Model Sensitivity Analysis for Biotrickling Filter Treatment of Graywater Simulant and Waste Gas. II
Publication: Journal of Environmental Engineering
Volume 134, Issue 10
Abstract
A detailed sensitivity analysis was conducted to identify key parameters for a biotrickling filter simultaneously treating graywater and waste gas containing ammonia and hydrogen sulfide contaminants. Sampling-based approaches were applied to quantitatively assess the sensitivity of both design and intrinsic model parameters. Specifically, the sensitivity of contaminant removal rates under system conditions was investigated. Results suggested that contaminant removal rates can be substantially improved by increasing the fraction of wetted area in a biotrickling filter. Although recirculation flow rate is insensitive when considering liquid contaminant removal, increasing this parameter improves gas removal efficiency and also increases wetted area within the biotrickling filter. Reactor performance can also be improved by increasing gas and liquid residence times. Contaminant diffusivity through the biofilm is an important parameter and should be accurately assessed. This study differentiated key from insignificant biotrickling filter reactor design parameters for the biotrickling filter and provides guidance for similar research applications.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
This research was supported by a grant from NASA through the ALS NSCORT Center, headquartered at Purdue Univ. The first writer was funded by a fellowship from the American Association of University Women.
References
Alonso, C., Zhu, X., Suidan, M. T., Kim, B. R., and Kim, B. J. (2000). “Parameter estimation in biofilter systems.” Environ. Sci. Technol., 34(11), 2318–2323.
Baltzis, B. C., Mpanias, C. J., and Bhattacharaya, S. (2001). “Modeling the removal of VOC mixtures in biotrickling filters.” Biotechnol. Bioeng., 72(4), 389–401.
Box, G. E. P., and Draper, N. R. (1987). Emperical model-building and response surfaces, Wiley, New York.
Burton, S. A. Q., and Prosser, J. I. (2001). “Autotrophic ammonia oxidation at low pH through urea hydrolysis.” Appl. Environ. Microbiol., 67(7), 2952–2957.
Cox, H. H. J., Deshusses, M. A., Converse, B. M., Schroeder, E. D., and Iranpour, R. (2002). “Odor and volatile organic compound treatment by biotrickling filters: Pilot-scale studies at hyperion treatment plant.” Water Environ. Res., 74(5), 557–563.
Cukier, R. I., Levine, H. B., and Schuler, K. E. (1978). “Nonlinear sensitivity analysis of multiparamter model systems.” J. Comput. Phys., 26(1), 1–42.
Daniel, C. (1973). “One-at-a-time plans.” J. Am. Stat. Assoc., 68(342), 353–360.
De Beer, D., Stoodley, P., and Lewandowski, Z. (1996). “Liquid flow and mass transport in heterogeneous biofilms.” Water Res., 30(11), 2761–2765.
Devinny, J. S., and Ramesh, J. (2005). “A phenomenolgical review of biofilter models.” Comput. Methods Appl. Mech. Eng., 113(2–3), 187–196.
Diks, R. M. M., and Ottengraf, P. P. (1991). “Verification studies of a simplified model for the removal of dichloromethane from waste gases using a biological trickling filter.” Bioprocess Eng., 6(4), 93–99.
Gabriel, D., and Deshusses, M. A. (2003). “Performance of a full-scale biotrickling filter treating at a gas contact time of .” Environ. Prog., 22(2), 111–118.
Jin, Y., Veiga, M. C., and Kennes, C. (2005). “Effects of pH, , and flow pattern on the autotrophic degradation of hydrogen sulfide in a biotrickling filter.” Biotechnol. Bioeng., 92(4), 462–471.
Kim, S., and Deshusses, M. A. (2003). “Development and experimental validation of a conceptual model for biotrickling filtration of .” Environ. Prog., 22(2), 119–128.
Krumins, V., Line, M., and Wheaton, F. (2000). “Fluid velocity distribution in nitrifying trickling filters: Mathematical model and NMR calibration.” Water Res., 34(8), 2337–2345.
Li, H., Crittenden, J. C., Mihelcic, J. R., and Hannu, H. (2002). “Optimization of biofiltration for odor control: Model development and parameter sensitivity.” Water Environ. Res., 74(1), 5–16.
