Preliminary Design for NATM Tunnel Support in Soil
Publication: Journal of Geotechnical Engineering
Volume 118, Issue 4
Abstract
Design of tunnels constructed with the new Austrian tunneling method (NATM) is considered. With this method the tunnel is generally excavated using hand‐mining equipment and immediately supported with a continuous shell of shotcrete. The shotcrete acts as a preliminary support during the construction. A liner made of concrete is usually installed later to ensure the long‐term stability of the tunnel wall. The construction process of NATM tunnels is analyzed using the finite element method. The softening technique, currently used for the analysis of NATM tunnels, is improved and applied to a parametric study of ovoid transportation tunnels constructed in undrained clays. Based on this study, a simplified method is provided for the preliminary design of the NATM tunnel support. The method allows the estimation of moments and thrusts acting on the liner for a range of commonly encountered conditions. Design values are shown to be primarily dependent on soil deformation properties, initial stress conditions, and amounts of stress release in the ground prior to shotcreting.
Get full access to this article
View all available purchase options and get full access to this article.
References
1.
Cater, R. W., Shirlaw, J. N., Sullivan, C. A., and Chan, W. T. (1984). “Tunnels constructed for the Hong Kong Mass Transit Railway.” Hong Kong Engr., 12(10), 37–49.
2.
Deere, D. U., Peck, R. B., Monsees, J. E., and Schmidt, B. (1969). “Design of tunnel liners and support systems.” PB‐183 799, Report for the U.S. Department of Commerce, University of Illinois, Urbana, Ill.
3.
Hochmuth, W., Krischke, A., and Weber, J. (1985). Die Bauverfahren beim Münchner U‐Bahn‐Bau überblick über eine 20jährige Entwicklung. Tunnel 4, (in German), 206–218.
4.
Leca, E. (1989). “Analysis of NATM and shield tunneling in soft ground,” thesis presented to Virginia Polytechnic Institute and State University, at Blacksburg, Va., in partial fulfillment of the requirements for the degree of Doctor of Philosophy.
5.
Mana, A. I. (1978). “Finite element analyses of deep excavation behavior in soft clay,” thesis presented to Stanford University at Stanford, Calif., in partial fulfillment of the requirements for the degree of Doctor of Philosophy.
6.
Mohraz, B., Hendron, A. J., Ranken, R. E., and Salem, M. H. (1975). “Liner‐medium interaction in tunnels.” J. Constr. Div., ASCE, 101(1), 127–141.
7.
Mussger, K., Koinig, L., and Reischl, S. G. (1987). “Jet grouting in combination with NATM.” Proc., Rapid Excavation and Tunneling Conf., 1, 292–308.
8.
Panet, M. (1986). “Calcul du Soutènement des Tunnels à Section Circulaire par la Méthode Convergence‐Confinement avec un Champ de Contraintes Initiates Anisotropes.” Tunnels et Ouvrages Souterrains, 77, 228–232.
9.
Panet, M., and Guenot, A. (1982). “Analysis of convergence behind the face of a tunnel.” Proc., Int. Symp. Tunnelling '82, 197–204.
10.
Peck, R. B., Hendron, A. J., Jr., and Mohraz, B. (1972). “State of the art of soft ground tunneling.” Proc., 1st Rapid Excavation and Tunneling Conf., 259–286.
11.
Pierau, B. (1982). “Tunnel design with respect to the three‐dimensional state of stress and displacements around the temporary face.” Proc., Int. Conf. Numerical Methods in Geomechanics, 1221–1231.
12.
“Section E‐8a of WMATA's Greenbelt Route Washington Metropolitan Area Transit Authority. NATM Alternative Design. Sta. 515 + 35, Sta. 571 + 50.” (1987). Technical Report No. 1100‐TB‐6‐II & V. FEM, Sauer Corporation, Salzburg, Austria.
13.
Schikora, K., and Fink, T. (1982). “Berechnungsmethoden Moderner Bergmännischer Bauweisen beim U‐Bahn‐Bau.” Bauingenieur, 57, 193–198 (in German).
Information & Authors
Information
Published In
Copyright
Copyright © 1992 ASCE.
History
Published online: Apr 1, 1992
Published in print: Apr 1992
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.