Strain‐Softening Behavior of Granular Soil in Strain‐Path Testing
Publication: Journal of Geotechnical Engineering
Volume 118, Issue 2
Abstract
The strain‐softening response of a granular soil along a wide spectrum of strain paths is investigated experimentally. Direct strain‐path control is achieved by controlling the ratio of volume to axial strain increment using a digital pressure/ volume controller. The questions associated with the definition of strain softening are examined. Provided suitable experimental techniques are used to delay the onset of nonhomogeneous deformation, strain softening as a true material property of a soil element can be observed along certain strain paths. Two types of strain softening, prefailure and postfailure types, have been identified. The conditions for the occurrence of prefailure or postfailure strain softening were established. During postfailure strain softening, the effective stress state of the sample traces along the failure curve toward the origin. The sample, however, will suffer from an irrecoverable loss in shear strength if sheared at a confining stress close to the value prior to onset of postfailure softening. Thus, the shear strength of a sample, although not affected by unidirectional, prefailure shearing, is dependent on post‐failure strain history.
Get full access to this article
View all available purchase options and get full access to this article.
References
1.
Casey, J., and Naghdi, P. M. (1981). “On the characterization of strain‐hardening in plasticity.” J. Appl. Mech. Trans. ASME, 48(2), 285–296.
2.
Hettler, A., and Vardoulakis, I. (1984). “Behaviour of dry sand tested in a large triaxial apparatus.” Geotechnique, 34(2), 183–198.
3.
Hoeg, K. (1972). “Finite element analysis of strain‐softening clay.” J. Soil Mech. Found. Engrg. Div., ASCE, 98(1), 43–58.
4.
Lo, K. Y., and Lee, C. F. (1973). “Stress analysis and slope stability in strain‐softening materials.” Geotechnique, 23(1), 1–11.
5.
Lo, S.‐C. R. (1985). “Deformation behaviour of granular soils,” thesis presented to the Univ. of New South Wales, at Kensington, Australia, in partial fulfillment of the requirements for the degree of Doctor of Philosophy.
6.
Lo, S.‐C. R., Chu, J., and Lee, I. K. (1989). “A technique for reducing membrane penetration and bedding errors.” Geotech. Test. J., 12(4), 311–316.
7.
Lo, S.‐C. R., and Lee, I. K. (1990). “Response of a granular soil along constant stress increment ratio path.” J. Geotech. Engrg., ASCE, 116(3), 355–376.
8.
Menzies, B. K. (1987). “A computer controlled hydraulic testing system.” Proc. ASTM Symp. on Advanced Triaxial Testing, ASTM, Philadelphia, Pa., 82–94.
9.
Prevost, J.‐H., and Hoeg, K. (1975). “Soil mechanics and plasticity analysis of strain softening.” Geotechnique, 25(2), 279–297.
10.
Read, H. E., and Hegemier, G. A. (1984). “Strain softening of rock, soil and concrete—A review article.” Mech. Mater., 3, 271–294.
11.
Rowe, P. W. (1962). “The stress dilatancy relationship for static equilibrium of an assembly of particles in contact.” Proc. Royal Soc., A267, 500–529.
12.
Rowe, P. W. (1971). “Theoretical meaning and observed values of deformation parameters for soil.” Proc. Roscoe Memorial Symp. on Stress‐Strain Behaviour of Soils, Cambridge Univ., U.K., 143–194.
13.
Rowe, P. W., and Barden, L. (1964). “Importance of free ends in triaxial testing.” J. Soil Mech. Found. Engrg. Div., ASCE, 90(1), 1–15.
14.
Tatsuoka, F., Molenkamp, F., Torii, T., and Hino, T. (1984). “Behaviour of lubrication layers of platens in element tests.” Soils Found., 24(1), 113–128.
15.
Valanis, K. C. (1985). “On the uniqueness of solution of the initial value problem in strain softening materials.” J. Appl. Mech., ASME, 52(3), 649–653.
16.
Vardoulakis, I. (1979). “Bifurcation analysis of the triaxial test on sand samples.” Acta Mech., 32, 35–54.
17.
Vardoulakis, I. (1983). “Rigid granular plasticity model and bifuraction in the triaxial test.” Acta Mech., 49, 57–79.
Information & Authors
Information
Published In
Copyright
Copyright © 1992 ASCE.
History
Published online: Feb 1, 1992
Published in print: Feb 1992
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.