Fatigue Fracture of Concrete Subjected to Biaxial Stresses in the Tensile Region
Publication: Journal of Engineering Mechanics
Volume 128, Issue 6
Abstract
In this paper cyclic quasi-static and constant amplitude fatigue responses of concrete subjected tensile compression–tension biaxial stress are presented. In the tensile region within the biaxial stress space, magnitude of the principal tensile stress is larger than or equal to that of the principal compressive stress. An experimental program consisted of subjecting hollow, cylindrical concrete specimens to torsional loading. Failure in both quasi-static and fatigue is due to crack propagation. It is shown that the crack propagation resulting from the biaxial loading can be predicted using Mode I fracture parameters. The fatigue crack growth is observed to be a two-phase process: an acceleration stage that follows a deceleration stage. The crack length where the rate of crack growth changes from deceleration to acceleration is shown to be equal to the crack length at the quasi-static peak load. Analytical expressions for crack growth in the deceleration and acceleration stages are developed in terms of the mechanisms that influence quasi-static crack growth. The model parameters obtained from uniaxial fatigue tests are shown to be sufficient for predicting the biaxial fatigue response. Finally, a fracture-based fatigue-failure criterion is proposed, wherein the fatigue failure can be predicted using the critical Mode I stress intensity factor.
Get full access to this article
View all available purchase options and get full access to this article.
References
ACI Committee 215. (1982). Fatigue of concrete structures, S. P. Shah, ed., American Concrete Institute, Detroit.
Aglan, H. A., and Bayomy, F. A.(1998). “Innovative approach to fatigue crack propagation in concrete pavements.” Transp. Res. Rec., 1568, 17–23.
Ballarini, R., Shah, S. P., and Keer, L. M.(1984). “Crack growth in cement-based composites.” Eng. Fract. Mech., 20(3), 433–445.
Baluch, M. H., Qureshy, A. B., and Azad, A. K. (1987). “Fatigue crack propagation in plain concrete.” Proc., SEM/RILEM Int. Conf. on Fracture of Concrete and Rock, Houston, 80–87.
Bazant, Z. P., and Planas, J. (1998). Fracture and size-effect in concrete and quasi-brittle materials, CRC, Boca Raton, Fla.
Bazant, Z. P., and Schell, W. F.(1993). “Fatigue fracture of high-strength concrete and size effect.” ACI Mater. J., 90(5), 472–478.
Bazant, Z. P., and Xu, K.(1991). “Size effect in fatigue fracture of concrete.” ACI Mater. J., 88(4), 390–399.
Lemaitre, J., and Chaboche, J.-L. (1990). Mechanics of solid materials, Cambridge University Press, Cambridge, England.
Nelson, E. L., Carrasquillo, R. L., and Fowler, D. W. (1988). “Behavior and failure of high-strength concrete subjected to biaxial cyclic compression loading.” ACI Mater. J., 248–253.
Oh, B. H.(1991). “Fatigue-life distributions of concrete for various stress levels.” ACI Mater. J., 88(2), 122–128.
Ouyang, C., and Shah, S. P.(1991). “Geometry dependent R-curve for quasi-brittle materials.” J. Am. Ceram. Soc., 74(11), 2831–2836.
Paskova, T., and Meyer, C.(1994). “Optimum number of specimens for low-cycle fatigue tests of concrete.” J. Struct. Eng., 120(7), 2242–2247.
Perdikaris, P. C., and Calomino, A. M. (1987). “Kinetics of crack growth in plain concrete.” Proc., SEM/RILEM Int. Conf. on Fracture of Concrete and Rock, Houston, 64–69.
RILEM Committee 36-RDL (1984). “Long term random dynamic loading of concrete structures.” RILEM Mater. Struct., 17(9), 1–28.
Shah, S. P., Swartz, S. E., and Ouyang, C. (1995). Fracture mechanics of concrete, Wiley, New York.
Su, E. C. M., and Hsu, T. T. C. (1988). “Biaxial compression fatigue and discontinuity of concrete.” ACI Mater. J., 178–188.
Subramaniam, K. V. (1999). “Fatigue of concrete subjected to biaxial loading in the tension region.” PhD dissertation, Northwestern Univ.
Subramaniam, K. V., O’Neil, E., Popovics, J. S., and Shah, S. P.(2000). “Crack propagation in flexural fatigue of concrete.” J. Eng. Mech. Div., Am. Soc. Civ. Eng. 126(9), 891–898.
Subramaniam, K. V., Popovics, J. S., and Shah, S. P.(1998). “Testing concrete in torsion: instability analysis and experiments.” J. Eng. Mech. Div., Am. Soc. Civ. Eng. 124(11), 1258–1268.
Subramaniam, K. V., Popovics, J. S., and Shah, S. P. (1999a). “Fatigue behavior of concrete subjected to biaxial stresses.” Proc., FAA Airport Technology Transfer Conf., Atlantic City, N.J.
Subramaniam, K. V., Popovics, J. S., and Shah, S. P.(1999b). “Fatigue response of concrete subjected to biaxial fatigue in the compression–tension region.” ACI Mater. J., 96(6), 663–669.
Yin, W., and Hsu, T. T. C. (1995). “Fatigue behavior of steel fiber reinforced concrete in uniaxial and biaxial compression.” ACI Mater. J., 71–81.
Information & Authors
Information
Published In
Copyright
Copyright © 2002 American Society of Civil Engineers.
History
Received: Feb 6, 2001
Accepted: Jun 15, 2001
Published online: May 15, 2002
Published in print: Jun 2002
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.