Underwater Retrogressive Slope Failure: Observations and Analyses
Publication: Journal of Geotechnical and Geoenvironmental Engineering
Volume 150, Issue 11
Abstract
This paper presents an analysis of an underwater retrogressive slope failure caused by the concurrent construction of a wharf access causeway and dredging near the end of the causeway for the wharf structure cofferdams. A cross section was developed along the causeway and analyzed to simulate the retrogressive slope failure using limit equilibrium analyses. The compound failure surface for the inverse stability analysis of each of the five retrogressive failure masses agrees with observations before, during, and after the failure. Soil stratigraphy is discussed and the mobilized undrained strength of the seabed clay underlying the causeway fill was estimated using an inverse analysis of each of the five failure masses. The inverse analysis shows that the concurrent dredging and causeway construction reduced the factor of safety (FoS) of the causeway underwater slope, which eventually initiated the retrogressive failure. The stability analyses show that the causeway construction contributed to the reduction of the FoS but dredging triggered the first slope failure, which started the retrogressive failure. Nevertheless, had dredging not occurred, a slope failure would still have occurred if the causeway construction had extended another 5 m from where the first slope failure occurred.
Practical Applications
There are several practical lessons from the slope failure discussed in this paper. First, in any slope modification, the existing soils in the area of construction should be sampled and tested. Engineers and owners should be cautious of construction methods that make implicit assumptions about soil strength and/or other engineering characteristics. Even though gathering underwater geotechnical data is difficult, it is recommended to perform field tests to evaluate the shear strength of soil layers to perform slope stability analyses. Further, planned modifications to a slope that could destabilize it should be thoroughly analyzed, and such analyses should not be restricted to a circular failure surface. If possible, the construction sequence should be modified to reduce the extent to which the slope is destabilized. In this case, that would mean constructing the wharf before the causeway. Finally, construction should be monitored to verify that the proposed methods are working as intended. In this case, it was assumed that the rockfill would displace the marine clay when constructing the causeway. This should have been verified as filling progressed. Photographs of the dredged marine indicated a medium to medium stiff clay, which indicated that the clay was not as soft as anticipated.
Get full access to this article
View all available purchase options and get full access to this article.
Data Availability Statement
Some or all data, models, or code that support the findings of this study are available from the corresponding author upon reasonable request.
Acknowledgments
The contents and views in this paper are those of the individual authors and do not necessarily reflect those of any of the corporations, contractors, agencies, consultants, organizations, owners, and/or contributors to the port development. The second author acknowledges and appreciates the participation of Filippo Massobrio of LANGAN Engineering and Environmental Services, LLC., based in New York City, in the initial stages of this case study because they both studied and presented this project as their CEE 581 course term project at the University of Illinois Urbana–Champaign.
References
Barton, N., and B. Kjærnsli. 1981. “Shear strength of rockfill.” J. Geotech. Eng. Div. 107 (7): 873–891. https://doi.org/10.1061/AJGEB6.0001167.
Bjerrum, L. 1971. Subaqueous slope failures in Norwegian fjords. Oslo, Norway: Norwegian Geotechnical Institute.
Cornforth, D. H. 2005. Landslides in practice: Investigation, analysis, and remedial/preventative options in soils, 529–540. Hoboken, NJ: Jhon Wiley & Sons.
Demers, D., and S. Leroueil. 2002. “Evaluation of preconsolidation pressure and the overconsolidation ratio from piezocone tests of clay deposits in Quebec.” Can. Geotech. J. 39 (1): 174–192. https://doi.org/10.1139/t01-071.
Drevininkas, A., M. Manzari, T. Sangiuliano, and D. Staseff. 2015. Geotechnical characteristics of Barlow-Ojibway Clay in Northern Ontario. Toronto: Ministry of Transportation of Ontario.
Duncan, J. M. 2000. “Factors of safety and reliability in geotechnical engineering.” J. Geotech. Geoenviron. Eng. 126 (4): 307–316. https://doi.org/10.1061/(ASCE)1090-0241(2000)126:4(307).
Duncan, J. M., and A. L. Buchignani. 1973. “Failure of underwater slope in San Francisco Bay.” J. Soil Mech. Found. Div. 99 (9): 687–703. https://doi.org/10.1061/JSFEAQ.0001926.
Duncan, J. M., S. G. Wright, and T. L. Brandon. 2014. Soil strength and slope stability. New York: Wiley.
Frossard, E., W. Hu, C. Dano, and P. Y. Hicher. 2012. “Rockfill shear strength evaluation: A rational method based on size effects.” Géotechnique 62 (5): 415–427. https://doi.org/10.1680/geot.10.P.079.
Griffiths, D. V., J. Huang, and G. A. Fenton. 2011. “Probabilistic infinite slope analysis.” Comput. Geotech. 38 (4): 577–584. https://doi.org/10.1016/j.compgeo.2011.03.006.
Hamidi, A., V. Yazdanjou, and N. Salimi. 2009. “Shear strength characteristics of sand-gravel mixtures.” Int. J. Geotech. Eng. 3 (1): 29–38. https://doi.org/10.3328/IJGE.2009.03.01.29-38.
