Asymptotic-Numerical Method to Analyze the Postbuckling Behavior, Imperfection-Sensitivity, and Mode Interaction in Frames
Publication: Journal of Engineering Mechanics
Volume 131, Issue 6
Abstract
The paper presents the formulation and illustrates the application of an asymptotic-numerical (semianalytical) method to analyze the geometrically nonlinear behavior of plane frames. The method adopts an “internally constrained” beam model and involves two distinct procedures: (1) an asymptotic analysis, which employs a perturbation technique to establish a sequence of systems of equilibrium differential equations and boundary conditions, and (2) the successive numerical solution of such systems, by means of the finite element method. This method can be applied to investigate the behavior of frames with arbitrarily complex configurations (member number and orientation) and leads to the determination of analytical expressions which provide: (1) the initial postbuckling behavior of perfect frames and (2) the nonlinear equilibrium paths of frames containing small initial imperfections or acted by primary bending moments, including the influence of eventual buckling mode interaction phenomena. In order to validate and illustrate the application and potential of the proposed method, several numerical results are presented, concerning (1) four validation examples (Euler column and three simple frames—two or three members), for which there exist some (perfect frame) analytical and numerical asymptotic results reported in the literature; (2) a single-bay pitched-roof frame with partially restrained column bases; and (3) a three-bay frame with two leaning columns. These results comprise (1) the initial postbuckling behavior of perfect frames (individual and coupled buckling modes) and (2) geometrically nonlinear equilibrium paths describing the behavior of frames containing initial geometrical imperfections or primary bending moments. In the latter case, most of the semianalytical results are compared with fully numerical values, yielded by finite element analyses performed in the commercial code ABAQUS.
Get full access to this article
View all available purchase options and get full access to this article.
References
Appeltauer, J., and Kollár, L. (1999). “Buckling of frames.” Structural stability in engineering practice, L. Kollár, ed., E & FN Spon, London, 129–186.
Azrar, L., Cochelin, B., Damil, N., and Potier-Ferry, M. (1993). “An asymptotic-numerical method to compute the postbuckling behaviour of elastic plates and shells.” Int. J. Numer. Methods Eng., 36(8), 1251–1277.
Besseling, J. F. (1977). “Derivatives of deformation parameters for bar elements and their use in buckling and postbuckling analysis.” Comput. Methods Appl. Mech. Eng., 12, 97–124.
Budiansky, B. (1974). “Theory of buckling and post-buckling behavior of elastic structures.” Advances in applied mechanics, C.-S. Yih, ed., Vol. 14, Academic, New York, 1–65.
Casciaro, R., Salerno, G., and Lanzo, A. D. (1992). “Finite element asymptotic analysis of slender elastic structures: a simple approach.” Int. J. Numer. Methods Eng., 35(7), 1397–1426.
Damil, N., and Potier-Ferry, M. (1990). “A new method to compute perturbed bifurcations: application to the buckling of imperfect elastic structures.” Int. J. Eng. Sci., 28(9), 943–957.
Davies, J. M. (1991). “The stability of multi-bay portal frames.” Struct. Eng., 69(12), 223–229.
Hangai, Y., and Kawamata, S. (1972). “Perturbation method in the analysis of geometrically nonlinear and stability problems.” Advances in computational methods in structural mechanics and design, J. T. Oden, ed., UAH Press, Univ. of Alabama, Tuscaloosa, Ala., 473–492.
Hibbit, Karlsson, and Sorensen Inc. (HKS). (2002) ABAQUS standard, Version 6.3-1, HKS, Providence, R.I.
Horne, M. R. (1977). “Safeguards against frame instability in the plastic design of single-storey pitched-roof frames.” Proc., Conf. on the Behaviour of Slender Structures, The City Univ., London, v.1–v.22.
Khamlichi, A., Elbakkali, L., and Limam, A. (2001). “Postbuckling of elastic beams considering higher order strain terms.” J. Eng. Mech., 127(4), 372–378.
