Enhancing Air-Breathing Direct Methanol Fuel-Cell Performance by Optimizing Anode Flow-Channel Widths and Open Ratios of Cathode Current Collectors
Publication: Journal of Energy Engineering
Volume 149, Issue 5
Abstract
Air-breathing direct methanol fuel cells (AB-DMFCs) are used as a source of power for portable electronic devices. The width of the anode flow channel in AB-DMFCs plays a vital role in enhancing mass transfer to anode reaction sites. The transfer of oxygen to cathode reaction sites occurs through the current collector openings, and an optimum current collector open ratio (OR) was identified in this study. However, limited research is available on the effect of anode channel widths in combination with cathode current collector open ratios on the cell performance. This study analyzed the impact of anode single serpentine flow-channel widths and cathode current collector open ratios on AB-DMFC performance. The analysis was conducted in four stages. The first stage examined the influence of methanol concentration, varying from 0.5 to 2 M. In the second stage, three different anode flow-channel widths—1, 1.5, and 2 mm—were considered, with the methanol fuel flow rate varying from 0.5 to . Experimental results revealed that fuel-cell performance increased with the increase of methanol concentration from 0.5 to 1.5 M and then decreased. Moreover, a fuel cell fitted with a flow field (FF) with a channel width of 1 mm provided better performance at a methanol flow rate. Three different open ratios of cathode current collectors—45.40%, 55.40%, and 63.05%—were considered in the experiment, and the ambient temperature was varied from 30°C to 70°C. Among the three current collectors, the cell with a 55.40% current collector offered superior performance, and the optimal condition was observed at a methanol flow rate of . The optimized combination of a fuel cell fitted with a 1-mm channel–width flow field and 55.40% open-ratio current collectors produced a maximum power density (MPD) of at a methanol flow rate.
Get full access to this article
View all available purchase options and get full access to this article.
Data Availability Statement
The raw data for this study were generated at Maharaj Vijayaram Gajapathi Raj (MVGR) College of Engineering, Vizianagaram, Andhra Pradesh, India. Any derived data that support the results of this study are available from the corresponding author upon request.
Acknowledgments
The authors convey their sincere appreciation to Rajendra Ambati, an English Lecturer at Government Polytechnic Atmakur, Sri Potti Sri Ramulu (SPSR) Nellore, India for his invaluable assistance in editing and proofreading this manuscript.
References
Alizadeh, E., M. Farhadi, K. Sedighi, and M. Shakeri. 2013. “Effect of channel depth and cell temperature on the performance of a direct methanol fuel cell.” J. Fuel Cell Sci. Technol. 10 (3): 031002. https://doi.org/10.1115/1.4024151.
Arisetty, S., S. G. Advani, and A. K. Prasad. 2008. “Methanol diffusion rates through the anode diffusion layer in direct methanol fuel cells from limiting current measurements.” Heat Mass Transfer 44 (10): 1199–1206. https://doi.org/10.1007/s00231-007-0355-3.
Boni, M., S. Srinivasa Rao, and G. Naga Srinivasulu. 2020. “Performance evaluation of an air breathing–direct methanol fuel cell with different cathode current collectors with liquid electrolyte layer.” Asia-Pac. J. Chem. Eng. 15 (4): e2465. https://doi.org/10.1002/apj.2465.
Boni, M., S. R. Surapaneni, N. S. Golagani, and S. K. Manupati. 2021. “Experimental investigations on the effect of current collector open ratio on the performance of a passive direct methanol fuel cell with liquid electrolyte layer.” Chem. Pap. 75 (Jan): 27–38. https://doi.org/10.1007/s11696-020-01277-0.
Borello, D., A. Calabriso, L. Cedola, L. Del Zotto, and S. G. Santori. 2014. “Development of improved passive configurations of DMFC with reduced contact resistance.” Energy Procedia 61 (Jan): 2654–2657. https://doi.org/10.1016/j.egypro.2014.12.268.