Hussain, M., and T. D. Stark. 2011. “Back-analysis of preexisting landslides.” In Proc., Specialty Conf. Geo-Frontiers 2011, 3659–3668. Reston, VA: ASCE.
Idries, A., and T. D. Stark. 2024. “Uncertainty in drained fully softened and residual strength correlations.” J. Geotech. Geoenviron. Eng. 150 (1): 06023010. https://doi.org/10.1061/JGGEFK.GTENG-11840.
Idries, A., T. D. Stark, L. Moya, and J. Lin. 2023. “Case study: 3D mobilized strength of compacted fill.” Can. Geotech. J. 61 (6): 1177–1188. https://doi.org/10.1139/cgj-2023-0187.
Leps, T. M. 1970. “Review of shearing strength of rockfill.” J. Soil Mech. Found. Div. 96 (4): 1159–1170. https://doi.org/10.1061/JSFEAQ.0001433.
Morgenstern, N. R., and V. E. Price. 1965. “The analysis of the stability of general slip surfaces.” Géotechnique 15 (1): 79–93. https://doi.org/10.1680/geot.1965.15.1.79.
Morgenstern, N. R., and V. E. Price. 1967. “A numerical method for solving the equations of stability of general slip surfaces.” Comput. J. 9 (4): 388–393. https://doi.org/10.1093/comjnl/9.4.388.
Peck, R. B., W. E. Hanson, and T. H. Thornburn. 1974. Foundation engineering. 2nd ed. New York: Wiley.
Puzrin, A. M., T. E. Gray, and A. J. Hill. 2017. “Retrogressive shear band propagation and spreading failure criteria for submarine landslides.” Géotechnique 67 (2): 95–105. https://doi.org/10.1680/jgeot.15.P.078.
Rocscience. 2022. Slide version 2021–2D slope stability analysis. Toronto: Rocscience.
Saxov, S., and J. K. Nieuwenhuis. 2012. Vol. 6 of Marine slides and other mass movements. New York: Springer.
Silva, F., T. W. Lambe, and W. A. Marr. 2008. “Probability and risk of slope failure.” J. Geotech. Geoenviron. Eng. 134 (12): 1691–1699. https://doi.org/10.1061/(ASCE)1090-0241(2008)134:12(1691).
Stark, T. D., H. Choi, and C. Lee. 2009. “Case study of undrained strength stability analysis for dredged material placement areas.” J. Waterw. Port Coastal Ocean Eng. 135 (3): 91–99. https://doi.org/10.1061/(ASCE)0733-950X(2009)135:3(91).
Stark, T. D., and I. A. Contreras. 1996. “Constant volume ring shear apparatus.” Geotech. Test. J. 19 (1): 3–11. https://doi.org/10.1520/GTJ11402J.
Stark, T. D., and I. A. Contreras. 1998. “Fourth avenue landslide during 1964 Alaskan earthquake.” J. Geotech. Geoenviron. Eng. 124 (2): 99–109. https://doi.org/10.1061/(ASCE)1090-0241(1998)124:2(99).
Stark, T. D., and A. Idries. 2021. “Drained residual shear strength power function coefficients a and b.” Geotech. Test. J. 44 (6): 1678–1694. https://doi.org/10.1520/GTJ20200234.
Stark, T. D., A. Idries, and J. Lin. 2024. “Mobilized shear strength of overconsolidated Seattle clays.” J. Geotech. Geoenviron. Eng. 150 (6): 04024046. https://doi.org/10.1061/JGGEFK.GTENG-12062.
Stark, T. D., P. J. Ricciardi, and R. D. Sisk. 2018. “Case study: Vertical drain and stability analyses for a compacted embankment on soft soils.” J. Geotech. Geoenviron. Eng. 144 (2): 05017007. https://doi.org/10.1061/(ASCE)GT.1943-5606.0001786.
Terzaghi, K. 1956. “Varieties of submarine slope failures.” In Proc., 8th Texas Conf. on Soil Mechanics and Foundation Engineering, 41. Boston: Harvard Univ.
Terzaghi, K., R. B. Peck, and G. Mesri. 1996. Soil mechanics in engineering practice. New York: Wiley.
USACE. 1970. Engineering and design: Stability of earth and rock-fill dams. Washington, DC: USACE.
Whittlestone, A. P., and J. D. Johnson. 1994. “Probabilistic risk analysis of slope stability to assess stabilisation measures.” In Risk and reliability in ground engineering, 266–276. London: Thomas Telford.
Yagiz, S. 2001. “Brief note on the influence of shape and percentage of gravel on the shear strength of sand and gravel mixtures.” Bull. Eng. Geol. Environ. 60 (4): 321–323. https://doi.org/10.1007/s100640100122.
Zhang, W., B. Klein, M. F. Randolph, and A. M. Puzrin. 2021. “Upslope failure mechanisms and criteria in submarine landslides: Shear band propagation, slab failure and retrogression.” J. Geophys. Res. Solid Earth 126 (9): e2021JB022041. https://doi.org/10.1029/2021JB022041.
Information & Authors
Information
Published In
Copyright
© 2024 American Society of Civil Engineers.
History
Received: Apr 10, 2023
Accepted: Mar 1, 2024
Published online: Aug 28, 2024
Published in print: Nov 1, 2024
Discussion open until: Jan 28, 2025
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.