Finite Element Modeling of Single‐Solute Activated‐Carbon Adsorption
Publication: Journal of Environmental Engineering
Volume 118, Issue 2
Abstract
Adsorption onto activated carbon in a fixed‐bed reactor has been found to be an attractive process for removing hazardous organics from water and wastewater. Current fixed‐bed reactor design procedures can be both expensive and time‐consuming. Mathematical process modeling can reduce the cost and time by decreasing laboratory and pilot‐scale experimentation. A model will provide the most utility if it is computationally efficient, and both stable and accurate for a wide variety of system conditions. A global method of orthogonal collocation is currently favored over finite differences. This method, however, results in an unstable algorithm as a result of spatial oscillation. The use of the semidiscrete Galerkin finite‐element method with an asymmetric interpolating function was found to eliminate this spatial oscillation, resulting in a computationally efficient algorithm. A relationship was developed that allows the optimum value of the asymmetric parameter to be determined. This results in a stable algorithm and minimizes numerical dispersion. Additionally, the model predictions were in excellent agreement with experimental results.
Get full access to this article
View all available purchase options and get full access to this article.
References
1.
Bender, S. J., Pinder, G. F., and Gray, W. G. (1975). “A comparison of numerical approximations to the one dimensional convective‐diffusion equation.” Internal Report; Water Resources Program, Princeton University, Princeton, N.J.
2.
Burden, R. L., and Faires, J. D. (1985). Numerical analysis. PWS‐Kent, 3rd Ed., Boston, Mass.
3.
Carey, G. F., and Finlayson, B. A. (1975). “Orthogonal collocation on finite elements.” Chem. Engrg. Sci., 30(May/June), 587–596.
4.
Crittenden, J. C., and Hand, D. W. (1983). “Modeling of adsorption, desorption and displacement in fixed bed adsorbers.” Fundamental of Adsorptions: Proc., Engrg. Found. Conf., Engineering Foundation, Schloss, West Germany, 185–194.
5.
Crittenden, J. C., Luft, P., Hand, D. W., and Friedman, G. (1984). “Predicting the removal of known organic compounds in unknown mixtures of total organic halogens in fixed‐bed adsorbers.” Proc., 1984 Speciality Conf., ASCE, New York, N.Y., 370–373.
6.
Crittenden, J. C., Wong, B. W. C., Thacker, W. E., and Hinrichs, R. L. (1980). “Mathematical model of sequential loading in fixed‐bed adsorbers.” J. WPCF, 52(11), 2780–2795.
7.
Finlayson, B. A. (1980). “Packed bed reactor analysis by orthogonal collocation.” Chem. Engrg. Sci., 26(July), 1081–1091.
8.
Finlayson, B. A. (1980). “Nonlinear analysis in chemical engineering.” McGraw‐Hill Book Co., Inc., New York, N.Y.
9.
Hand, D. W., Crittenden, J. C., and Thacker, W. E. (1983). “User‐oriented batch reactor solutions to homogeneous surface diffusion model.” J. Envir. Engrg., ASCE, 109(1), 82–101.
10.
Hindmarsh, A. C. (1972). “Linear multistep methods for ordinary differential equations: Method formulation, stability, and the methods of Nerderieck and Gear.” UCRL—51186 Rev. 1, Lawrence Livermore Laboratory, University of California, Livermore, Calif.
11.
Huebner, K. H., and Thornton, E. A. (1982). Finite element methods for engineers, 2nd Eds., John Wiley and Sons, New York, N.Y.
12.
Huyakorn, P. S. (1976). “An upwind finite element scheme for improved solution of the convection‐diffusion equation.” Res. Report Number 76‐WR. 2, Princeton University, Princeton, N.J.
13.
Huyakorn, P. S. (1977). “Solution of steady state convective transport equation using an upwind finite element scheme.” Appl. Math. Modeling, 1(Mar.), 187–195.
14.
Lapidus, L., and Pinder, G. F. (1982). Numerical solution of partial differential equations in science and engineering. John Wiley and Sons, New York, N.Y.
