Residual Capacity of Mainshock-Damaged Precast-Bonded Prestressed Segmental Bridge Deck under Vertical Earthquake Ground Motions
Publication: Journal of Bridge Engineering
Volume 23, Issue 5
Abstract
Although the use of segmental bridge decks has increased around the world, their use in seismic regions under vertical earthquake motions is yet to be fully understood. The asymmetric behavior of segment joints under vertical motions as well as the low strain ductility of cables passing through the joints raise questions on postearthquake performance of decks following a disastrous earthquake and during aftershocks. Because strong aftershocks can expedite the collapse of structures damaged in the mainshock, assessing the residual capacity of mainshock-damaged bridges becomes important with regard to postearthquake performance. In the current research, two medium- and long-span case study bridges were investigated to study the residual capacity of bridges of such type. To this end, a two-dimensional model for segment joints was developed and verified via experimental results. The results related to nonlinear time-history analysis under the design earthquakes showed that midspan segment joints were bound to suffer spalling concretes at the bottom and yielding tendons at the top. The findings revealed that the residual capacity of the mainshock-damaged bridges decreases with the increase in the damage level caused by mainshock, yet not more than 50% in comparison to the intact bridge, even at the worst damage level.
Get full access to this article
View all available purchase options and get full access to this article.
References
AASHTO. (1999). Guide specifications for design and construction of segmental concrete bridges, 2nd Ed., Washington, DC.
AASHTO. (2007). Proposed AASHTO guide specifications for LRFD seismic bridge design, Subcommittee for Seismic Effects on Bridges, Washington, DC.
American Segmental Bridge Institute Grouting Committee. (2000). “Interim statement on grouting practices.” Phoenix.
Anagnostopoulou, M., Filiatrault, A., and Aref, A. (2012). “Vertical seismic response of a precast segmental bridge superstructure.” Proc., 15th World Conf. on Earthquake Engineering, Lisboa, Portugal, Paper No. 3321.
Burnell, K. P., Megally, S. H., Restrepo, J. I., and Seible, F. (2005). “Seismic testing of precast segmental systems bridges: Phase III, bridge systems test.” Structural Systems Research Project SSRP 2005/01, Univ. of California at San Diego, La Jolla, CA.
Caltrans. (2006). Seismic design criteria, Version 1.4, Sacramento, CA.
Campbell, K. W., and Bozorgnia, Y. (2003). “Updated near-source ground-motion (attenuation) relations for the horizontal and vertical components of peak ground acceleration and acceleration response spectra.” Bull. Seismol. Soc. Am., 93(3), 1413.
Kang, D., Maeda, M., and Waon, H. Y. (2004). “Post-earthquake capacity evaluation of reinforced concrete buildings based on seismic response analysis.” Proc., 13th World Conf. on Earthquake Engineering, Vancouver, Canada, Paper No. 1633.
Li, Y., Song, R., and Van De Lindt, J. V. (2014). “Collapse fragility of steel structures subjected to earthquake mainshock-aftershock sequences.” J. Struct. Eng., 04014095.
Luco, N., Bazzurro, P., and Cornell, C. A. (2004). “Dynamic versus static computation of the residual capacity of a mainshock-damaged building to withstand an aftershock.” Proc., 13th World Conf. on Earthquake Engineering, Vancouver, Canada, Paper No. 2405.
Megally, S. H., Seible, F., and Dowell, R. K. (2003a). “Seismic performance of precast segmental bridges: Segment-to-segment joints subjected to high flexural moments and low shears.” PCI J., 48(2), 80–96.
Megally, S. H., Seible, F., and Dowell, R. K. (2003b). “Seismic performance of precast segmental bridges: Segment-to-segment joints subjected to high flexural moments and high shears.” PCI J., 48(3), 72–90.
OpenSees [Computer software]. University of California, Berkeley, CA.
PEER (Pacific Earthquake Engineering Research Center). (2011). “Pacific earthquake engineering research center PEER strong motion database.” 〈https://ngawest2.berkeley.edu/spectras/81339/searches〉 (Sep. 21, 2016).
Poelse, M., Ludovico, M. D., Prota, A., and Manfredi, G. (2012). “Residual capacity of earthquake damaged buildings.” Proc., 15th World Conf. on Earthquake Engineering, Lisboa, Portugal, Paper No. 1005.
Ribeiro, F. L. A., Barbosa, A. R., and Neves, L. C. (2014). “Application of reliability-based robustness assessment of steel moment resisting frame structures under post-mainshock cascading events.” J. Struct. Eng., A4014008.
Ryu, H., Luco, N., Uma, S. R., and Liel, A. (2011). “Developing fragilities for mainshock-damaged structures through incremental dynamic analysis.” Proc., 9th Pacific Conf. on Earthquake Engineering, Auckland, New Zealand, Paper No. 225.
Tang, B. (2006). “Framework for prefabricated bridge elements and systems (PBES) decision-making.” Proc., Second U.S.-Taiwan Bridge Engineering Workshop, No. FHWA-IF-06-30.
USGS. (2011). “Magnitude 9—Near the east coast of Honshu, Japan.” 〈http://earthquake.usgs.gov/earthequakes/eqinthenews/2011/usc0001xgp#summary〉 (Jun. 8, 2015).
USGS. (2012). “Magnitude 8.6—Off the west coast of Northern Sumatra.” 〈http://earthquake.usgs.gov/earthquakes/recenteqsww/Quakes/usc000905e.php#summary〉 (Jun. 8, 2015).
Vamvatsikos, D., and Cornell, C. A. (2002). “Incremental dynamic analysis.” Earthquake Eng. Struct. Dyn., 31(3), 491–514.
Veletzos, M. J., and Restrepo, J. I. (2009). “Influence of vertical earthquake motion and pre-earthquake stress on joint response of precast concrete segmental bridges.” PCI J., 54(3), 99–128.
Veletzos, M. J., and Restrepo, J. I. (2011). “Modeling of jointed connections in segmental bridges.” J. Bridge Eng., 139–147.
Veletzos, M. J., and Restrepo, J. I. (2014). “Equivalent unbonded length for modeling of multistrand tendons in precast segmental construction.” J. Bridge Eng., 101–109.
Yeo, G. L., and Cornell, C. A. (2005). “Stochastic characterization and decision bases under time-dependent aftershock risk in performance based earthquake engineering.” Rep. No. TB149, John A. Blume Earthquake Engineering Center, Stanford Univ., Stanford, CA.
Information & Authors
Information
Published In
Copyright
© 2018 American Society of Civil Engineers.
History
Received: May 2, 2017
Accepted: Oct 17, 2017
Published online: Feb 16, 2018
Published in print: May 1, 2018
Discussion open until: Jul 16, 2018
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.