Logan, B. E., Hermanowicz, S. W., and Parker, D. S. (1987a). “Engineering implications of a new trickling filter model.” J. Water Pollut. Control Fed., 59(12), 1017–1028.
Logan, B. E., Hermanowicz, S. W., and Parker, D. S. (1987b). “A fundamental model for trickling filter process design.” J. Water Pollut. Control Fed., 59(12), 1029–1042.
Lu, C., Chang, K., and Hsu, S. (2004). “A model for treating isopropyl alcohol and acetone mixtures in a trickle-bed air biofilter.” Process Biochem. (Oxford, U.K.), 39(12), 1849–1858.
McKay, M. D., Beckman, R. J., and Conover, W. J. (1979). “A comparison of three methods of selecting values of input variables in the analysis of output from a computer code.” Technometrics, 21(2), 239–245.
Morris, M. D. (1991). “Factorial sampling plans for preliminary computational experiments.” Technometrics, 33(2), 161–174.
Onda, K., Takeuchi, H., and Okumoto, Y. (1968). “Mass transfer coefficients between gas and liquid phases in packed columns.” J. Chem. Eng. Jpn., 1(1), 56–62.
Picioreanu, C., van Loosdrecht, M. C. M., and Heijnen, J. J. (2000). “Effect of diffusive and convective substrate transport on biofilm structure formation: A two-dimensional modelling study.” Biotechnol. Bioeng., 69(5), 504–515.
Rene, E., Maliyekkal, S., Shihabudeen, M., Philip, L., and Swaminathan, T. (2006). “Back-propogation neural network for performance propagation neural network for performance predicition in trickling bed air biofilter.” Int. J. Environ. Pollut., 28(3–4), 382–400.
Saltelli, A., and Bolado, R. (1998). “An alternative way to compute Fourier amplitude sensitivity test (FAST).” Comput. Stat. Data Anal., 26(4), 445–460.
Saltelli, A., Chan, K., and Scott, E. M. (2000). Sensitivity analysis, Wiley, New York.
Saltelli, A., Tarantola, S., Campolongo, F., and Ratto, M. (2004). Sensitivity Analysis in Practice—A guide to assessing scientific models, Wiley, New York.
Sharvelle, S., Arabi, M., Banks, M. K., and Mannering, F. (2008a). “Model development for biotrickling filter treatment of graywater simulant and waste gas. I.” J. Environ. Eng., 134(10), 813–825.
Sharvelle, S., McLamore, E., and Banks, K. (2008b). “Hydrodynamic characteristics in biotrickling filters as affected by packing material and hydraulic loading rate.” J. Environ. Eng., 134(5), 346–352.
Sharvelle, S., McLamore, E., Clark, S., and Banks, M. K. (2008c). “Characterization of effluent from biological trickling filters treating graywater in advanced life support systems.” Habitation, 11(3), 95–104.
Siegrist, H., and Gujer, W. (1985). “Mass transfer mechanisms in a heterotrophic biofilm.” Water Res., 19(11), 1369–1378.
Spear, R. C., Grieb, T. M., and Shang, N. (1994). “Parameter uncertainty and interaction in complex environmental models.” Water Resour. Res., 30(11), 3159–3169.
Spear, R. C., and Hornberger, G. M. (1980), “Eutrophication in peel inlet. II: Identification of critical uncertainty via generalized sensitivity analysis.” Water Res., 14(1), 43–49.
Washington, S. P., Karlaftis, M. G., and Mannering, F. (2003). Statistical and econometric methods for transportation data analysis, Chapman & Hall, New York.
Wik, T., Mattson, A., Hansson, E., and Niklasson, C. (1995). “Nitrification in a tertiary trickling filter at high hyraulic loads—Pilot plant operation and mathematical modeling.” Water Sci. Technol., 32(8), 185–192.
Information & Authors
Information
Published In
Copyright
© 2008 ASCE.
History
Received: Nov 9, 2006
Accepted: Nov 1, 2007
Published online: Oct 1, 2008
Published in print: Oct 2008
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.