Recovery of High-Viscosity Crude Oil from Contaminated Oil-Wet Sand Using a Combined Mechanical Agitation and Freeze-Thaw Process
Publication: Journal of Environmental Engineering
Volume 141, Issue 11
Abstract
This research presents a combined mechanical agitation and freeze–thaw method as a simple and immediate response to recover high-viscosity crude oil from oil-wet contaminated sand following oil spill events. The effects of temperature, pH, and agitation rate were studied on the recovery of high-viscosity crude oil in a mechanically agitated cell followed by freeze–thaw. Results showed that the increase in temperature and pH to 50°C and pH 9, respectively, was optimum and led to a 58% increase in oil recovery. The optimum agitation rate of 1,000 rpm at 50°C and pH 9 was further shown to increase the oil recovery to 68%. Further increases in agitation rates, however, showed a decline in oil recovery due to the formation of oil-in-water emulsions. Results of this study suggest that the combined mechanical agitation and freeze–thaw process is a viable method for the recovery of spilled crude oil on sand.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
Funding for this work is from Monash University Malaysia and is gratefully acknowledged.
References
Abioye, O., Agamuthu, P., and Aziz, A. A. (2012). “Phytotreatment of soil contaminated with used lubricating oil using Hibiscus cannabinus.” Biodegradation, 23(2), 277–286.
Agamuthu, P., Abioye, O., and Aziz, A. A. (2010). “Phytoremediation of soil contaminated with used lubricating oil using Jatropha curcas.” J. Hazard. Mater., 179(1–3), 891–894.
Albergaria, J. T., Alvim-Ferraz, M. D. C. M., and Delerue-Matos, C. (2012). “Remediation of sandy soils contaminated with hydrocarbons and halogenated hydrocarbons by soil vapour extraction.” J. Environ. Manage., 104, 195–201.
Angelo, M., and Ordonio, A. (2012). “How to grease the waters: The 2006 Guimaras oil spill retrospection.” M.S. thesis, Univ. of the Philippines Los Baños, Los Baños, Philippines.
Ayranci, I., Tan, G., Dix-Cooper, M., Hossein-Pour, M. (2010). “Mixing in process industries, mineral processing.” 〈http://1.mixing.net/sites/default/files/publications/Mixing%20in%20mineral%20processing.pdf〉 (Apr. 1, 2014).
Czarnecki, J., Radoev, B., Schramm, L. L., and Slavchev, R. (2005). “On the nature of Athabasca oil sands.” Adv. Colloid Interface, 114–115, 53–60.
Dai, Q., and Chung, K. H. (1995). “Bitumen-sand interaction in oil sand processing.” Fuel, 74(12), 1858–1864.
Dai, Q., and Chung, K. H. (1996). “Hot water extraction process mechanism using model oil sands.” Fuel, 75(2), 220–226.
Deglon, D. A. (2005). “The effect of agitation on the floatation of platinum ores.” Miner. Eng., 18(8), 839–844.
Falciglia, P., Giustra, M., and Vagliasindi, F. (2011). “Low-temperature thermal desorption of diesel polluted soil: Influence of temperature and soil texture on contaminant removal kinetics.” J. Hazard. Mater., 185(1), 392–400.
Gagne, L., Gunnoe, E., Linnell, A., and Williamson, E. (2008). “Exxon Valdez oil spill.” Chapter 111, Principles of chemistry writing project, D. Tshudy, ed., Gordon College, Dept. of Chemistry, MA, 81–86.
Hong, P., Cha, Z., Zhao, X., Cheng, C. -J., and Duyvesteyn, W. (2013). “Extraction of bitumen from oil sands with hot water and pressure cycles.” Fuel Process. Technol., 106, 460–467.
Hupka, J., Miller, J. D., and Drelich, J. (2004). “Water-based bitumen recovery from diluent-conditioned oil sands.” Can. J. Chem. Eng., 82(5), 978–985.
Lindemann, E., Naude, N., Romero, P., and Tengwall, K. (2008). “The Exxon Valdez oil spill.” Chapter 111, Principles of chemistry writing project, D. Tshudy, ed., Gordon College, Dept. of Chemistry, MA, 86–91.
Liu, J., Xu, Z., and Masliyah, J. (2005). “Colloidal forces between bitumen surfaces in aqueous solutions measured with atomic force microscope.” Colloid Surf. A, 260(1–3), 217–228.
Long, J., Drelich, J., Xu, Z., and Masliyah, J. H. (2007a). “Effect of operating temperature on water-based oil sands processing.” Can. J. Chem. Eng., 85(5), 726–738.
Long, J., Xu, Z., and Masliyah, J. H. (2005). “On the role of temperature in oil sands processing.” Energy Fuel, 19(4), 1440–1446.
Lu, M., Zhang, Z., Qiao, W., Guan, Y., Xiao, M., and Peng, C. (2010). “Removal of residual contaminants in petroleum-contaminated soil by Fenton-like oxidation.” J. Hazard. Mater., 179(1), 604–611.
Margesin, R., Hämmerle, M., and Tscherk, O. D. (2007). “Microbial activity and community composition during bioremediation of diesel-oil-contaminated soil: Effects of hydrocarbon concentration, fertilizers, and incubation time.” Microb. Ecol., 53(2), 259–269.
