Hazardous Wastes Generated in the Manufacture of High-Explosive 1,3,5-triamino-2,4,6-trinitrobenzene
Publication: Journal of Hazardous, Toxic, and Radioactive Waste
Volume 18, Issue 3
Abstract
The hazardous wastes generated in the manufacture of high-explosive 1,3,5-triamino-2,4,6-trinitrobenzene (TATB) from starting material 1,3,5-trichlorobenzene are described. The process generates three kinds of effluents: water-based nitration effluent (WNE), toluene-based amination effluent (TAE), and water-based amination effluent (WAE). These three effluents are analyzed as per the country’s pollution control norms. Both WNE and WAE need treatment before discharge to the environment. These treatment methodologies are discussed. The solvent recovery from TAE was found highly feasible. However, some solid organic explosive waste ( TATB produced) is generated from the residue of TAE after solvent recovery. The composition of this solid waste is analyzed by gas chromatography and its potential explosiveness is characterized by a sensitivity test. The disposal methodology of the solid wastes generated from WNE, TAE, and WAE are also discussed.
Get full access to this article
View all available purchase options and get full access to this article.
References
Agrawal, J. P. (2010). High energy materials: Propellants, explosives and pyrotechnics, Wiley, Hoboken, NJ.
Agrawal, J. P., and Hodgson, R. D. (2007). Organic chemistry of explosives, Wiley, Hoboken, NJ.
Avrami, L., and Hutchinson, R. (1977). The sensitivity to impact and friction for energetic materials, Plenum Press, New York.
Bassett, J., Denney, R. C., Jeffery, G. H., and Mendham, J. (1978). Vogel’s textbook of quantitative chemical analysis, 4th Ed., Longman Group, England.
Bellamy, A. J., Ward, S. J., and Golding, P. (2002). “A new synthesis route to 1,3,5-triamino-2,4,6-trinitrobenzene (TATB).” Propellants Explos. Pyrotech., 27(2), 49–58.
Benziger, T. M. (1981). “Manufacture of TATB.” Proc., 12th Int. Annual Conf. of ICT, Institute of Chemical Technology, Fraunhofer, 491–503.
Boddu, V. M., Viswanath, D. S., Ghosh, T. K., and Damavarapu, R. (2010). “2,4,6-triamino-1,3,5-trinitrobenzene (TATB) and TATB-based formulations—A review.” J. Hazard. Mater., 181(1–3), 1–8.
Brown, W., and Reavill, M. J. (1954). “Effect of tetrachloronitrobenzene on the sprouting and cropping of potato tubers.” Ann. Appl. Biol., 41(3), 435–460.
Central Pollution Control Board (CPCB). (1986). “General standard for discharge of environmental pollutants, Part-A: Effluents [Schedule VI].” The Environment Protection Act 1986, New Delhi, Govt. of India.
Dobratz, B. M. (1995). “The insensitive high explosive triaminotrinitrobenzene (TATB): Development and characterisation—1888 to 1994.”, Los Alamos National Laboratory, Los Alamos, NM.
Mandal, A. K., Patil, U. K., Bhattacharyya, S. C., and Syal, R. K. (2000). “Recovery of explosives from the effluent in the manufacture of 1,3,5-triamino-2,4,6-trinitrobenzene.” Proc. 3rd Int. High Energy Materials Conf. and Exhibits (HEMCE), High Energy Materials Society of India (HEMSI), Thiruvanathapuram, 434–440.
Mitchell, A. R., Pagoria, P. F., and Schmidt, R. D. (1996). “A new synthesis of TATB using inexpensive starting material and mild reaction conditions.” Proc. 27th Int. Annual Conf. of ICT, Institute of Chemical Technology, Fraunhofer, 29/1–29/11.
Nandi, A. K., Kasar, S. M., Thanigaivelan, U., Mandal, A. K., and Pandey, R. K. (2012). “Formation of the sensitive impurity 1,3,5-triamino-2-chloro-4,6-dinitrobenzene in pilot plant TATB production.” Org. Process Res. Dev., 16(12), 2036–2042.
Nandi, A. K., Sutar, V. B., and Bhattacharyya, S. C. (2004). “Thermal hazards evaluation for sym-TCB nitration reaction using thermal screening unit (TSU).” J. Therm. Anal. Cal., 76(3), 895–901.
Narasimhan, V. L., Bhattacharyya, S. C., Mandal, A. K., and Nandi, A. K. (2006). “Scaling up the process for preparing 1,3,5-triamino-2,4,6-trinitrobenzene(TATB).” Final Technical Rep. 6/2006, HEMRL Sutarwadi, Pune, India.
O’Keefe, D. M. (1978). “Synthesis of sym-trichlorotrinitrobenzene, Part-2- Nitration with nitric acid, synthesis of by-products.”, Sandia Laboratory, Albuquerque, NM.
Ott, D. G., and Benziger, T. M. (1987). “Preparation of 1,3,5-triamino-2,4,6-trinitrobenzene from 3,5-dichloroanisole.” J. Energy Mater., 5(3–4), 343–354.
Quinlin, W. T., and Evans, W. H. (1976). “Pilot scale synthesis of TATB.”, Mason and Hanger Silas Mason, (MHSMP), Pantex Plant, Amarillo, TX.
Reavill, M. J. (1954). “Effect of certain chloronitrobenzenes on germination, growth and sporulation of some fungi.” Ann. Appl. Bio., 41(3), 448–460.
Surve, R. N., Mehilal, Prasad, U. S., and Agrawal, J. P. (1996). “The preparation of 1,3,5-triamino-2,4,6-trinitrobenzene (TATB) from 1,3,5-trichlorobenzene (100g batch size).”, High Energy Materials Research Laboratory (HEMRL), Sutarwadi, Pune, India.
Yasuda, S. K. (1973). “Simultaneous determination of 1,3-dinitro-2,4,6-trichlorobenzene and 1,3-dinitro-2,4,5,6-tetraclorobenzene in 1,3,5-trichloro-2,4,6-trinitro-benzene.” J. Chrom., 76(2), 331–335.
Information & Authors
Information
Published In
Copyright
© 2014 American Society of Civil Engineers.
History
Received: Dec 27, 2012
Accepted: Jun 12, 2013
Published online: Jun 15, 2013
Published in print: Jul 1, 2014
Discussion open until: Jul 14, 2014
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.