Estimation of Subgrade Resilient Modulus from Standard Tests
Publication: Journal of Geotechnical Engineering
Volume 116, Issue 5
Abstract
Mechanistic pavement design procedures based on elastic layer theory require the specification of elastic moduli for each material in the pavement section. Repeated load tests yielding a resilient modulus are frequently used to characterize the soil subgrade. Due to difficulties associated with cyclic testing, approximate methods are often used for design estimates of resilient modulus. These approximations are often based only on shear strength measures and do not account for the dependence on the magnitude of cyclic deviator stress. A procedure is described to relate the soil‐index properties and the moduli obtained from uncon‐fined compression tests, to resilient modulus. Two statistical models are described and demonstrated for 11 soils from throughout the state of Tennessee. One model provides an estimation of the breakpoint resilient modulus, or the modulus at a deviator stress of 6 psi (41 kPa). The second model provides a general nonlinear relationship for the modulus of fine‐grained soils as a function of deviator stress. Both models are demonstrated for a range of soils and are shown to provide a good characterization of the response for the soils investigated. Similar relationships can be developed for other subgrade soils, and may prove useful to agencies that use deterministic pavement design procedures, but lack the capability for high‐production repeated‐load testing.
Get full access to this article
View all available purchase options and get full access to this article.
References
1.
AASHTO guide for design of pavement structures. (1986). Amer. Assoc. of State Highway and Transp. Officials, Washington, D.C.
2.
Ahmed, S. B., and Larew, H. G. (1962). “A study of the repeated load strength moduli of soils.” Proc., 1st Int. Conf. on the Struct. Design of Asphalt Pavements, Univ. of Michigan, Ann Arbor, Mich., 637–648.
3.
Akai, K., et al. (1981). “Mechanical behavior of cohesive soil under repeated loading.” Proc., Int. Conf. “Recent Advances in Geotech. Engrg. and Soil Dynamics,” Vol1, 75–80.
4.
Akoto, B. K. A. (1986). “The effect of repeated loading on the ultimate unconfined compressive strength of a lime‐stabilized laterite.” Engrg. Geology, 23(2), 125–135.
5.
Bandyopadhay, S. S., and Frantzen, J. A. (1983). “Investigation of moisture variation in subgrade modulus by cross‐correlation method.” Transp. Res. Record, No. 945, Transportation Research Board, Washington, D.C, 10–15.
6.
Barksdale, R. D. (1975). “Test procedures for characterizing dynamic stress‐strain properties of pavement materials.” Special Report 162, Transportation Research Board, National Research Council, Washington, D.C.
7.
Boateng‐Poku, Y. (1988). “Testing and modeling of subgrade resilient moduli for Tennessee soils,” thesis presented to the University of Tennessee, at Knoxville, Tenn., in partial fulfillment of the requirements for the degree of Master of Science.
8.
Brown, S. F., Austin, G., and Overy, R. F. (1980). “Instrumented triaxial cell for cyclic loading of clays.” ASTM Geotech. Testing J., 3(4), 145–152.
9.
Brown, S. F., and Pappin, J. W. (1981). “Analysis of pavements with granular bases, layered pavement systems.” Transp. Res. Record No. 810, 17–23.
10.
Clough, G. W., and Duncan, J. M. (1971). “Finite element analyses of retaining wall behavior.” J. Soil Mech. and Found. Engrg. Div., ASCE, 97(12), 1657–1673.
11.
Drumm, E. C., and Moore, A. B. (1988). “Pavement design using rapid methods of collecting and analyzing deflection data: Phase II—Design procedure development.” Report to Tennessee Department of Transportation, Project 83‐25‐2,. Nashville, Tenn.
12.
Duncan, J. M., and Chang, C.‐Y. (1970). “Nonlinear analysis of stress and strain in soils.” J. Soil Mech. and Found. Engrg. Div., 96(5), 1629–1653.
13.
Figueroa, J. L., and Thompson, M. R. (1981). “Simplified structural analysis of flexible pavements for secondary roads based on ILLI‐PAVE,” Transp. Res. Record No. 766, 5–10.
14.
Fredlund, D. G., Bergan, A. T., and Wong, P. K. (1977). “Relationship between the resilient modulus and stress conditions for cohesive subgrade soils.” Transp. Res. Record No. 642, 73–871.
15.
Heuklelom, W., and Klomp, A. J. G. (1962). “Dynamic testing as a means of controlling pavement during and after construction.” Proc., 1st Int. Conf. on Struct. Design of Asphalt Pavement, Univ. of Michigan, Ann Arbor, Mich.
16.
Hicks, R. G., and Monismith, C. L. (1971). “Factors influencing the resilient response granular materials.” Highway Res. Record, No. 345, Highway Research Board, Washington, D.C., 14–31.
17.
