Boundary Conditions for Modeling Transport in Vertical Barriers
Publication: Journal of Environmental Engineering
Volume 124, Issue 11
Abstract
One-dimensional advective-dispersive-reactive models are often used to simulate the performance of vertical subsurface barriers. However, a review of the literature reveals a lack of consistency in the treatment of boundary conditions (BCs), particularly for field applications. Commonly used simplified BCs are shown to result in nonconservative predictions of contaminant flux when applied to the low flow scenarios expected in the field. Consequently, the constant concentration entrance BC and zero concentration exit BC are recommended as the starting point for the design of slurry walls. Generalized “mixing zone” conditions are also proposed and evaluated for modeling both field installations and laboratory columns. For field scenarios, the exit mixing zone provides flexibility in adjusting between the limiting cases of zero concentration and semiinfinite BCs. For laboratory columns, mixing zones may be used to represent the influence of porous materials placed at the column ends to promote lateral distribution of the permeating fluid.
Get full access to this article
View all available purchase options and get full access to this article.
References
1.
Acar, Y. B., and Haider, L.(1990). “Transport of low-concentration contaminants in saturated earthen barriers.”J. Geotech. Engrg., ASCE, 116(7), 1031–1052.
2.
Bear, J. (1972). Dynamics of fluids in porous media. Elsevier, New York.
3.
Bierck, B. R., and Chang, W. C. (1994). “Contaminant transport through soil-bentonite slurry walls: attenuation by activated carbon.”Proc., Water Envir. Specialty Conf. on Innovative Solutions for Contaminated Site Mgmt., Miami, Fla., 461–472.
4.
Booker, J. R., and Rowe, R. K.(1987). “One-dimensional advective-dispersive transport into a deep layer having a variable surface concentration.”Int. J. Numer. and Anal. Methods in Geomech., 11(2), 131–142.
5.
Danckwerts, P. V.(1953). “Continuous flow systems: Distributions of residence times.”Chem. Engrg. Sci., 2(1), 1–13.
6.
Evans, J. C., Adams, T. L., and Prince, M. J. (1997). “Metals attenuation in minerally-enhanced slurry walls.”Proc., 1997 Int. Containment Technol. Conf. and Exhibition, St. Petersburg, Fla.
7.
Khandelwal, A., Rabideau, A. J., and Shen, P.(1998). “Analysis of diffusion and sorption of organic solutes in soil/bentonite barrier materials.”Envir. Sci. and Technol., 32(9), 1333–1339.
8.
Mott, H. V., and Weber Jr., W. J.(1992). “Sorption of low molecular weight organic contaminants by fly ash: considerations for the enhancement of cutoff barrier performance.”Envir. Sci. and Technol., 26, 1234–1241.
9.
Owen, S. P.(1925). “The distribution of temperature in a column of liquid flowing from a cold source into a receiver maintained at a higher temperature.”Proc., Phys. Soc. of London, 23, 238–249.
10.
Parker, J. C., and van Genuchten, M. T.(1984). “Flux-averaged and volume-averaged concentrations in continuum approaches to solute transport.”Water Resour. Res., 29(7), 866–872.
11.
Rabideau, A. J. (1996). “Contaminant transport modeling.”Assessment of containment technologies for environmental remediation, R. R. Rumer and J. K. Mitchell, eds., NTIS Publ. PB96-180593 (Published under the auspices of U.S. Department of Energy, U.S. Environmental Protection Agency, and DuPont Company).
12.
Rabideau, A. J., and Khandelwal, A.(1998). “Nonequilibrium sorption in soil/bentonite barriers.”J. Envir. Engrg., ASCE, 124(4), 329–335.
13.
Rowe, R. K., and Booker, J. R.(1985). “1-D pollutant migration in soils of finite depth.”J. Geotech. Engrg., ASCE, 111(4), 479–499.
14.
Shackelford, C. D. (1989). “Diffusion of contaminants through waste containment barriers.”Transp. Res. Rec. 1219, Transportation Research Board, Washington, D.C., 169–182.
15.
Shackelford, C. D. (1993). “Chapter 3: Contaminant transport.”Geotechnical practice for waste disposal, D. E. Daniel, ed., Chapman & Hall, Ltd., London, 33–65.
16.
Shackelford, C. D. (1995). “Analytical models for cumulative mass column testing.”GEOENVIRONMENT 2000, Proc., Spec. Conf. Sponsored by Geotech. Engrg. and Envir. Engrg. Div., ASCE, ASCE, New York.
17.
Shackelford, C. D., and Redmond, P. L.(1995). “Solute breakthrough curves for processed kaolin at low flow rates.”J. Geotech. Engrg., ASCE, 121(1), 17–32.
18.
Smith, J. A., and Jaffe, P. R.(1994). “Benzene transport through landfill liners containing organophilic bentonite.”J. Envir. Engrg., ASCE, 120(6), 1559–1577.
Information & Authors
Information
Published In
Journal of Environmental Engineering
Volume 124 • Issue 11 • November 1998
Pages: 1135 - 1139
Copyright
Copyright © 1998 American Society of Civil Engineers.
History
Published online: Nov 1, 1998
Published in print: Nov 1998
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.