15.
Lee, M. C., Crittenden, J. C., Snoeyink, V. L., and Ari, M. (1983). “Design of carbon beds to remove humic substances.” J. Envir. Engrg., 109(3), 631–645.
16.
Lee, M. C., Snoeyink, V. L., and Crittenden, J. C. (1981). “Activated carbon adsorption of humic substances.” J. AWWA, 8(Aug.), 440–446.
17.
Liang, S. (1984). “Mathematical modeling of sorption in heterogeneous system,” thesis presented to the University of Michigan, at Ann Arbor, Mich., in partial fulfillment of the requirements for the degree of Doctor of Philosophy.
18.
Liu, K. T. (1980). “Determination of mass transport parameters for fixed‐bed adsorbers by a micro‐column technique,” thesis presented to the University of Michigan, at Ann Arbor, Mich., in partial fulfillment of the requirements for the degree of Doctor of Philosophy.
19.
Lucas, T. R., and Reiddien, G. W., Jr., (1971). “Some collocation methods for nonlinear boundary value problems.” SIAM J. Numer. Anal., 9(2), 341–356.
20.
Narbaitz, R. M., and Benedek, A. (1983). “Least cost process design for granular activated carbon adsorbers.” J. WPCF, 55(16), 1244–1251.
21.
Russel, R. D., and Shampine, L. F. (1972). “A collocation method for boundary value problems.” Numerische Mathematik, 19(1), 1–28.
22.
Summers, R. S., and Roberts, P. V. (1983). “Simulation of DOC removal in activated carbon beds.” J. Envir. Engrg., ASCE, 110(1), 73–92.
23.
Thacker, W. E. (1981). “Modeling of activated carbon and coal gasification char adsorbents in single‐solute and bisolute systems,” thesis, presented to the University of Illinois at Urbana‐Champaign, Urbana, Ill., in partial fulfillment of the requirements for the degree of Doctor of Philosophy.
24.
Thacker, W. E., Crittenden, J. C., and Snoeyink, V. L. (1984). “Modeling of adsorber performance: Variable influent concentration and comparison of adsorbents.” J. WPCF, 56(3), 243–250.
25.
Thacker, W. E., Snoeyink, V. L., and Crittenden, J. C. (1983). “Desorption of compounds during operation of GAC adsorption systems.” J. AWWA, 75(Mar.), 144–149.
26.
van Genuchten, M. T. (1976). “On the accuracy and efficiency of several numerical schemes for solving the convective‐dispersive equation.” Int. Conf. of Finite Element in Water Resour., Princeton University, Princeton, N.J.
27.
van Vliet, B. M., and Weber, W. J., Jr. (1981). “Comparative performance of synthetic adsorbents and activated carbon for specific compound removal from wastewaters.” J. WPCF, 53(11), 1585–1598.
28.
Villadsen, J. V., and Sorensen, J. P. (1969). “Solution of parabolic partial differential equations by double collocation method.” Chem. Engrg. Sci., 24(Aug.), 1337–1349.
29.
Villadsen, J. V., and Stewart, W. E. (1967). “Solution of boundary value problems by orthogonal collocation.” Chem. Engrg. Sci., Vol. 22, 1483–1501.
30.
Weber, W. J., Jr., and Crittenden, J. C. (1975). “MADAM I—a numeric method for design of adsorption systems.” J. WPCF, 47(5), 924–940.
31.
Weber, W. J., Jr., and Smith, E. H. (1987). “Critical review—simulation and design methods for adsorption systems.” Envir. Sci. Tech., 21(11), 1040–1049.
32.
Zienkiewicz, O. C. (1982). The finite element method, 3rd Ed., McGraw Hill Book Co., Inc., New York, N.Y.
Information & Authors
Information
Published In
Journal of Environmental Engineering
Volume 118 • Issue 2 • March 1992
Pages: 238 - 252
Copyright
Copyright © 1992 ASCE.
History
Published online: Mar 1, 1992
Published in print: Mar 1992
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.