Mixing in Inclined Dense Jets
This article has a reply.
VIEW THE REPLYPublication: Journal of Hydraulic Engineering
Volume 123, Issue 8
Abstract
Experiments were performed using laser-induced fluorescence (LIF) and a microconductivity probe on turbulent dense jets inclined upwards at an angle of 60° into stationary environments. Such jets are frequently used to discharge industrial wastewaters. Time-averaged LIF images show concentration profiles that vary smoothly in space but instantaneous images show considerable patchiness. Dilution at the jet impact point was found to be higher than previously reported. Downstream from the impact point, the flow becomes predominantly horizontal with a complex additional mixing process that results in ultimate dilutions considerably higher than the impact dilution. The flow is highly turbulent in the vicinity of the falling jet with large concentration fluctuations. These fluctuations decay with distance due to turbulence collapse under the influence of density stratification. The end of the mixing zone is defined as the location where the intensity of the concentration fluctuations falls to 0.05 (i.e. 5%) of their mean value. Normalized expressions for dilution, rise height, and other properties were derived and experimental coefficients are presented from which these gross flow properties could be predicted.
Get full access to this article
View all available purchase options and get full access to this article.
References
1.
Britter, R. E. (1988). “A review of some mixing experiments relevant to dense gas dispersion.”Stably stratified flow and dense gas dispersion, J. S. Puttock, ed., Clarendon Press, Oxford, U.K., 1–38.
2.
Britter, R. E.(1989). “Atmospheric dispersion of dense gases.”Annu. Rev. of Fluid Mech., 21, 317–344.
3.
Ferrier, A., Funk, D., and Roberts, P. J. W.(1993). “Application of optical techniques to the study of plumes in stratified fluids.”Dyn. of Atmospheres and Oc., 20, 155–183.
4.
Head, M. J. (1983). “The use of miniature four-electrode conductivity probes for high resolution measurement of turbulent density or temperature variations in salt-stratified water flows,” PhD thesis, Univ. of Calif., San Diego.
5.
List, E. J. (1993). “Transition from jet plume dilution to ambient turbulent mixing.”Recent research advances in the fluid mechanics of turbulent jets and plumes, NATO Advanced Sci. Inst. Ser. E: Appl. Sci., Vol. 255, 1–11.
6.
McLennan, T. N., and Randall, R. E.(1986). “Measurement of brine jet height and dilution.”J. Wtrwy., Port, Coast. and Oc. Engrg., ASCE, 112(2), 200–216.
7.
Pincince, A. B., and List, E. J.(1973). “Disposal of brine into an estuary.”J. Water Pollution Control Fedn., 45(11), 2335–2344.
8.
Roberts, P. J. W.(1979). “Line plume and ocean outfall dispersion.”J. Hydr. Div., ASCE, 105(4), 313–330.
9.
Roberts, P. J. W. (1994a). “Jets and plumes and ocean outfall design.”Recent research advances in the fluid mechanics of turbulent jets and plumes, NATO Advanced Sci. Inst. Ser. E: Appl. Sci., Vol. 255, 441–464.
10.
Roberts, P. J. W. (1994b). “Design report for the sea outfall and diffuser for discharge of Haifa Chemical's waste into the sea.”Prepared for Tahal Consulting Engineers, Tel Aviv, Israel.
11.
Roberts, P. J. W., and Toms, G.(1987). “Inclined dense jets in a flowing current.”J. Hydr. Engrg., ASCE, 113(3), 323–341.
12.
Roberts, P. J. W., and Toms, G.(1988). “Ocean outfall system for dense and buoyant effluents.”J. Envir. Engrg., ASCE, 114(5), 1175–1191.
13.
Roberts, P. J. W., Snyder, W. H., and Baumgartner, D. J.(1989). “Ocean outfalls.”J. Hydr. Engrg., ASCE, 115(1), 1–70.
14.
Rouse, H. (1947). “Gravitational diffusion from a boundary source in two-dimensional flow.”J. Appl. Mech., A, A225–A228.
15.
Wright, S. J.(1984). “Buoyant jets in density-stratified crossflow.”J. Hydr. Engrg., ASCE, 110(5), 643–656.
16.
Wright, S. J., Roberts, P. J. W., Zhongmin, Y., and Bradley, N. E.(1991). “Surface dilution of round submerged buoyant jets.”J. Hydr. Res., 29(1), 67–89.
17.
Zeitoun, M. A., Reid, R. O., McHilhenny, W. F., and Mitchell, T. M. (1972). “Model studies of outfall systems for desalination plants. Part III. Numerical simulations and design considerations.”Res. and Devel. Progress Rep. No. 804, Office of Saline Water, U.S. Dept. of Interior, Washington, D.C.
Information & Authors
Information
Published In
Copyright
Copyright © 1997 American Society of Civil Engineers.
History
Published online: Aug 1, 1997
Published in print: Aug 1997
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.