Masliyah, J., Zhou, Z., Xu, Z., Czarnecki, J., and Hamza, H. (2004). “Understanding water-based Bitumen extraction from Athabasca oil sands.” Can. J. Chem. Eng., 82(4), 628–654.
McCay, D. F., Rowe, J. J., Whittier, N., Sankaranarayanan, S., and Etkin, D. S. (2004). “Estimation of potential impacts and natural resources damages of oil.” J. Hazard. Mater., 107(1–2), 11–25.
Miller, N. J., and Mudge, S. M. (1997). “The effect of biodiesel on the rate of removal and weathering characteristics of crude oil within artificial sand columns.” Spill Sci. Technol. B, 4(1), 17–33.
Misra, M., Aguilar, R., and Miller, J. D. (1981). “Surface chemistry features in the hot water processing of Utah tar sand.” Sep. Sci. Technol., 16(10), 1523–1544.
Morgott, D., Lewis, C., Bootman, J., and Banton, M. (2014). “Disulfide oil hazard assessment using categorical analysis and a mode of action determination.” Int. J. Toxicol., 33(1 Suppl.), 181 S–198 S.
Owens, E. H. (2011). “Shoreline countermeasures.” Oil spill science and technology, Elsevier, New York, 907–921.
Painter, P., Williams, P., and Lupinsky, A. (2010). “Recovery of bitumen from Utah tar sands using ionic liquids.” Energy Fuel, 24(9), 5081–5088.
Pazos, M., Plaza, A., Martín, M., and Lobo, M. (2012). “The impact of electrokinetic treatment on a loamy-sand soil properties.” Chem. Eng. J., 183, 231–237.
Pomes, V., Fernández, A., and Houi, D. (2002). “Effect of applied electrical field and the initial soil concentration on species recovery during application of the electroremediation process.” Process Saf. Environ., 80(5), 256–264.
Prince, R. C., et al. (2003). “Bioremediation of stranded oil on an arctic shoreline.” Spill Sci. Technol. B, 8(3), 303–312.
Rahman, R. M., Ata, S., and Jameson, G. J. (2012). “The effect of flotation variables on the recovery of different particle size fractions in the froth and the pulp.” Int. J. Miner. Process., 106–109, 70–77.
Rodrigues, T. R., and Rubio, J. (2007). “DAF-dissolved air flotation: Potential applications in the mining and mineral processing industry.” Int. J. Miner. Process., 82(1), 1–13.
Rubio, J., Souza, M. L., and Smith, R. W. (2002). “Overview of flotation as a wastewater treatment technique.” Miner. Eng., 15(3), 139–155.
Schmidt-Edkin, D. (2010). “Spill occurrences: A world overview.” Chapter 2, Oil spill science and technology, M. Fingas, ed., Elsevier.
Schramm, L. L. (2000). Surfactants: Fundamentals and applications in the petroleum industry, Cambridge University Press, Cambridge, U.K.
Schramm, L. L., Stasiuk, E. N., and Turner, D. (2003). “The influence of interfacial tension in the recovery of bitumen by water-based conditioning and flotation of athabasca oil sands.” Fuel Process. Technol., 80(2), 101–118.
Shell Corporation. (2010). “Safety data sheet.”.
SigmaPlot version 12 [Computer software]. San Jose, CA, Systat Software Inc.
Soleimani, M., Afyuni, M., Hajabbasi, M. A., Nourbakhsh, F., Sabzalian, M. R., and Christensen, J. H. (2010). “Phytoremediation of an aged petroleum contaminated soil using endophyte infected and non-infected grasses.” Chemosphere, 81(9), 1084–1090.
Talingdan-Tabangcura, M. E. (2006). “Science-based management of MT Solar 1 oil spill.” Science and Technology Information Institute, Metro Manila, Philippines, 〈http://sntpost.stii.dost.gov.ph/NewPOST/JulSep2006/Science_based_management_of_MT_Solar_1_oil_spill.html〉 (Jun. 27, 2013).
Usman, M., Faure, P., Hanna, K., Abdelmoula, M., and Ruby, C. (2012). “Application of magnetite catalyzed chemical oxidation (Fenton-like and persulfate) for the remediation of oil hydrocarbon contamination.” Fuel, 96, 270–276.
Wang, J., Yin, J., Ge, L., and Zheng, J. (2010a). “Using flotation to separate oil spill contaminated beach sands.” J. Environ. Eng., 147–151.
Wang, J., Zhan, X., Zhou, L., and Lin, Y. (2010b). “Biological indicators capable of assessing thermal treatment efficiency of hydrocarbon mixture-contaminated soil.” Chemosphere, 80(8), 837–844.
Xu, Y., and Lu, M. (2010). “Bioremediation of crude oil-contaminated soil: Comparison of different biostimulation and bioaugmentation treatments.” J. Hazard. Mater., 183(1), 395–401.
Information & Authors
Information
Published In
Copyright
© 2015 American Society of Civil Engineers.
History
Received: Apr 11, 2014
Accepted: Feb 12, 2015
Published online: May 22, 2015
Discussion open until: Oct 22, 2015
Published in print: Nov 1, 2015
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.