Characterization of Clay Particle Surfaces for Contaminant Sorption in Soil Barriers Using Flow Microcalorimetry
Publication: Journal of Environmental Engineering
Volume 130, Issue 8
Abstract
Clays such as kaolinite and bentonite are widely used in various industries as sorbents. The sorptive characteristics of clays are exploited when they are used in contaminant barrier systems. To use clays effectively, their surface characteristics need to be known; especially, when they are used for contaminant sorption. Available surface area of clay minerals and the characteristics that depend on it are very sensitive to environmental changes such as those that can be induced by changes in the composition of pore fluid. Flow microcalorimetry with a down-stream concentration was used to determine the heats and amounts of adsorption of acids and bases on the clays. Test results presented herein revealed that both kaolinite and bentonite exhibit significantly different adsorption isotherms and heat of wetting under high pH and low pH conditions. Kaolinite has the capacity to adsorb both acidic and basic molecules almost equally. However, it has a tendency to adsorb more base than acid because of its stronger complexation capacity with acids than with bases. On the other hand, bentonite has a tendency to adsorb more acidic than basic molecules per gram. These results also indicate that both kaolinite and bentonite have different heats of wetting characteristics. As the concentrations of the acids and bases increase, the heat of wetting of kaolinite decreases while that of bentonite increases.
Get full access to this article
View all available purchase options and get full access to this article.
References
Chassin, P., Jounay, C., and Quiquampoix, H.(1986). “Measurement of the surface free energy of calcium–montmorillonite.” Clay Miner., 21, 899–907.
Chibowski, E., and Staszczuk, P.(1988). “Determination of surface free energy of kaolinite.” Clays Clay Miner., 36, 455–461.
Costanzo, P. M., Giese, R. F., and van Oss, J.(1990). “Determination of the acid-base characterization of clay mineral surfaces by contact angle measurements: implication for the adsorption of the organic solutes from aqueous media.” J. Adhes. Sci. Technol., 4, 267–275.
Drago, R. S., Vogel, G. C., and Needham, T. E.(1971). “A four-parameter equation for predicting enhalphies of adduct formation.” J. Am. Chem. Soc., 93, 6014–6026.
Fowkes, F. M., Jones, K. L., Li, G., and Lloyd, T. B.(1989). “Surface chemistry of coal by flow microclorimetry.” J. Energy Fuels,3, 367–378.
Kaya, A. (1996). “The effects of pore fluid contamination on selected physico-chemical parameters of fine grained soils.” PhD dissertation, Lehigh Univ., Bethlehem, Pa.
Lloyd, T. B.(1994). “Experimental procedures to characterize acid–base and dispersion force contributions to solid wettability.” Colloids Surf., A, 93, 25–37.
Mauguis, D. J.(1985). “Subcritical crack growth, surface energy, fracture roughness, atic-slip, and embitterment.” J. Mater. Sci., 20, 3041–3062.
Norris, J., Giese, R. F., van Oss, C. J., and Costanzo, P. M.(1992). “Hydrophobic nature of organo-clays as a Lewis acid/base phenomenon.” Clays Clay Miner., 4, 327–334.
Parks, G. A.(1984). “Surface and interfacial free energies of quartz.” J. Geophys. Res., 89, 3997–4008.
Saada, A., Papier, E., Balard, H., and Siffert, B.(1995). “Determination of the surface properties of illite and kaolinite by inverse gas chromatography.” J. Colloid Interface Sci., 175, 212–218.
Stumm, W. (1992). Chemistry of the solid–water interface, Wiley, New York.
Westall, J. C. (1987). “Adsorption mechanisms in aquatic surface chemistry,” Aquatic surface chemistry, W. Stumm, ed., Wiley, New York, 3–32.
Information & Authors
Information
Published In
Copyright
Copyright © 2004 American Society of Civil Engineers.
History
Received: Jun 17, 2003
Accepted: Jun 18, 2003
Published online: Jul 15, 2004
Published in print: Aug 2004
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.