Discussion of “A Critical Assessment of the Effect of Initial Fabric on Key Small-Strain Design Parameters of Slurry-Deposited Silts and Sands”
This article is a reply.
VIEW THE ORIGINAL ARTICLEPublication: Journal of Geotechnical and Geoenvironmental Engineering
Volume 150, Issue 12
Get full access to this article
View all available purchase options and get full access to this article.
References
Al-Tarhouni, M., P. Simms, and S. Sivathayalan. 2011. “Cyclic behaviour of reconstituted and desiccated–rewet thickened gold tailings in simple shear.” Can. Geotech. J. 48 (7): 1044–1060. https://doi.org/10.1139/t11-022.
Bradshaw, A. S., and C. D. P. Baxter. 2007. “Sample preparation of silts for liquefaction testing.” Geotech. Test. J. 30 (4): 100206–100332. https://doi.org/10.1520/GTJ100206.
Desrues, J., R. Chambon, M. Mokni, and F. Mazerolle. 1996. “Void ratio evolution inside shear bands in triaxial sand specimens studied by computed tomography.” Géotechnique 46 (3): 529–546. https://doi.org/10.1680/geot.1996.46.3.529.
Imseeh, W. H., K. A. Alshibli, and R. I. Al-Raoush. 2020. “Discrepancy in the critical state void ratio of poorly graded sand due to shear strain localization.” J. Geotech. Geoenviron. Eng. 146 (8): 04020066. https://doi.org/10.1061/(ASCE)GT.1943-5606.0002280.
Liu, T., R. J. Jardine, K. Vinck, and S. K. Ackerley. 2022. “Optimization of advanced laboratory monotonic and cyclic triaxial testing on fine sands.” Geotech. Test. J. 45 (6): 1087–1107. https://doi.org/10.1520/GTJ20210190.
Reid, D., et al. 2021a. “Results of a critical state line test round robin program.” Géotechnique 71 (7): 616–630. https://doi.org/10.1680/jgeot.19.P.373.
Reid, D., and R. Fanni. 2022. “A comparison of intact and reconstituted samples of a silt tailings.” Géotechnique 72 (2): 176–188. https://doi.org/10.1680/jgeot.20.P.020.
Reid, D., R. Fanni, and A. B. Fourie. 2021b. “Some considerations when preparing thickened tailings for shear strength testing in the laboratory from a slurry.” In Proc., Paste 2021: 24th Int. Conf. on Paste, Thickened and Filtered Tailings, 203–216. Perth, Australia: Australian Centre for Geomechanics.
Reid, D., R. Fanni, and A. B. Fourie. 2022a. “Slurry deposition preparation method for tailings characterisation—History, debates, techniques and benefits.” In Proc., Tailings 2022. Santiago, Chile: Gecamin.
Reid, D., R. Fanni, K. Koh, and I. Orea. 2018. “Characterisation of a subaqueously deposited silt iron ore tailing.” Géotech. Lett. 8 (4): 278–283. https://doi.org/10.1680/jgele.18.00105.
Reid, D., A. Fourie, S. Dickinson, T. Shanmugarajah, R. Fanni, K. Smith, J. Garfias, B. Yuan, M. Ghafghazi, and A. Duyvesty. Forthcoming. “Results of a dilatancy round robin.” Canadian Geotech. J. 57 (4).
Reid, D., A. Fourie, and S. Moggach. 2019. “Characterization of a gold tailings with hypersaline pore fluid.” Can. Geotech. J. 57 (4): 482–496. https://doi.org/10.1139/cgj-2018-0579.
Reid, D., and A. B. Fourie. 2015. “The influence of slurry density on in situ density.” In Proc., Paste 2015: Proc. 18th Int. Seminar on Paste and Thickened Tailings, 95–106. Perth, Australia: Australian Centre for Geomechanics.
Reid, D., F. Fourie, and R. Fanni. 2022b. “Layering—The missing factor in fabric studies?” In Proc., 20th Int. Conf. on Soil Mechanics and Geotechnical Engineering. London: ISSMGE.
Salvatore, E., G. Modoni, E. Andò, M. Albano, and G. Viggiani. 2017. “Determination of the critical state of granular materials with triaxial tests.” Soils Found. 57 (5): 733–744. https://doi.org/10.1016/j.sandf.2017.08.005.
Shuttle, D. A., and J. Cunning. 2007. “Liquefaction potential of silts from CPTu.” Can. Geotech. J. 44 (1): 1–19. https://doi.org/10.1139/t06-086.
Sivathayalan, S., and Y. P. Vaid. 2002. “Influence of generalized initial state and principal stress rotation on the undrained response of sands.” Can. Geotech. J. 39 (1): 63–76. https://doi.org/10.1139/t01-078.
Thomson, P. R., and R. C. K. Wong. 2008. “Specimen nonuniformities in water-pluviated and moist-tamped sands under undrained triaxial compression and extension.” Can. Geotech. J. 45 (7): 939–956. https://doi.org/10.1139/T08-023.
Vaughn, P. R. 1997. “Panel dicussion: Sedimentation of tailings.” In Proc., 14th Int. Conf. on Soil Mechanics and Foundation Engineering, 2561–2562. London: ISSMGE.
Wang, S., R. Luna, and R. Stephenson. 2011. “A slurry consolidation approach to reconstitute low-plasticity silt specimens for laboratory triaxial testing.” Geotech. Test. J. 34 (4): 288–296. https://doi.org/10.1520/GTJ103529.
Zdravković, L., and R. J. Jardine. 2001. “The effect on anisotropy of rotating the principal stress axes during consolidation.” Géotechnique 51 (1): 69–83. https://doi.org/10.1680/geot.2001.51.1.69.
Information & Authors
Information
Published In
Journal of Geotechnical and Geoenvironmental Engineering
Volume 150 • Issue 12 • December 2024
Copyright
© 2024 American Society of Civil Engineers.
History
Received: Sep 26, 2023
Accepted: Oct 30, 2023
Published online: Sep 26, 2024
Published in print: Dec 1, 2024
Discussion open until: Feb 26, 2025
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.