Formation of Shear Zones in Reinforced Sand
Publication: Journal of Geotechnical Engineering
Volume 122, Issue 11
Abstract
A series of tests was conducted in a plane-strain hollow cylindrical testing device. The reinforced sand samples developed wider shear zones than the unreinforced samples and had wider shear zones than similarly reinforced samples tested in direct-shear devices. Shear-zone width increased with increasing reinforcement concentration, reinforcement stiffness, and soil-reinforcement bond strength. Reduction of displacement data to a strain basis reveals that shear, elongational, compressional, and volumetric strains differ in unreinforced and reinforced samples. Dense, dilatant unreinforced sand samples formed narrow shear zones with large strains, whereas the reinforced samples had smaller but more uniform strains distributed throughout the samples. Reorientation of zero-extension shear planes in the reinforced samples limited the range of orientations over which the reinforcements contributed to strength. Overall, the results indicate that reinforced soils deforming in uniform stress fields do not develop narrow shear zones, and, therefore, reinforcement contribution to strength through reorientation and mobilization of bending moments is unlikely under field conditions. To insure that reinforcements are loaded in tension, they should be oriented well within 45° of the minor principal stress.
Get full access to this article
View all available purchase options and get full access to this article.
References
1.
Basset, R. H., and Last, N. C. (1978). “Reinforcing earth below footings and embankments.”Proc., Symp. on Earth Reinforcement, 202–229.
2.
Gray, D. H., and Ohashi, H.(1983). “Mechanics of fiber reinforcements in sand.”J., Geotech. Div., ASCE, 109(3), 335–353.
3.
Jewell, R. A. (1980). “Some factors which influence the shear strength of reinforced sand.”Proc., Symp. on Comp. Applications to Geotech. Problems in Hwy. Engrg., CUED/D-Soils/TR85.
4.
Juran, I., Schlosser, F., Louis, C., Kernoa, M., and Eckmann, B. (1981). “Le reinforcement des sols par barres passives.”Proc., Tenth Int. Conf. on Soil Mech. and Found. Engrg., 713–716.
5.
Juran, I., Chen, C. L., and Guermazi, A.(1988). “Numerical analysis of the response of reinforced soils to direct shearing: Part 2.”Int. J., Numer. Anal. Meth. Geomech., 12(2), 157–171.
6.
Juran, I., and Chen, C. L.(1989). “Strain compatibility design method for reinforced earth walls.”J., Geotech. Div., ASCE, 115(4), 435–456.
7.
Roscoe, K. H.(1970). “The influence of strains in soil mechanics.”Géotechnique, London, England, 20(2), 129–170.
8.
Shewbridge, S. E. (1987). “The influence of reinforcement properties on the strength and deformation characteristics of a reinforced sand,” PhD dissertation, University of California, Berkeley.
9.
Shewbridge, S. E., and Sitar, N.(1989). “Deformation characteristics of reinforced sand in direct shear.”J., Geotech. Div., ASCE, 115(8), 1134–1147.
10.
Shewbridge, S. E., and Sitar, N.(1990). “Deformation based model for reinforced sand.”J., Geotech. Div., ASCE, 116(7), 1153–1170.
11.
Shewbridge, S. E., and Sitar, N.(1991). “Deformation based model for reinforced sand: Closure.”J., Geotech. Div., ASCE, 117(11), 1812–1817.
12.
Shewbridge, S. E., and Sitar, N.(1992a). “Strain compatibility design method for reinforced earth walls: Discussion.”J., Geotech. Div., ASCE, 118(2), 318–321.
13.
Shewbridge, S. E., and Sitar, N. (1992b). “Shear zone formation and slope stability analysis.”Geotech. Spec. Pub. No. 31, ASCE Spec. Conf., Stability and Perf. of Slopes and Embankments II, ASCE, New York, N.Y., 358–370.
14.
Sousa, J. (1986). “Dynamic properties of pavement materials,” PhD dissertation, University of California, Berkeley, Calif.
15.
Waldron, L. J.(1977). “The shear resistance of root-permeated homogeneous and stratified soil.”Soil Sci. Soc. of Am. J., 41(3), 843–849.
Information & Authors
Information
Published In
Journal of Geotechnical Engineering
Volume 122 • Issue 11 • November 1996
Pages: 873 - 885
Copyright
Copyright © 1996 American Society of Civil Engineers.
History
Published online: Nov 1, 1996
Published in print: Nov 1996
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.