Optimal Wasteload Allocation Procedure for Achieving Dissolved Oxygen Water Quality Objectives. I: Sensitivity Analysis
This article has a reply.
VIEW THE REPLYPublication: Journal of Environmental Engineering
Volume 130, Issue 11
Abstract
A method is presented to compute sensitivities of in-stream dissolved oxygen (DO) with respect to perturbations in the load vector and the reaction coefficients that make up the eutrophication cycle. It is shown that the direct sensitivity method, i.e., the repetitive solution of the direct problem, produces the desired information, however at a large computational cost. The utilization of the adjoint sensitivity method proves to be a much more efficient way to compute these sensitivities as large subsets of the sensitivity information domain can be easily extracted with just a few runs. It is found that for the given problem setup, in-stream DO is most sensitive to ammonia, effluent DO, algae, and carbonaceous biochemical oxygen demand (CBOD) loads. Additionally, the computed sensitivities vary considerably in their general trend over the simulation time. Sensitivities also are computed with respect to the reaction coefficients (26 total) that govern the interdependency of all constituents. Sediment oxygen demand proves to be the coefficient with the highest influence that is three orders of magnitude higher than the next set of coefficients comprised of reaeration, CBOD degradation, nitrification, and denitrification. All other coefficients have a negligible influence on DO concentrations. Computations are carried out using a two-dimensional model formulation applied to a long rectangular channel with varying width and slope and periodic but unsteady flow conditions.
Get full access to this article
View all available purchase options and get full access to this article.
References
1.
Chapra, S.C. ( 1997). Surface water quality modeling, McGraw-Hill, New York.
2.
Chertok, D. L., and Lardner, R. W., (1996). “Variational data assimilation for a nonlinear hydraulic model.” Appl. Math. Model., 20, 675–682.
3.
Environmental Protection Agency (EPA). (2001). “Chesapeake Bay Program.” 〈http://www.epa.gov/r3chespk/index.htm〉.
4.
Environmental Protection Agency (EPA). (2002). “Water quality analysis simulation program (WASP6).” 〈http://www.epa.gov/region4/water/tmdl/tools/wasp.htm〉.
5.
Fischer, H.B., List, E.J., Koh, R.C., Imberger, N.H., and Brooks, N.H. ( 1979). Mixing in inland and coastal waters, Academic, New York.
6.
Katopodes, N. D. (1984). “Dissipative Galerkin scheme for open-channel flow.” J. Hydraul. Eng., 110(4), 450–466.
7.
Katopodes, N.D. ( 1987). “Finite element model for hydrodynamics and mass transport in the upper Potomac estuary.” Report Prepared for the Metropolitan Washington Council of Governments.
8.
Liggett, J. A., and Chen, L.-C. (1994). “Inverse transient analysis in pipe networks.” J. Hydraul. Eng., 120(8).
9.
Lung, W.-S., and Sobeck, R. G. (1999). “Renewed use of BOD/DO models in water quality management.” J. Water Resour. Plan. Manage., 125(4), 222–227.
10.
Marchuk, G.I. ( 1995). Adjoint equations and analysis of complex systems, Kluwer, Dordrecht.
11.
Neupauer, R. M., and Wilson, J. L. (2001). “Adjoint-derived location and travel time probabilities for a multidimensional groundwater system.” Water Resour. Res. 37(6), 1657–1668.
12.
Odd, N. ( 1981). “The predictive ability of one-dimensional estuary models.” Transport Models for Inland and Coastal Waters, H. B. Fischer, ed., 39–62.
13.
Piasecki, M. (1998). “A numerical model for the transport of radionuclides incorporating cohesive/noncohesive sediments.” J. Marine Environ. Eng., 4, 331–365.
14.
Piasecki, M., and Katopodes, N. D. (1997). “Control of contaminant releases in rivers. I: Adjoint sensitivity analysis.” J. Hydraul. Eng., 123(6), 486–492.
15.
Piasecki, M., and Sanders, B. F. (2002). “Optimization of multiple freshwater diversions in well-mixed estuaries.” J. Water Resour. Plan. Manage., 128(1), 74–84.
16.
Sanders, B. F., and Piasecki, M. (2002). “Mitigation of salinity intrusion in well-mixed estuaries by optimization of freshwater diversion rates.” J. Hydraul. Eng., 128(1), 64–77.
17.
Schnoor, J.L. ( 1996). Environmental modeling fate and transport of pollutants in water, air, and soil, Wiley, New York.
18.
Shen, J., and Kuo, A. Y. (1996). “Inverse estimation of parameters for an estuarine eutrophication model.” J. Environ. Eng., 122(11), 1031–1040.
19.
Shen, J., and Kuo, A. Y. (1998). “Application of inverse method to calibrate estuarine eutrophication model.” J. Environ. Eng., 124(5), 409–418.
20.
Sun, N.-Z., and Yeh, W. W.-G. (1990). “Coupled inverse problems in groundwater modeling. I: Sensitivity analysis and parameter identification.” Water Resour. Res., 26(10), 2507–2525.
21.
Thomann, R.T., and Mueller, J.A. ( 1987). Principles of surface water quality modeling and control, Harper & Row, New York.
Information & Authors
Information
Published In
Copyright
Copyright © 2004 ASCE.
History
Published online: Nov 1, 2004
Published in print: Nov 2004
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.