Braz, B. A., C. S. Moreira, V. B. Oliveira, and A. M. F. R. Pinto. 2019. “Effect of the current collector design on the performance of a passive direct methanol fuel cell.” Electrochim. Acta 300 (Mar): 306–315. https://doi.org/10.1016/j.electacta.2019.01.131.
Calabriso, A., L. Cedola, L. Del Zotto, F. Rispoli, and S. G. Santori. 2015. “Performance investigation of passive direct methanol fuel cell in different structural configurations.” J. Cleaner Prod. 88 (Feb): 23–28. https://doi.org/10.1016/j.jclepro.2014.06.087.
Ding, Q., H.-L. Zhao, Z.-M. Wan, Y.-R. Yang, C. Yang, and X.-D. Wang. 2020. “Performance of parallel, interdigitated, and serpentine flow field PEM fuel cells with straight or wavelike channels.” J. Energy Eng. 146 (5): 04020054. https://doi.org/10.1061/(ASCE)EY.1943-7897.0000701.
Fang, Y., T. Zhang, Y. Zhang, and J. Zhu. 2021. “Evolution of oxygen reduction property by the role of in cathode catalyst for passive direct methanol fuel cells.” Appl. Catal., A 627 (Oct): 118378. https://doi.org/10.1016/j.apcata.2021.118378.
Gholizadeh, M., M. Ghazikhani, and I. Khazaee. 2017. “Experimental study of humidity changes on the performance of an elliptical single four-channel PEM fuel cell.” Heat Mass Transfer 53 (1): 233–239. https://doi.org/10.1007/s00231-016-1819-0.
Jung, G.-B., A. Su, C.-H. Tu, F.-B. Weng, and S.-H. Chan. 2007. “Innovative flow-field combination design on direct methanol fuel cell performance.” J. Fuel Cell Sci. Technol. 4 (3): 365–368. https://doi.org/10.1115/1.2744056.
Kianimanesh, A., B. Yu, Q. Yang, T. Freiheit, D. Xue, and S. S. Park. 2012. “Investigation of bipolar plate geometry on direct methanol fuel cell performance.” Int. J. Hydrogen Energy 37 (23): 18403–18411. https://doi.org/10.1016/j.ijhydene.2012.08.128.
Kim, S. H., H. Y. Cha, C. M. Miesse, J. H. Jang, Y. S. Oh, and S. W. Cha. 2009. “Air-breathing miniature planar stack using the flexible printed circuit board as a current collector.” Int. J. Hydrogen Energy 34 (1): 459–466. https://doi.org/10.1016/j.ijhydene.2008.09.088.
Nakagawa, N., T. Tsujiguchi, S. Sakurai, and R. Aoki. 2012. “Performance of an active direct methanol fuel cell fed with neat methanol.” J. Power Sources 219 (Dec): 325–332. https://doi.org/10.1016/j.jpowsour.2012.07.062.
Ouellette, D., U. Gencalp, and C. O. Colpan. 2017. “Effect of cathode flow field configuration on the performance of flowing electrolyte-direct methanol fuel cell.” Int. J. Hydrogen Energy 42 (4): 2680–2690. https://doi.org/10.1016/j.ijhydene.2016.11.022.
Park, Y.-C., P. Chippar, S.-K. Kim, S. Lim, D.-H. Jung, H. Ju, and D.-H. Peck. 2012. “Effects of serpentine flow-field designs with different channel and rib widths on the performance of a direct methanol fuel cell.” J. Power Sources 205 (May): 32–47. https://doi.org/10.1016/j.jpowsour.2011.12.055.
Park, Y.-C., D.-H. Peck, S.-K. Dong, S.-K. Kim, S. Lim, D.-H. Jung, J.-H. Jang, and D.-Y. Lee. 2011. “Operating characteristics and performance stability of 5 W class direct methanol fuel cell stacks with different cathode flow patterns.” Int. J. Hydrogen Energy 36 (2): 1853–1861. https://doi.org/10.1016/j.ijhydene.2010.02.018.
