Cyclic Behavior of Pavement Base Materials
Publication: Journal of Geotechnical Engineering
Volume 111, Issue 1
Abstract
The influence of stress path on the stress‐strain behavior of a Florida sand subject to repetitive moving wheel loads is investigated in the laboratory with conventional traixial equipment. A conventional resilient modulus test with only cyclic varying compressive loads and a moving wheel stress path involving both extension and compressive loads determined from an elastic solution were examined at different initial confining pressures. The tests showed that excursions of applied extension loading followed by compression loading resulted in anisotropic material behavior. This, in turn, influenced both the cyclic permanent strain (rutting) build‐up as well as the resilient (distortion) behavior of the material for initial confining pressures below approximately 40 psi (276 kPa). It was concluded that, in order to model both the distortion and rutting characteristics of a sand, improved constitutive relationships over the simple linear elastic theory are warranted. A bounding surface plasticity model was subsequently developed based upon both the plastic shear dilation and volumetric behavior of the sand. The predicted model response agreed both qualitatively and quantitatively for the tests investigated.
Get full access to this article
View all available purchase options and get full access to this article.
References
1.
Aboim, C. R., and Roth, W. N., “Bounding‐Surface‐Plasticity Theory Applied to Cyclic Loading of Sand,” International Symposium on Numerical Models in Geomechanics, Zurich, Switzerland, 1982.
2.
Boker, C., Field Manual of Soil Engineering, 5th Ed., Michigan Department of State Highway, Lansing, Mich., 1970.
3.
Brabston, W. N., “Investigation of Compaction Criteria for Airport Pavement Subgrade Soils,” Technical Report GL‐81‐U, U.S. Army Engineer Waterways Experiment Station, C.E. Vicksburg, Miss., Oct., 1981.
4.
Brown, S. F., “Repeated Load Testing of a Granular Material,” Journal of the Geotechnical Engineering Division, ASCE, Vol. 100, GT7, 1974, pp. 825–841.
5.
Crawford, J. E., “An Analytical Model for Airfield Pavement Analysis (AFPAV),” Technical Report 71‐70, Air Force Weapons Laboratory, Kirtland Air Force Base, N.M., 1971.
6.
Dafalias, Y. F., “Initial and Induced Anisotropy of Cohesive Soils by Means of a Varying Non‐Associated Flow Rub,” Proceedings, Collogue International du C.N.R.S., No. 319, 1981.
7.
Dafalias, Y. F., “On Cyclic and Anisotropic Plasticity,” thesis presented to the University of California, at Berkeley, Calif., in 1975, in partial fulfillment of the requirements for the degree of Doctor of Engineering.
8.
Dafalias, Y. F. and Herrmann, L. R., “A Bounding Surface Soil Plasticity Model,” International Symposium on Soils Under Cyclic and Transient Loading, University of Swansea, Swansea, U.K., 1980.
9.
Dafalias, Y. F., and Popov, E. P., “A Model of Nonlinearly Hardening Materials for Complex Loading,” Acta Mechanica, Vol. 21, No. 3, 1974, pp. 173–192.
10.
Ko, Y. N., and Scott, R. F., “Deformation of Sand at Failure,” Journal of Soil Mechanics and Foundation Division, ASCE, No. SM4, 1968, pp. 883–898.
11.
Lade, P. V., “The Stress‐Strain and Strength Characteristics of Cohesionless Soils,” thesis presented to the University of California, at Berkeley, Calif., in 1972, in partial fulfillment of the requirements for the degree of Doctor of Engineering.
12.
Lade, P. V., “Elasto‐Plastic Stress‐Strain Theory for Cohesionless Soil with Curved Field Surfaces,” International Journal of Solids and Structures, Vol. 13, 1977.
13.
Malvern, L. E., Introduction to the Mechanics of a Continuous Medium, Prentice‐Hall, New Jersey, 1979.
14.
Monismith, C. L., and Finn, F. N., “Flexible Pavement Design: State of the Art,” Journal of the Transportation Engineering Division, ASCE, No. TE1, Jan., 1977, pp. 1–53.
15.
Nair, K., and Chang, C. Y., “Flexible Pavement Design and Management Materials Characterization,” National Cooperative Highway Research Program, Report No. 140, Washington, D.C., 1973.
16.
Prager, W., “Recent Developments in the Mathematical Theory of Plasticity,” Journal of Applied Physics, Vol. 20, 1949.
17.
Seed, H. B., Chan, C. K., and Lee, C. E., “Resilience Characteristics of Subgrade Soils and Their Relation to Fatigue Failures in Asphalt Pavements,” Proceedings, 1st International Conference on Structural Design of Asphalt Pavements, Ann Arbor, Mich., 1962.
18.
Townsend, F. C., and Chisolm, E. E., “Plastic and Resilient Properties of Vicksburg Buckshot Clay Under Repetitive Loading,” Technical Report S‐76‐16, U.S. Army Engineer Waterways Experiment Station, CE, Vicksburg, Miss., Nov., 1976.
19.
Yong, R. N., and Oster, J. C., “On the Analysis of Soil Deformation Under a Moving Rigid Wheel,” Proceedings, 2nd International Conference I.S.T.V.S., Quebec, 1962, pp. 339–352.
Information & Authors
Information
Published In
Copyright
Copyright © 1985 ASCE.
History
Published online: Jan 1, 1985
Published in print: Jan 1985
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.