Pressure Cell for Measuring Capillary Pressure Relationships of Contaminated Sands
Publication: Journal of Environmental Engineering
Volume 125, Issue 4
Abstract
A conventional pressure cell may be inadequate for making the multiple capillary pressure–saturation relationships necessary to characterize waste sites because of its materials of construction and poor dynamic response. This paper outlines the design of a pressure cell apparatus that is constructed of chemically resistant materials and is capable of generating drainage and imbibition capillary relationships at both positive and negative capillary pressures for sandy porous media containing organic liquids and surface-active solutes over a range of pH values. Its rapid response is caused primarily by a highly conductive capillary barrier and the continuous visual display of degree of saturation. Because of the high conductivity of the capillary barrier, bubbles form under it, limiting the cell to 40 h of use at a capillary pressure head of 150 cm H2O or 10 h at 200 cm H2O. This range is sufficient, however, to allow the generation of the five capillary pressure relationships necessary to characterize wettability for many waste-site systems.
Get full access to this article
View all available purchase options and get full access to this article.
References
1.
Amott, E. ( 1959). “Observations relating to the wettability of porous rock.” Trans. AIME, 216, 156–162.
2.
Anderson, W. G. ( 1987). “Wettability literature survey, 4. The effects of wettability on capillary pressure.” J. Petr. Technol., 39(10), 1283–1300.
3.
Demond A. H., Desai, F. N., and Hayes, K. F. ( 1994). “Effect of cationic surfactants on organic liquid-water capillary pressure-saturation relationships.” Water Resour. Res., 30(2), 333–342.
4.
Demond A. H., and Roberts, P. V. ( 1991). “Effect of interfacial forces on two-phase capillary pressure-saturation relationships.” Water Resour. Res., 27(3), 423–437.
5.
Desai F. N., Demond, A. H., and Hayes, K. F. ( 1992). “Influence of surfactant sorption on capillary pressure-saturation relationships.” Transport and remediation of subsurface contaminants: Colloidal, interfacial, and surfactant phenomena, R. Knox and D. Sabatini, eds., American Chemical Society, Washington, D.C., 133–148.
6.
Donaldson, E. C., Thomas, R. D., and Lorenz, P. B. ( 1969). “Wettability determination and its effect on recovery efficiency.” Soc. Petr. Engrg. J., 9(1), 13–20.
7.
Elrick, D. E., and Bowman, D. H. ( 1964). “Note on an improved apparatus for soil moisture flow measurements.” Soil Sci. Soc. Am. Proc., 28, 450–452.
8.
Gardner, W. R. ( 1956). “Calculation of capillary conductivity from pressure plate outflow data.” Soc. Sci. Soc. Am. Proc., 20, 317–320.
9.
Klute, A. ( 1986). “Water retention: Laboratory methods.” Methods of soil analysis, Part 1: Physical and mineralogical methods, 2nd Ed., A. Klute, ed., American Society of Agronomy, Madison, Wis., 635–662.
10.
Lord, D. L., Demond A. H., Salehzadeh, A., and Hayes, K. F. ( 1997). “Influence of organic acid solution chemistry on subsurface transport properties, 2. Capillary pressure-saturation.” Envir. Sci. Technol., 31, 2052–2058.
11.
Miller, E. E., and Elrick, D. E. ( 1958). “Dynamic determination of capillary conductivity extended for non-negligible membrane impedance.” Soil Sci. Soc. Am. Proc., 22, 483–486.
12.
Powers, S. E., and Tamblin, M. E. ( 1995). “Wettability of porous media after exposure to synthetic gasolines.” J. Contaminant Hydro., 19, 105–125.
13.
Reginato, R. J., and Van Bavel, C. H. M. ( 1962). “Pressure cell for soil cores.” Soil Sci. Soc. Am. Proc., 26(1), 1–3.
14.
Standard test method for capillary-moisture relationships for coarse- and medium-textured soils by porous-plate apparatus, D2325-68 . (1994). ASTM, West Conshohocken, Pa.
15.
Topp, G. C., Klute, A., and Peters, D. B. ( 1967). “Comparison of water content-pressure head data obtained by equilibrium, steady-state and unsteady-state methods.” Soil Sci. Soc. Am. Proc., 31, 312–314.
16.
Wei, M., Bowman, R. S., Wilson, J. L., and Morrow, N. R. ( 1993). “Wetting properties and stability of silane-treated glass exposed to water, air, and oil.” J. Colloid and Interface Sci., 157, 154–159.
17.
Wilson, J. L., Conrad, S. H., Mason, W. R., Peplinski, W., and Hagan, E. ( 1990). “Laboratory investigation of residual liquid organics from spills, leaks and the disposal of hazardous wastes in groundwater.” Rep. No. EPA/600/6-90/004, R. S. Kerr Environmental Research Laboratory, U.S. Environmental Protection Agency, Ada, Okla.
Information & Authors
Information
Published In
History
Published online: Apr 1, 1999
Published in print: Apr 1999
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.