Two-Phase Modeling of Leachate Recirculation Using Vertical Wells in Bioreactor Landfills
Publication: Journal of Hazardous, Toxic, and Radioactive Waste
Volume 17, Issue 4
Abstract
Leachate recirculation or liquid injection is an established practice for operating landfills as bioreactors to enhance the biodegradation of municipal solid waste (MSW). Among other subsurface liquid injection methods, vertical wells (VWs) represent one of the most common methods used for active or closed landfills. The current design and operation of VW systems does not consider the effect of additional liquid injection on the increase in gas pressures. In this study, a two-phase model that assumes landfill leachate and gas as immiscible phases was used to predict the moisture distribution and pore water and pore-gas pressures in a typical bioreactor landfill that uses VWs as its leachate injection or recirculation system. The unsaturated liquid and gas properties of MSW were simulated based on the van Genuchten model. The study evaluates the effect of the unsaturated hydraulic conductivity of MSW, the heterogeneous and anisotropic nature of the MSW, and the geometric configuration of VWs on moisture distribution and pore water and gas pressures. The unsaturated hydraulic properties of MSW significantly influence the wetted area and pore-water pressures during the initial stages of leachate injection and during the gravity drainage that follows. The numerical modeling results show that the gas pressures in the landfill will be of the order of 60 to 150 kPa, which are far above the liquid pressures for most typical liquid injection rates when no gas accumulation in the landfill is assumed due to an active gas extraction system. Hence, the slope stability of bioreactor landfills needs to be assessed by using the effects of gas and liquid pressures, especially when the gas extraction system is operating at below optimum efficiency.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
This project is funded by the U.S. National Science Foundation (CMMI #0600441) and it is gratefully acknowledged.
References
Benson, C. H., and Wang, X. (1998). “Soil water characteristic curves for solid waste.”, Dept. of Civil and Environmental Engineering, Univ. of Wisconsin-Madison, Madison, WI, 1–6.
Breitmeyer, R. J., and Benson, C. H. (2011). “Measurement of unsaturated hydraulic properties of municipal solid waste.” Proc., Geofrontiers 2011, ASCE Geotechnical Special Publication 211, ASCE, Reston, VA.
Itasca Consulting Group Inc. (IGCI) (2011). Fast lagrangian analysis of continue (FLAC) version 7.0: Fluid mechanical interaction, user’s manual, 4th Ed., Itasca Consulting Group, Minneapolis, MN.
Haydar, M., and Khire, M. (2004). “Numerical evaluation of heterogeneity and anisotropy of waste properties on leachate recirculation in bioreactor landfills.” J. Solid Waste Manage. Technol., 30(4), 233–242.
Haydar, M. M., and Khire, M. V. (2005). “Leachate recirculation using horizontal trenches in bioreactor landfills.” J. Geotech. Geoenviron. Eng., 131(7), 837–847.
Haydar, M. M., and Khire, M. V. (2007). “Leachate recirculation using permeable blankets in engineered landfills.” J. Geotech. Geoenviron. Eng., 133(4), 360–371.
Interstate Technology, and Regulatory Council Alternative Landfill Technologies Team (ITRC). (2006). Characterization, design, construction and monitoring of bioreactor landfills, ITRC Alternative Landfill Technologies Team, Washington, DC.
Jain, P., Townsend, T. G., and Tolaymat, T. H. (2010). “Steady state design of vertical wells for liquids addition at bioreactor landfills.” Waste Manage., 30(11), 2022–2029.
Kazimoglu, Y. K., McDougall, J. R., and Pyrah, I. C. (2006). “Unsaturated hydraulic conductivity of landfilled waste.” Proc., 4th Int. Conf. on Unsaturated Soils, Geotechnical Special Publication (GSP) 147, ASCE, Reston, VA, 1525–1534.
Khire, M., and Haydar, M. (2007). “Leachate recirculation in engineered landfills using geocomposite drainage material.” J. Geotech. Geoenviron. Eng., 133(2), 166–174.
Khire, M. V., and Mukherjee, M. (2007). “Leachate injection using vertical wells in bioreactor landfills.” Waste Manage., 27(9), 1233–1247.
Kulkarni, H. S. (2012). “Optimization of leachate recirculation systems in bioreactor landfill.” Ph.D. thesis, Dept. of Civil and Materials Engineering, Univ. of Illinois, Chicago, IL.
Lu, N., and Likos, W. J. (2004). Unsaturated soil mechanics, Wiley, Hoboken, NJ.
McCreanor, P. T. (1998). “Landfill leachate recirculation systems: Mathematical modeling and validation.” Ph.D. thesis, Dept. of Civil and Environmental Engineering, Univ. of Central Florida, Orlando, FL.
Mualem, Y. (1976). “A new model for predicting the hydraulic conductivity of unsaturated porous media.” Water Resour. Res., 12(3), 513–522.
Mukherjee, M., and Khire, M. (2012). “Instrumented large-scale subsurface liquid injection model for bioreactor landfills.” Geotech. Test. J., 34(12), 1–10.
Peaceman, D. W. (1977). Fundamentals of numerical reservoir simulation, Elsevier, New York.
Reddy, K. R. (2006). “Geotechnical aspects of bioreactor landfills.” Proc., Indian Geotechnical Conf. 2006—Geotechnical Engineering—Indian Experience, Indian Institute of Technology, India, 79–94.
Reddy, K. R., Hettiarachchi, H., Parakalla, N., Gangathulasi, J., Bogner, J., and Lagier, T. (2009). “Hydraulic conductivity of MSW in landfills.” J. Environ. Eng., 135(8), 1–7.
Reinhart, D. R., McCreanor, P. T., and Townsend, T. (2002). “The bioreactor landfill: Its status and future.” Waste Manage. Res., 20(2), 172–186.
Reinhart, D. R., and Townsend, T. G. (1997). Landfill bioreactor design and operation, Lewis Publishers, Washington, DC.
Sharma, H. D., and Reddy, K. R. (2004). Geoenvironmental engineering: Site remediation, waste containment, and emerging waste management technologies, Wiley, Hoboken, NJ.
Simunek, J., Sejna, M., and van Genuchten, M. Th. (1999). “The Hydrus-2D software package for simulating two-dimensional movement of water, heat, and multiple solutes in variably saturated media. Version 2.0.”, International Ground Water Modeling Center, Colorado School of Mines, Golden, CO.
Stoltz, G., Tinet, A. J., Staub, M. J., Oxarango, L., and Gourc, J. P. (2012). “Moisture retention properties of municipal solid waste in relation to compression.” J. Geotech. Geoenviron. Eng., 138(4), 535–543.
van Genuchten, M. Th. (1980). “A closed-form equation for predicting the hydraulic conductivity of unsaturated soils.” Soil Sci. Soc. Am. J., 44(5), 892–898.
Information & Authors
Information
Published In
Copyright
© 2013 American Society of Civil Engineers.
History
Received: Mar 30, 2012
Accepted: Dec 26, 2012
Published online: Dec 29, 2012
Discussion open until: May 29, 2013
Published in print: Oct 1, 2013
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.