Shaari, N., Z. Zakaria, and S. K. Kamarudin. 2019. “The optimization performance of cross-linked sodium alginate polymer electrolyte bio-membranes in passive direct methanol/ethanol fuel cells.” Int. J. Energy Res. 43 (14): 8275–8285. https://doi.org/10.1002/er.4825.
Shrivastava, N. K., R. B. Chadge, P. Ahire, and J. P. Giri. 2019. “Experimental investigation of a passive direct ethanol fuel cell.” Ionics 25 (2): 719–726. https://doi.org/10.1007/s11581-018-2797-7.
Shrivastava, N. K., S. B. Thombre, and K. L. Wasewar. 2013. “Nonisothermal mathematical model for performance evaluation of passive direct methanol fuel cells.” J. Energy Eng. 139 (4): 266–274. https://doi.org/10.1061/(ASCE)EY.1943-7897.0000112.
Su, S., J. Liang, Y. Luo, Z. Liu, X. Li, P. Yin, L. Chen, Y. Cui, and D. Wang. 2021. “A new water management system for air-breathing direct methanol fuel cell using superhydrophilic capillary network and evaporation wings.” Energy Convers. Manage. 246 (Oct): 114665. https://doi.org/10.1016/j.enconman.2021.114665.
Sudaroli, B. M., and A. K. Kolar. 2015. “Experimental and numerical study of serpentine flow fields for improving direct methanol fuel cell performance.” Fuel Cells 15 (6): 826–838. https://doi.org/10.1002/fuce.201500046.
Wong, C. W., T. S. Zhao, Q. Ye, and J. G. Liu. 2006. “Experimental investigations of the anode flow field of a micro direct methanol fuel cell.” J. Power Sources 155 (2): 291–296. https://doi.org/10.1016/j.jpowsour.2005.04.028.
Xue, Y. Q., H. Guo, H. H. Shang, F. Ye, and C. F. Ma. 2015. “Simulation of mass transfer in a passive direct methanol fuel cell cathode with perforated current collector.” Energy 81 (Mar): 501–510. https://doi.org/10.1016/j.energy.2014.12.063.
Yang, H., and T. S. Zhao. 2005. “Effect of anode flow field design on the performance of liquid feed direct methanol fuel cells.” Electrochim. Acta 50 (16–17): 3243–3252. https://doi.org/10.1016/j.electacta.2004.11.060.
Yang, H., T. S. Zhao, and Q. Ye. 2005. “Pressure drop behavior in the anode flow field of liquid feed direct methanol fuel cells.” J. Power Sources 142 (1–2): 117–124. https://doi.org/10.1016/j.jpowsour.2004.09.036.
Yousefi, S., M. Shakeri, and K. Sedighi. 2013. “The effect of cell orientations and environmental conditions on the performance of a passive DMFC single cell.” Ionics 19 (11): 1637–1647. https://doi.org/10.1007/s11581-013-0889-y.
Yousefi, S., and M. Zohoor. 2013. “Investigating the effect of operating parameters on the open circuit voltage of a passive DMFC.” Ionics 19 (8): 1195–1201. https://doi.org/10.1007/s11581-013-0924-z.
Yuan, Z., J. Yang, Y. Zhang, and X. Zhang. 2015. “The optimization of air-breathing micro direct methanol fuel cell using response surface method.” Energy 80 (Feb): 340–349. https://doi.org/10.1016/j.energy.2014.11.076.
Information & Authors
Information
Published In
Copyright
© 2023 American Society of Civil Engineers.
History
Received: Sep 30, 2022
Accepted: May 15, 2023
Published online: Jun 29, 2023
Published in print: Oct 1, 2023
Discussion open until: Nov 29, 2023
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.