Koiter, W. T. (1945). “Over der stabiliteit van het elastische evenwicht.” PhD thesis, Delft Univ., Delft, The Netherlands; (1967), NASA Rep. No. TT-F-10833, NASA, Washington, D.C.
Koiter, W. T. (1967). “Postbuckling analysis of a simple two-bar frame.” Recent progress in applied mechanics—The folke odquist volume, Almquist and Wiksell, Stockholm, Sweden, 337–354.
Kounadis, A. N., Giri, J., and Simitses, G. J. (1977). “Nonlinear stability analysis of an eccentrically loaded two-bar frame.” J. Appl. Mech., 44(4), 701–706.
Magnusson, A. (2000). “Treatment of bifurcation points with asymptotic expansion.” Comput. Struct., 77(5), 475–484.
Olesen, J. F., and Byskov, E. (1982). “Accurate determination of asymptotic postbuckling stresses by the finite element method.” Comput. Struct., 15(2), 157–163.
Pignataro, M. (1998). “Stability, bifurcation and post-buckling analysis.” Coupled instabilities in metal structures: Theoretical and design aspects, J. Rondal, ed., CISM Course 379, Springer, Wien, Germany, 29–83.
Pignataro, M., Di Carlo, A., and Rizzi, N. (1985). ‘Discussion on “Accurate determination of asymptotic postbuckling stresses by the finite element method” by J. F. Olesen and E. Byskov,’ Comput. Struct., 21(5), 933–935.
Pignataro, M., Rizzi, N., and Di Carlo, A. (1980). “Symmetric bifurcation of plane frames through a modified energy potential.” J. Struct. Mech., 8(3), 237–255.
Pignataro, M., Rizzi, N., and Luongo, A. (1991). “Stability, bifurcation and postcritical behaviour of elastic structures.” Developments in civil engineering, Vol. 39, Elsevier Science, Amsterdam, The Netherlands.
Poulsen, P. N., and Damkilde, L. (1998). “Direct determination of asymptotic structural postbuckling behaviour by the finite element method.” Int. J. Numer. Methods Eng., 42(4), 685–702.
Rehfield, L. W. (1973). “Advanced elastic postbuckling analysis by a perturbation procedure.” AIAA J., 11(5), 759–760.
Rizzi, N., Di Carlo, A., and Pignataro, M. (1980). “A parametric postbuckling analysis of an asymmetric two-bar frame.” J. Struct. Mech., 8(4), 435–448.
Roorda, J. (1965). “Stability of structures with small imperfections.” J. Eng. Mech. Div., 91(EM1), 87–106.
Roorda, J., and Chilver, A. H. (1970). “Frame buckling: an illustration of the perturbation technique.” Int. J. Non-Linear Mech., 5, 235–246.
Schafer, B. W., and Graham, L. (2002). “FEM implementation of Koiter’s asymptotic post-buckling prediction with application to stochastic post-buckling analysis.” Abstracts of 15th ASCE Engineering Mechanics Conf., New York, (CD-ROM), 136–136.
Silvestre, N., and Camotim, D. (2002). “Post-buckling behavior, imperfection-sensitivity and mode interaction in pitched-roof steel frames.” Proc., of SSRC 2002 Annual Stability Conf., Seattle, 139–162.
Thompson, J., and Hunt, G., (1973). A general theory of elastic stability, Wiley, London.
Waterloo Maple Incorporation (WMI). (2001). Maple 7, Waterloo, Canada.
Wu, B. (1999). “Buckling mode interaction in fixed-end column with central brace.” J. Eng. Mech., 125(3), 316–322.
Zhang, J., and Ellingwood, B. (1995). “Effects of uncertain material properties on structural stability.” J. Struct. Eng., 121(4), 705–716.
Information & Authors
Information
Published In
Copyright
© 2005 ASCE.
History
Received: May 25, 2003
Accepted: Jan 12, 2005
Published online: Jun 1, 2005
Published in print: Jun 2005
Notes
Note. Associate Editor: Hayder A. Rasheed
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.