test soils to axial stresses up to 850 MPa. The apparatus was instrumented with strain gauges such that lateral soil stresses, and therefore K0, could be inferred from measured circumferential strains. Three different initial densities of quartz, Cambria, and gypsum sands were tested and it was found that the effect of initial density was eliminated at high stress magnitudes. This stress magnitude was higher for mineralogically harder grains than for softer grains. The inferred values of K0 for the mineralogically harder Cambria sand was found to be constant at high pressures, but slightly below that indicated by Jaky's equation. However, the softer gypsum sand indicated increasing values of K0 as the stress magnitude increased. This apparently was caused by inelastic, viscous flow during shearing.
Get full access to this article
View all available purchase options and get full access to this article.
References
1.
Andrawes, K. Z., and El-Sohby, M. A. (1973). “Factors affecting coefficient of earth pressure K0 .”J. Soil Mech. and Found. Div., ASCE, 99(7), 527–539.
2.
Bishop, A. W. (1958). “Test requirements for measuring the coefficient of earth pressure at rest.”Proc., Brussels Conf. on Earth Pressure Problems, Brussels, Belgium, Vol. 1, 2–14.
3.
Bopp, P. (1994). “Effect of initial relative density on instability and behavior of granular materials at high pressure,” PhD dissertation, Dept. of Civ. and Envir. Engrg., Univ. of California, Los Angeles, Calif.
4.
Hagerty, M. M., Hite, D. R., Ullrich, C. R., and Hagerty, D. J.(1993). “One-dimensional high-pressure compression of granular media.”J. Geotech. Engrg., ASCE, 119(1), 1–18.
5.
Hendron, A. (1963). “The behavior of sand in one-dimensional compression,” PhD dissertation, Univ. of Illinois, Urbana, Ill.
6.
Jaky, J. (1948). “Pressure in silos.”Proc., 2nd Int. Conf. on Soil Mech. and Found. Engrg., Vol. 1, 103–107.
7.
Lacerda, W. A. (1976). “Stress-relaxation and creep effects on soil deformation,” PhD dissertation, Dept. of Civ. Engrg., Univ. of California, Berkeley, Calif.
8.
Murphy, D. J. (1987). “Stress, degradation, and shear strength of granular material.”Geotechnical modeling and applications, Sayed M. Sayed, ed., Gulf Publishing Co., Houston, Tex., 181–211.
9.
Roberts, J. E., and de Souza, J. M. (1958). “The compressibility of sand.”Proc., Am. Soc. for Testing Mat., Vol. 58, ASTM, Philadelphia, Pa., 1269–1277.
10.
Schmertmann, J. H.(1983). “A simple question about consolidation.”J. Geotech. Engrg., ASCE, 109(1), 119–122.
11.
Terzaghi, K.(1920). “Old earth pressure theories and new test results.”Engrg. News Record, 85, 632.
12.
Terzaghi, K., and Peck, R. B. (1948). Soil mechanics in engineering practice, John Wiley and Sons, Inc., New York, N.Y., 65–67.
13.
Vesic, A. S., and Clough, G. W.(1968). “Behavior of granular materials under high stresses.”J. Soil Mech. and Found. Div., ASCE, 94(3), 661–688.
14.
Yamamuro, J. A. (1993). “Instability and behavior of granular materials at high pressures,” PhD dissertation, Dept. of Civ. Engrg., Univ. of California, Los Angeles, Calif., 738.
15.
Yamamuro, J. A., and Lade, P. V.(1996). “Drained sand behavior in axisymmetric tests at high pressures.”J. Geotech. Engrg., ASCE, 122(2), 109–119.
Information & Authors
Information
Published In
Copyright
Copyright © 1996 American Society of Civil Engineers.
History
Published online: Feb 1, 1996
Published in print: Feb 1996
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.