Estimation of In Situ Lateral Stresses in Soils by Cone‐Penetration Test
Publication: Journal of Geotechnical Engineering
Volume 119, Issue 10
Abstract
A simple method for the estimation of in situ lateral stress in soils using the results of a cone‐penetration test (CPT) is described and illustrated. The method is based on the dependence of cone‐penetration‐test sleeve friction on lateral stress. It recognizes that insertion of the cone causes soil disturbance, so the normal stress on the friction sleeve must differ from the initial in situ value. The lateral earth pressure on the sleeve during penetration is assumed equal to the Rankine passive pressure value. Field test results show that the method gives estimates of lateral stress that compare well with values determined by other procedures, such as the self‐boring pressuremeter, the flat‐plate dilatometer, laboratory tests on undisturbed samples, and the Brooker and Ireland correlations. The method in its present form requires separate assumption or determination of the overconsolidation ratio of the soil.
Get full access to this article
View all available purchase options and get full access to this article.
References
1.
Bandis, C., and Lacasse, S. (1985a). “Self‐boring pressuremeter tests in Onsoy clay, field report and data reduction.” Internal report no. 40019‐10, Norwegian Geotech. Inst., Oslo, Norway.
2.
Bandis, C., and S. Lacasse (1985b). “Interpretation of self‐boring and push‐in pressuremeter tests in Holmen sand.” Progress report no. 40019‐21, Norwegian Geotech. Inst., Oslo, Norway.
3.
Bellotti, R., Bizzi, G., and Ghionna, V. (1982). “Design, construction and use of a calibration chamber.” Proc., 2nd European symp. on penetration testing, ESOPT II, A. A. Balkema, Rotterdam, The Netherlands, 2, 439–446.
4.
Benoit, J. (1983). “Analysis of self‐boring pressuremeter tests in soft clay,” PhD thesis, Stanford University, Stanford, Calif.
5.
Benoit, J., and Clough, G. W. (1986). “Self‐boring pressuremeter tests in soft clay.” J. Geotech Engrg, ASCE, 112(1), 60–78.
6.
Bonaparte, R., and Mitchell, J. K. (1979). The properties of San Francisco Bay mud at Hamilton Air Force Base, California. Dept. of Civ. Engrg., Univ. of California, Berkeley, Calif.
7.
Brooker, E. W., and Ireland, H. O. (1965). “Earth pressure at rest related to stress history.” Can. Geotech. J., II(1), 1–15.
8.
Campanella, R. G., and Robertson, P. K. (1981). “Applied cone research.” Symp. on Cone Penetration Testing and Experience, ASCE, New York, N.Y., 373–362.
9.
Chapman, G. A., and Donald, I. B. (1981). “Interpretation of static penetration tests in sand.” Proc., 10th Int. Conf. Soil Mech. and Found. Engrg., A. A. Balkema, Rotterdam, The Netherlands, 2, 455–450.
10.
Denby, G. M. (1978). “Self‐boring pressuremeter study of San Francisco Bay mud.” Technical report no. CE 232, Dept. of Civ. Engrg., Stanford Univ., Stanford, Calif.
11.
Durgunoglu, H. T., and Mitchell, J. K. (1975). “Static penetration resistance of soils, I: Analysis, II: Evaluation of theory and implication for practice.” Special conf. on in‐situ measurement of soil properties, ASCE, New York, N.Y., 1, 151–189.
12.
Eidsmoen, T., Howland, J., and Kjesbu, E. (1985). “Statistical evaluation of CPT's in Holmen sand.” Internal rep. no. 40015‐9, Norwegian Geotech. Inst., Oslo, Norway.
13.
Gillespie, D., Lunne, T., and Eisdmoen, T. (1985a). “In‐situ investigation techniques and interpretation for offshore practice, cone penetration tests in sand at Holmen, Drammen—field report and data reduction.” Internal rep. no. 40019‐13, Norwegian Geotech. Inst., Oslo, Norway.
14.
Gillespie, D., Lunne, T., and Eidsmoen, T. (1985b). “Cone penetration tests in sand at Holmen, Drammen—field report and data reduction.” Internal rep. no. 40019‐13, Norwegian Geotech. Inst., Oslo, Norway.
15.
Huntsman, S. T. (1985). “Determination of in‐situ lateral pressure of cohesionless soils by static cone penetrometer,” PhD thesis, University of California, Berkeley, Calif.
16.
Jaky, J. (1944). “The coefficient of earth pressure at rest.” J. Soc. of Hungarian Arch. and Engrs., Budapest, Hungary, 355–358 (in Hungarian).
17.
Karlsrud, K. (1988). “Summary, interpretation, and analysis of the pile load tests at the Lierstranda test site.” Report no. 52523‐26, Norwegian Geotech. Inst., Oslo, Norway.
18.
Lacasse, S. (1985). “Dilatometer tests in Onsoy clay.” Progress rep. no. 40019‐3, Norwegian Geotech. Inst., Oslo, Norway.
19.
Lacasse, S., and Lunne, T. (1986). “Dilatometer tests in sand, use of in‐situ tests in geotechnical engineering.” Geotech. special publication no. 6, ASCE, New York, N.Y., 686–699.
20.
Lacasse, S., and Vage, T. (19850. “Self‐boring pressuremeter tests in Holmen sand— field report and data reduction.” Internal rep. no. 40019‐18, Norwegian Geotech. Inst., Oslo, Norway.
21.
Marchetti, S. (1980). “In situ tests by flat dilatometer.” J. Geotech. Engrg., ASCE, 106(3), 299–321.
22.
Masood, T. (1990). “Determination of lateral earth pressure in soils by in‐situ measurement,” PhD thesis, University of California, Berkeley, Calif.
23.
Mayne, P. W., and Kemper, J. B. (1988). “Profiling OCR in stiff clays by CPT and SPT.” Geotech. Testing J., 11(2), 139–147.
24.
Mayne, P. W., and Kulhawy, F. H. (1982). “ relationship in soils.” J. Geotech. Engrg., 108(6), 851–872.
25.
Mokkelbost, K. H. (1988). “Application of dilatometer for pile design.” Internal rep. no. 521610‐1, Build. Res. Establishment and Norwegian Geotech. Inst., Oslo, Norway.
26.
Schmertmann, J. H. (1983). “Revised procedure for calculating and OCR from DMT's with and which incorporates the penetration force measurement to permit calculating the plain strain friction angle.” DMT Workshop, Schmertmann and Crapps, Inc., Gainesville, Fla.
27.
Schmertmann, J. H. (1985). Measure and use of the in‐situ lateral stress. Osterberg Vol., Dept. of Civ. Engrg., Northwestern Univ., Evanston, Ill., 189–213.
28.
Tringale, P. T. (1983). “Soil identification in‐situ using an acoustic cone penetrometer,” PhD thesis, University of California, Berkeley, Calif.
Information & Authors
Information
Published In
Copyright
Copyright © 1993 American Society of Civil Engineers.
History
Received: Jul 15, 1991
Published online: Oct 1, 1993
Published in print: Oct 1993
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.