Discrete-Element Model for Buckling Analysis of Thin Ring Confined Within Rigid Boundary
Publication: Journal of Engineering Mechanics
Volume 121, Issue 1
Abstract
An elastic ring in rigid confinement may buckle inward when pressure is applied by a uniform inward movement of the confining rigid frame, particularly when a defect or initial inward deflection is present. As a result, the buckled portion of the ring becomes free of boundary pressure. This problem is known as shrink buckling, contact buckling, or one-way buckling. This problem was investigated by using three different approaches: the discrete method, the finite-element method, and an experimental method. A discrete-element model for the stability of thin rings confined within rigid boundaries was first developed, and then the critical buckling condition was derived from equilibrium equations. The frictional effect at the interface between the ring and the boundary was then taken into consideration. A finite-element model was developed and ANSYS 4.4 was used to carry out the calculations. The results from the discrete model were compared with the results from the finite-element analysis, and finally were verified by experimental results.
Get full access to this article
View all available purchase options and get full access to this article.
References
1.
Bucciarelli, L. L. Jr., and Pian, T. H. H. (1967). “Effect of initial imperfections on the instability of a ring confined in an imperfect rigid boundary.” ASME Trans., J. Appl. Mech., 34(4), 979–984.
2.
Burgess, I. W.(1971a). “On the equilibrium and stability of discrete one-way structural systems.”Int. J. Solids and Struct., 7(7), 667–683.
3.
Burgess, I. W.(1971b). “The buckling of a radially constrained imperfect circular ring.”International Journal of Mechanical Science, Oxford, England, 13(9), 741–753.
4.
Chan, H. C., and McMinn, S. J.(1966). “The stability of uniformly compressed ring surrounded by a rigid circular surface.”International Journal of Mechanical Science, Pergamon Press, Inc., Oxford, England, 8(6), 433–442.
5.
Chan, H. C., and McMinn, S. J.(1966a). “The stability of the steel liner of a prestressed concrete pressure vessel.”Nuclear Engrg. and Design, 3(1), 66–73.
6.
Chicurel, R. (1968). “Shrink buckling of thin circular rings,” ASME Trans., J. Appl. Mech., 35(3), 608–610.
7.
El-Bayoumy, L. (1972). “Buckling of a circular elastic ring confined to a uniformly contracting circular boundary.” ASME Trans., J. Appl. Mech., 39(3), 758–766.
8.
El Naschie, M. S. (1990). Stress, stability and chaos in structural engineering: an energy approach . McGraw-Hill Book Co., Inc., New York, N.Y.
9.
Hsu, P. T., Elkon, J., and Pian, T. H. H. (1964). “Note on the instability of circular rings confined to a rigid boundary.” ASME Trans., J. Appl. Mech., 31(3), 559–562.
10.
Liszka, T., and Trojnacki, A. (1978). “Elastic stability of a force-fit connection of two thin rings. Archiwum Budowy Maszyn, Zeszyt, 25(3), 535–548.
11.
Lo, H., Bogdanoff, J. E., Goldberg, J. L., and Crawford, R. F. (1962). “A buckling problem of a circular ring.”Proc., 4th U.S. Nat. Congr. of Appl. Mech., ASME, New York, N.Y., 691–695.
12.
Oberg, E., Jones, F. D., and Horton, H. L. (1980). Machinery's handbook . Industrial Press, Inc., New York, N.Y.
13.
Simitses, G. J. (1976). An introduction to the elastic stability of structures . Prentice-Hall, Inc., Englewood Cliffs, N.J.
14.
Soong, T. C., and Choi, I. (1985). “Buckling of an elastic elliptical ring inside a rigid boundary.” ASME Trans., J. Appl. Mech., 52(6), 523–528.
15.
Sun, C., Shaw, W. J. D., Vinogradov, A. M. (1994). “Buckling of circular rings confined within rigid boundaries.”Proc., 17th Annu. Energy-Source Technol. Conf. and Exhibition, T. J. Kozik, ed., ASME, New York, N.Y., Vol. 62, 219–224.
16.
Timoshenko, S. P., and Gere, J. M. (1961). Theory of elastic stability, 2nd Ed., McGraw-Hill Book Co., Inc., New York, N.Y.
Information & Authors
Information
Published In
Copyright
Copyright © 1995 American Society of Civil Engineers.
History
Published online: Jan 1, 1995
Published in print: Jan 1995
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.