Highter, W. H., and Moore, A. B. (1984). Pavement design using rapid methods of collecting and analyzing deflection data: Phase II—design procedure development; progress report I and interim design procedure. Civ. Engrg. Dept., Univ. of Tennessee, Knoxville, Tenn.
18.
Johnson, T. D. (1986). “The resilient moduli of subgrade soil in the East Tennessee area,” presented to the University of Tennessee, at Knoxville, Tenn., in partial fulfillment of the requirements for the degree of Master of Science.
19.
Kondner, R. L. (1963). “Hyperbolic stress‐strain response: Cohesive soils.” J. Soil Mech. and Found. Engrg. Div., 89(1), 115–143.
20.
Leschinsky, D., and Rawlings, D. L. (1988). “Stress path and permanent deformations in sand subjected to repeated load.” Geotech. Testing J., 11(1), 36–43.
21.
McVay, M., and Taesiri, Y. (1985). “Cyclic behavior of pavement base materials.” J. Geotech. Engrg., ASCE, 111(1), 1–17.
22.
"Methods of sampling and testing.” (1982). Standard specifications for transportation materials and methods of sampling and testing, 13th Ed., American Association of State Highway and Transportation Officials (AASHTO), Washington, D.C.
23.
Moossazadeh, J. M., Witczak, W. (1981). “Prediction of subgrade moduli for soil that exhibits nonlinear behavior.” Transp. Res. Record No. 810.
24.
Rada, G., and Witczak, M. W. (1981). “Comprehensive evaluation of laboratory resilient modulus results for granular materials.” Transp. Res. Record No. 810, 23–33.
25.
Raymond, G. P., Gaskin, P. N., and Addo‐Abedi, F. Y. (1979). “Repeated compressive loading of a leda clay.” Canadian Geotech. J., 16(1), 1–10.
26.
"Research and development of the Asphalt Institutes thickness design manual.” (1982). 9th Ed., Res. Report No. 82‐2, Asphalt Institute, College Park, Md.
27.
Sangrey, D. A., Henkel, D. J., and Esrig, M. I. (1969). “Effective stress response of a saturated clay soil to repeated loading.” Canadian Geotech. I., 6(3), 241–252.
28.
Sangrey, D. A., Pollard, W. S., and Egan, J. A. (1978). “Errors associated with the rate of undrained cyclic testing of clay soils.” ASTM Special Tech. Publication No. STP654, 280–294.
29.
Seed, H. B., Chan, C. K., and Lee, C. E. (1962). “Resilience characteristics of subgrade soils and their relation to fatigue failures in asphalt pavements.” Proc., 1st Int. Conf. on Struct. Design of Asphalt Pavements, Univ. of Michigan, Ann Arbor, Mich.
30.
Soderman, L. G., Kim, Y. D., and Milligan, V. (1968). “Field and laboratory studies of modulus of elasticity of a clay till.” Highway Res. Record No. 243, 1–11.
31.
Springer, M. E., and Elder, J. A. (1980). Soils of Tennessee. U.S. Dept. of Agr. Soil Conservation Service and the Univ. of Tennessee Agric. Experiment Station, Knoxville, Tenn., 1–64.
32.
Stewart, H. E. (1986). “Permanent strains from cyclic variable—Amplitude loadings.” J. Geotech. Engrg., 112(6), 646–660.
33.
Tanimoto, K., and Nishi, M. (1970). “Resilient characteristics of soils under repeated loading.” Soils and Found., 10(1), 75–92.
34.
Terrel, R. L., and Award, I. S. (1972). “Laboratory considerations.” Proc., Association of Asphalt Paving Technologists, AAPT Symp. of Tech. of Thick Lift Constr.
35.
Thompson, M. R., and Hoffman, M. S. (1983). “Concepts for developing an NDT‐based design procedure for determining asphalt concrete overlay thickness.” Transp. Res. Record No. 930, 12–18.
36.
Thompson, M. R., and Robnett, Q. L. (1976). “Final report, resilient properties of subgrade soils.” Civ. Engrg. Studies Transp. Engrg. Series No. 14, Illinois Cooperative Highway and Transp. Series No. 160, Urbana, Ill.
37.
Thompson, M. R., and Robnett, Q. L. (1979). “Resilient properties of subgrade soils.” Transp. Engrg. J., ASCE, 105(1), 71–89.
38.
Thorton, S. I., and Elliot, R. P. (1986). “Resilient modulus—What is it?” Proc., 37th Annual Highway Geology Symp., Helena, Mont., 267–282.
39.
Yoder, E. J., and Witczak, M. W. (1975). Principles of pavement design, 2nd Ed., John Wiley and Sons, Inc., New York, N.Y.
Information & Authors
Information
Published In
Journal of Geotechnical Engineering
Volume 116 • Issue 5 • May 1990
Pages: 774 - 789
Copyright
Copyright © 1990 ASCE.
History
Published online: May 1, 1990
Published in print: May 1990
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.