Integral Abutment Bridge Behavior: Parametric Analysis of a Massachusetts Bridge
Publication: Journal of Bridge Engineering
Volume 12, Issue 1
Abstract
Integral abutment bridges are often a preferred bridge type for moderate spans throughout the United States. However, design methods and construction details vary from state to state. Variations between states are noted in the methods employed to accommodate deformations in the piles. The significance of these differences was evaluated through a finite-element study. The effects of backfill properties and soil restraint on piles were evaluated with regard to bridge distortions and maximum moment realized in the piles. Results show that bridge expansion is predominantly affected by backfill conditions, whereas contraction is influenced by pile restraint conditions. Pile moments are minimized when denser backfill and lower pile restraint are provided. The influence of abutment soil-structure spring modeling assumptions is addressed. Models were calibrated to the reference bridge at Orange-Wendell, Mass, which has been instrumented and data collected for 4 years.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
The research reported was prepared in cooperation with the Executive Office of Transportation, Massachusetts Highway Department and the United States Department of Transportation, Federal Highway Administration, through the Massachusetts Transportation Research Program. The contents of this paper reflect the views of the writers, who are responsible for the facts and the accuracy of the data presented herein. The contents do not necessarily reflect the official view or policies of the Massachusetts Highway Department or the Federal Highway Administration. Preliminary modeling and data collection was contributed by Jason Pisano, Benjamin Crellin, Jeffrey Hnatio, and David Butler.
References
American Petroleum Institute. (1993). Recommended practice for planning, designing, and constructing fixed offshore platforms, API RP 2A, 20th Ed., Dallas.
Bonczar, C. H., Civjan, S. A., Brena, S. F., and DeJong, J. (2005). “Behavior of integral abutment bridges: Field data and computer modeling.” Final Rep. No. UMTC-05-04 to Massachusetts Highway Dept., Univ. of Massachusetts Transportation Center, Amherst, Mass.
Burke, M. P., Jr. (1993). “Integral bridges: Attributes and limitations.” Transportation Research Record. 1393, National Research Council, Washington, D.C., 1–8.
Conboy, D. W., and Stoothoff, E. J. (2005). “Integral abutment design and construction: The New England experience.” Proc., Integral Abutment and Jointless Bridges 2005 Conf., Federal Highway Administration, 50–60.
Georgia Tech Research Corporation. (2002). GTStrudl user guide, Revision 2, Georgia Institute of Technology, Atlanta.
Kunin, J., and Alampalli, S. (2000). “Integral abutment bridges: Current practice in United States and Canada.” J. Perform. Constr. Facil., 14(3), 104–111.
Liu, D., Magliola, R. A., and Dunker, K. F. (2005). “Integral abutment bridges—Iowa and Colorado experience.” Proc., Integral Abutment and Jointless Bridges 2005 Conf., Federal Highway Administration, 136–147.
Massachusetts Highway Dept. (1999). Design guidelines and standard details for integral abutment bridges, Mass Highway Bridge Manual, Boston.
National Cooperative Highway Research Program (NCHRP). (1991). “Manuals for the design of bridge foundations.” R. M. Barker, J. M. Duncan, K. B. Rojiani, P. S. K. Ooi, C. K. Tan, and S. G. Kim, eds., Transportation Research Record. 343, Transportation Research Board, Washington, D.C.
Soltani, A. A., and Kukreti, A. R. (1992). “Performance evaluation of integral abutment bridges.” Transportation Research Record. 1371, National Research Council, Washington D.C., 17–25.
Thomson, T. A., and Lutenegger, A. J. (1998). “Passive earth pressure tests on an integral bridge abutment.” Proc., 4th Int. Conf. on Case Histories in Geotechnical Engineering, St. Louis, 901–906.
Information & Authors
Information
Published In
Copyright
© 2007 ASCE.
History
Received: Aug 16, 2005
Accepted: Dec 28, 2006
Published online: Jan 1, 2007
Published in print: Jan 2007
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.